For the reaction below which of the following conditions would you use? Explain.   C2H6 (g)   ↔  C2H4 (g)  + H2 (g)   600 ºC and 1 1500º C and 1 1500 ºC and 75 Don't need to make calculations, using the governing equations and Le Chatelier’s principle, explain clearly and briefly BOOK: Introduction to Chemical Engineering Thermodynamics (8th Edition)

Q: A process is being developed to produce carbonated beverages. As part of this process, a wetted-wall...

A: (a) The maximum possible concentration of dissolved CO2 in water at 2.54 atm CO2 partial pressure is...

Q: Which of the following statements concerning corrosion is(are) true? For the false statements, corre...

A: a) Since corrosion is a process in which the metal converts into oxides by reacting with the oxygen ...

Q: Would it be expected that for a given problem, the NR and inside-out methods converge to the same re...

A: In the Newton Raphson (NR) method, temperature and flow rates of the stage are calculated together a...

Q: A number of polymers, including polyvinylchloride, polystyrene, and polymethylmethacrylate, are made...

A: The reason for rotary dryers, fluidized-bed dryers and sprouted dryers are good choices for polymer ...

Q: Use the acidity model  pH = −log[H+],  where acidity (pH) is a measure of the hydrogen ion concentra...

A: Since pH is given by  pH = −log[H+]   [H+] = concentration of H+ ions 

Q: How do the NR methods differ from the BP and SR methods?

A: The difference between the NR method and BP and SR methods is to be mentioned.

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior of coconut milk contai...

A: The given fluid is coconut milk which is a non-Newtonian fluid. It follows the power-law according t...

Q: 1. a. Explain the terms (i) steam economy (ii) vapour recompression. b. A single-effect evaporator i...

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new ques...

Q: Ammonia, NH3, in air is being absorbed into water within the enclosed tank shown in the figure below...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: All forces result from direct contact. a. True   b. False

A: The correct option for the given statement is to be chosen.

Q: Argon gas in an insulated plasma deposition chamber with a volume of 2 L is to be heated by an elect...

A: For Argon gas:   Initial temperature, T1 = 300 K Initial pressure, P1 = 1.5 Pa The volume of the rea...

Q: What is meant by a group method?

A: The definition of the group method is to be mentioned.

Q: 30.10 Silicon tetrachloride, SiCl4, is an important chemical used in the manufacture of microelectro...

A: Given data: Temperature = 298 K Pressure = 1 atm Diameter of Cl2 gas bubble = 2 mm or 0.002 m Densit...

Q: The availability of forestry and agriculture wastes and residues is mainly determined by future deve...

A: Biomass is one of the potential renewable energy sources that can help us in bridging the gap betwee...

Q: A meat processing factory’s raw effluent has a five day BOD at 20oC of 1760 mg/l. If the k value is ...

A:

Q: It takes 15 kWh (kilowatt-hours) of electrical energy to produce 1.0 kg aluminum metal from aluminum...

A: NOTE : 1 Watt = 1 J/s and not 51 J/s  And 1 KWh = 3600 KJ  

Q: 1. Consider a case in which you have a material that support a certain stress at 75°C and you have s...

A: Differential Scanning Calorimetry or DSC is a traditionally common method used to estimate Transitio...

Q: a) If the expansion is carried out isothermally and reversibly, calculate Q. W, AH and AU. Draw the ...

A:

Q: A quiescent body of water has a depth of 600 mm. The DO level at the bottom after 16 days is 3.5 mg/...

A: Let, dissolved oxygen (DO) be represented by ‘A’.   Since the surface of the water body is exposed t...

Q: Twenty five liters of hydrogen is produced at a total pressure of 1 atm by the action of acid on met...

A: Initially there is no hydrogen and at the end 25 litres of hydrogen are produced. Therefore:

Q: Calculate (i) the equilibrium conversion and (ii) concentrations (ie. CA, Cg and Cc ) for the follow...

A: Given the liquid phase reaction is:   The initial concentration of the species is given as: The va...

Q: Calculate (i) the equilibrium conversion and (ii) concentrations (ie. CA, CB and Cc ) for the follow...

A: (i) The equilibrium conversion for the given liquid phase reaction is to be calculated.   The equili...

