Given an open tank filled with oil that is discharging through a 35-meter long commercial annulus pipe as shown in figure below. Calculate the volume flowrate at point 2 when the oil surface is 5 meters from it. Neglect entrance effects take kinematic viscosity equal to 4 x10* m/s. (Ro and Ri are radaii). h= 5 m Ro = 5 cm Ri = 2 cm Q. V L= 35 m Oil (SG = 0.9)

Given an open tank filled with oil that is discharging through a 35-meter long commercial annulus pipe as shown in figure below. Calculate the volume flowrate at point 2 when the oil surface is 5 meters from it. Neglect entrance effects take kinematic viscosity equal to 4 x10* m/s. (Ro and Ri are radaii). h= 5 m Ro = 5 cm Ri = 2 cm Q. V L= 35 m Oil (SG = 0.9)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Simulation of laminar gas flow in the pipe with Ansys Fluent Task: 1. Calculate velocity distribution in y axis at inlet and outlet of the pipe. Submit it as a chart. 2. Calculate velocity distribution over the pipe length. Submit it as a chart. Figure. pipe geometry L, m = 16 R, m= 0.15 Inlet velocity, m/s= 0.08 Gas= Oxygen Need proper solution like pdf file, don't need steps by steps. If you can can do it through ansys fluent. Write proper solution on word file or pdf.
The picture below depicts a system for delivering chocolate ganache in liquid form. Thenozzle on the end of the hose requires 140 kPa of pressure to operate effectively. Thehose is smooth plastic with an ID of 25 mm. The chocolate has a specific gravity of 1.1and a dynamic viscosity of 2.0 X 10-3 Pa*s. If the length of the hose is 85 m and there is a change in height of 10 m, determine(a) the power delivered by the pump to the ganache and(b) the pressure at the outlet of the pump.Neglect the energy losses on the suction side of the pump. The flow rate is 85 L/min.
4. Water is flowing in a pipe with radius of 25.4 cm at velocity of 5 m/s. The viscosity of water is 1.131 Pa-s and its density is equal to 997.9 What is its Reynolds m³° number and type of fluid flow?
Q:- A solid circular cylinder of diameter 100 mm and length 200 mm slides inside a vertical smooth pipe that has inside diameter 100.5 mm. The small space between the cylinder and the pipe is lubricated with an oil film that has viscosity 3 N.s/m2.The cylinder weight 20 N and concentric with the pipe as it falls .Find the rate of the changer in velocity of the cylinder? Pbe Cylinder O Flm
In shut off valve experiment, the 3/ 6th of valve position, the discharge is found as of 6 lit/s for the 27mm diameter pipe. Find the velocity and Reynolds number of the flow. Take the viscosity of water as 1.14x10 Ns/m?. (Enter only the value in the box by considering the unit given in bracket. Do not write the unit in the boxes) Velocity of water (unit in mm/s) = Reynold's number
the mean velocity of 40 degrees C fluid having an SG of 1.32 in a 50mm(inside diameter) tube is 2.5m/s. the absolute viscosity is 7.58 x 10^-3 poiseuille. what is the reynolds number?
For a certain value opening in a shut off valve experiment(exercise 1), the water with a velocity of 0.65 m/s passes through a the pipe of diameter 24 mm. Viscosity of water is 1.14 x10-3Ns/m². Find Reynold's number for this valve opening=
A Pipe used to transport an oil of specific gravity of 0.90 & 0.03poise at a Velocity of 1.6977m/s with a flow rate of 3cubic meter per second. A Pipe was used to conduct a test using water at 20 degree celsius with a velocity of 5.0931m/s. Find the diameter of the prototype. Viscosity of water at 20 degree celsius is 0.01poise
2. Castor oil flows through a pipe that has a cross-section of an equilateral triangle with a side length of 10 cm. The volume flow rate of the oil was measured to be 1.2 liters/second. The absolute viscosity of castor oil is about 650 cP. Calculate the Reynolds number and identify the type of flow.
d. A pipe line, 300 mm in diameter and 3200 m long is used to pump up 50 kg per second of oil whose density is 950 kg/m3 and whose kinematic viscosity is 2.1 stokes. The center of the pipe line at the upper end is 40 m above than that at the lower end. The discharge at the upper end is atmospheric. Find the pressure at the lower end.
Water is flowing in a horizontal smooth plastic pipe with a velocity of 20mm/s. What is the pressure difference between the point of entry to the exit of the 1m length of plastic pipe with a diameter of .15m if the dynamic viscosity is .0010016 Ns/m² ? ( hint: apply Bernoulli's energy equation, combined with Darcy Weisback)
1) The velocity profile of a viscus fluid over a plate is parabolie with vertex 25 em from the plate ,where the velocity 125 cm/s. calculate the velocity gradient and shear stress at distance of (0, 5, 15 and 25 cm) from the plate given the viscosity of the fluid =7 poise ? Also draw the figure explain the relationship between the velocity gradient and shear stress. Take velocity profile for parabolic equation, (v = ay + by + c)