Gasoline samples containing pollutant S was analysed using GC-FID. The data of analysiswas shown in Table 2.Table 2Injectiontr (min)peak area21.1 ppm toluene(Internal standard)10.1136,242145,99733.4 ppm S14.8221.1 ppm toluene(Internal standard)X ppm S10.0538,774239,11514.77i) Calculate the amount of S presence in the sample by using y = mx + b equation.Assumes that the b value is 0.ii) TCD and FIID are considered universal GC detectors of GC analysis. Explain twoadvantages of FID detector compared to TCD detector.

The aim of this question is to explain the amount of S in the sample using the equation y=mx+b.the…

Gasoline samples containing pollutant S was analysed using GC-FID. The data of analysis was shown in Table 2. Injection 1 2 Table 2 21.1 ppm toluene (Internal standard) 33.4 ppm S 21.1 ppm toluene (Internal standard) X ppm S tr (min) 10.11 14.82 10.05 14.77 peak area 36,242 45,997 38,774 39,115 Calculate the amount of S presence in the sample by using y my th equation

Gasoline samples containing pollutant S was analysed using GC-FID. The data of analysis was shown in Table 2. Injection 1 2 Table 2 21.1 ppm toluene (Internal standard) 33.4 ppm S 21.1 ppm toluene (Internal standard) X ppm S tr (min) 10.11 14.82 10.05 14.77 peak area 36,242 45,997 38,774 39,115 Calculate the amount of S presence in the sample by using y my th equation

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter11: Atomic Mass Spectrometry

Section: Chapter Questions

Problem 11.10QAP

See similar textbooks

Similar questions

4. A new method for the determination of mercury in fish was tested against a N.I.S.T. standard to determine if there was any bias (determinate error) in the new technique. The N.I.S.T. standard fish sample was certified to contain 13.55 ppm Hg. The results of six analyses by the new method gave a mean value of 14.15 ppm and s.d. = 0.42 ppm. Does the new method give accurate results at the 95% confidence level?
Chemistry The levels of an organic pollutant (P) in the groundwater at the perimeter of a plant were a cause for concern. A 10 mL sample of the water was taken and the pollutant was extracted with 95% efficiency using 25 mL of diethyl ether. GC was used to analyse the concentration of P in diethyl ether. A calibration curve was plotted for a series of standards of P which yielded the following results: Peak Area Toluene Conc. (µg/ml) 12,000 2.6 23,700 5.0 35,500 7.7 46,800 9.9 31,250 Sample Determine the concentration of P in ppb in the initial groundwater sample.
The researcher extracts a sample of well water and prepares it for TXRF analysis with a 10.00 mg/L V internal standard, like the calibration standards. The result produces SCa = 69297.81 and SV = 13481.2.Determine the concentration of Ca.
1) 1500 kg mixture contains 15% acetone, 75% water and 10% Acetic acid by weight. a) Calculate the total mole of mixture and molar fractions of each compound. b) Calculate Average Molecular Weight of mixture. c) 2 kmol more Acetic acid is added to the mixture. What would be the mass fractions of this new mixture? (MW: Acetone= 58 g/mol Water= 18 g/mol Acetic acid= 60 g/mol)
S & Post-Ax d Al2_Sin x > School x 8 Post-A: x ☐ bcps.schoology.com/common-assessment-delivery/start/6425623769?action=onresume&submissionid=969196920 NGLSync Portal Ho..... S week of 12/20 Post-Assessment Unit 1 LC2 S Grades X 6 School X S Pre-As X Identify the type of the reaction for each chemical equation. a. 2 Ag₂O → 4 Ag + O₂ b. CaO + H₂O → Ca(OH)₂ c. Pb(NO3)2 +KI → Pbl2 + 2 KNO31 Meet - nfw-jxsi-wtd 1 # Synthesis (A + B Ⓡ AB) d Al2_Sin x G The foll x G rocket x P Quizizz CPM CPM eBooks Index... Mycoplasma pneu... a Quizizz СРМ :: Single Replacement (AB+C ⓇAC + B) S Double Replacement (AB + CD ⓇAD + CB) :: Decomposition (ABⓇA + B) P 1 2
Chemistry The amount of V was found to be 0.19% (+/-) 0.02% V (N=6). Calculate t-calc, assuming 95% confidence level.
O 15 Ppm 2. In a certain polluted area, the partial pressure of NO gas was 8 pascal. The mixing ratio of NO is . ppmv (assume normal conditions) 3. A 500 kg sample of a fertilizer containing 115 ppms Cu was mixed with 15,000 kg soil which also contains 2.0 ppms Cu. The final level of Cu is ........ pPpms 4. The mixing ratio of H,S gas is 0.2 ppmv and the total flux into atmosphere is 2.5x10" kg Estimate r for H;S. ....kg (assume normal conditions and volume of atmosphere 4.0x10" m)
Study the tabulated data during an gravimetric analysis of BaSO4 experiment Trial T1 T2 T3 Mass of sample (g) 1.0040 1.0100 1.0050 Constant weight of empty crucible (g) 10.2453 10.2454 10.2454 Constant weight after ignition (g) 10.3253 10.3252 10.3253 1. Calculate the mean mass of precipitate as BaSO4 a. 0.0799 g b. 0.0800 c. 0.08 g 2. Calculate the mean weight of sulphate (MM BaSO4 = 233.39 g/mol, So42- = 176 g/mol)? a. 0.0603 g b. 0.06 g c. 0.06025 g 3. Calculate the mean % SO42- in the sample a. 6.00% b. 5.991% c. 5.9908%
(a) (i) Ksp value of Cul is 5.0 x10-12 mol2dm at 25 °C. Calculate the maximum number of moles of Cul that can be dissolved in 1 dm³ of water at 25 °C. (ii) Calculate the maximum number of moles of Cul that can be dissolved in 1 dm³ of 0.1 moldm³ of Nal solution at 25 °C.
An analysis of city drinking water for total hardness was done by two students in the laboratory and produced the following results (in ppm CaCO3): Student A: 228.3, 226.4, 226.9, 227.1, and 228.6. Student B: 229.5, 226.1, 230.7, 223.8, and 227.5What is the 95% confidence interval for the mean?
The contents of similar containers of sulfuric acid are 9.8, 10.2, 10.4, 9.8, 10.0, 10.2, and 9.6 liters. Find a 95% confidence interval for the mean of all such containers, assuming an approximate normal distribution. Use t = 2.447 9.74 10.26 9.74> μ μ> 10.26 O wwxx O xwww 9.74 <μ <-10.26
Leaching of Oil from Soybeans in a Single Stage. Repeat Example 12.9-1 for single-stage leaching of oil from soybeans. The 100 kg of soybeans contains 22 wt % oil and the solvent feed is 80 kg of solvent containing 3 wt % soybean oi!. = 0.239, V, = 50.0 kg, x41 = 0.239, N, = 1.5 Ans. L, = 52.0 kg, ya1 wwwww