Q: Solve a,b,c and d please

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Determine how many grams of each of the following solutes would be needed to make 3.60×102 mL of a 0...

A: Moles of any substance is given by  Moles = Concentration X volume of solution in L Since the concen...

Q: A tow truck exerts a force of 4301b on a car, causing it to accelerate at 10/s. What is the mass of ...

A: The mass of the car is to be determined.

Q: Drying is widely used to remove solvents from coated webs, which include coated paper and cardboard,...

A: The types of dryers that can be used with coated webs are: Roll support dryers Floatation dryers

Q: h. kihat is the approximation Of fick's equation CHint: the first three terms)! b. A Of wates has a ...

A: (a)   The first law of Fick’s gives the relationship between the diffusive flux and the concentratio...

Q: two plates which are aligned parallel above eachother.The top plate is moving horizontally with a co...

A: A Newtonian fluid is flowing between two parallel plates where top plate is moving with a constant v...

Q: A reactive chemical disposed of by dilution in a river dissipates at a uniform rate of 0.15 mg/l per...

A: The distance downstream that the chemical residual persist is to be determined.

Q: A batch dryer is to be selected to dry 100 kg/h of a toxic, temperature-sensitive material (maximum ...

A: The type of dryer suitable for the given toxic, temperature-sensitive material is to be mentioned.

Q: The concentration, C, of a drug in the blood as a function of the time, t, in hourssince the drug wa...

A: Since the are under the concentration curve is bioavailability. And are under any curve is given by ...

Q: Give three (3) environments that will cause rapid corrosion of 304 stainless steel

A: Three environments that will cause rapid corrosion of 304 stainless steel are to be mentioned.

Q: Sucrose in ground coffee particles of an average diameter of 2 mm is to be extracted with water in a...

A: The time in minutes required to leach 95% of the sucrose is to be calculated.

Q: A very thin polymeric coating of thickness 0.1mm uniformly coats a rectangular surface. The rectangu...

A:

Q: It takes 20 seconds to fill a two-liter bottle with water from your kitchen faucet. What is the mass...

A: Given : The volume of the water bottle is 2 L  And the time required to fill the water is 20 s  

Q: 6

A: There are two methods that can be used in reducing the toxic gas release from a wastewater treatment...

Q: Under what conditions does precipitation occur?

A: The conditions at which precipitation occurs are to be mentioned.

Q: Estimate the theoretical production of landfill gases (CH4,  NH3 and CO2) from the degradation of 80...

A:

Q: Calculate the heat change associated with cooling a 350.0 g aluminum bar from 70.0°Č to 25.0°Č. Is t...

A: The heat change associated with the of cooling of an aluminium bar is to be calculated along with th...

Q: 10 kg of C7H16 is burned with 6.8027k-mol of air. To produce 14.4 kg of CO2 along with other combust...

A: (a)   ‘i’ represents initial mass and moles, ‘f’’ represents final mass and moles, ‘m’ represents th...

Q: 3. Write your understanding about the Solar flat plate collectors and Solar evacuated tubes. Clearly...

A: A solar flat-plate collector is a box made of metal in which there is a cover of plastic or glass on...

Q: Use material balance based on species method to calculate the products from reactor, where the two f...

A:

Q: A reactive chemical disposed of by dilution in a river dissipates at a uniform rate of 0.15 mg/l per...

A: The distance downstream that the chemical residual persists is to be determined.

Q: In figure below compute the net force exerted on the hemispherical shape located at the bottom of th...

A:

Q: The air freshener shown in the figure below is used to deliver a pleasant vanilla fragrance in a roo...

A:

Q: Why is the following situation impossible? An apparatus is designed so that steam initially at T =  ...

A:

Q: Nitrogen is removed from a gas mixture with methane by gas permeation  using a glassy polymer membra...

A: The gas mixture of nitrogen and methane is to be separated by gas permeation having a glassy polymer...

Q: Book: Introduction to Chemical engineering Thermodynamics 8th edition, McGraw Hill, 2018

A: (a) The value of Margules parameter A is to be determined.   The modified Raoult's law is given as, ...

Q: The formation of nitroanaline(an important intermediate in dyes) is formed from the reaction of orth...

A: