For the following voltage and current phasors, calculate the reactive power in VAR 200 Vrms V = 140 I = 15 2 2 59⁰ Arms

Q: 1(a) Draw circuits to calculate Rth and Vth at terminals a-b. 24 V + 4A 1 5Ω 3Ω www 4Α 3 Ω 2 Ω 2 i…

A: Given the circuit, (a) (b)

Q: 1 ΚΩ (+1) ¹a 20 ΚΩ +

A: This question is based on the voltage gain of a non-inverting op-amp based amplifier.

Q: Course Objective 2: Perform analysis of circuits containing diodes, including voltage reference…

A:

Q: Consider the following circuit with R 500 2, Xc= 300 2. The supply voltage is SV. 150 Ω, Χ, Find the…

A: The RLC circuit diagram is shown below, Where,R=150 Ω.XL=500 Ω.XC=300 Ω.V=5 V.

Q: Given points P(3, -23, 46) and Q(31, 40, -49),  what is the distance between P and Q? (Use 4 decimal…

A: Here we have calculated distance between P and Q

Q: Consider the circuit shown in (Eigure 1). Suppose that is = 54 A Figure (x) <60 202 + Vo 21x 1 of 1…

A: In the Given circuit, is = 54 Amp    To find the voltage Vo  And total power supplied in the circuit…

Q: 6. The effect of adding the poles not at the origin, might have the slope of A. -20dB/dec B.…

A: In these questions,  We need to choose the correct options.  All questions are releted to control…

Q: Find U. (t)

A:

Q: Example 4. For the series diode configuration of Figure 7, determine VD, VR, and ID. 41₁ ID + VD-…

A:

Q: 3. Determine V₁ and V₂. 1 lov 452 + Vi - + V₂. W 202 8v

A: In this question we need to find the voltage V1 and V2 show in the given circuit.

Q: 2. Use Lenzs law to determine the direction of induced current in each case. Please note that the…

A: Dear student, Answer to parts d,e &amp; f are given below

Q: Design your own oscillator based on the Wein-bridge configuration. (See Alexander section 10.9.2.)…

A: Since the user has asked about the solution of question (1). Hence, we will provide the solution of…

Q: Example 14. Determine Vo for the network of Figure 16. (1) E= 10 Vo 1 (0) 0 Vo 2 Si ➜ D₁ Si ➜ D₂…

A: The given problem is from analysis of diode.  The detailed solution is given in the next step

Q: 17. Calcular el valor de i en cada circuito de la figura 3.53. 2V 5 V 7V D + (a) ΤΩ 9V 4 Ω www (b) -…

A: It is solved by assuming the required value to be found is i. 17. Given Data: a. A closed DC circuit…

Q: 19. Determine the output waveform in Figure 3–85.?        1.Repeat Problem 19 for a 4-input NOR…

A:

Q: 6. A coil draws 1875 watts when connected to a 150 V DC source. It consumes 3072 watts when used on…

A:

Q: For the following circuit: 1. find the transfer function H(jw) = V(jw)/Ê(jw) in symbolic form; 2.…

A: Given data R=13 Ω L=12 H et=1+cos2t V   To find out 1. Transfer function in frequency domain,…

Q: Convert the following decimal integers to 12-bit two's complement form. Show your work as most…

A: Given the following decimal integer 1023 -1984    To convert into 12 bit 2's complement form

Q: You need a capacitance of 4.5 uF but you only have a large number of 1 µF capacitors available. Draw…

A: In this question we need to connect a number of 1microfarad capacitor so that we get a equivalent…

Q: 5. u and us input waveforms are shown in Figure, V-0.7v. Sketch the waveform resulting at vo and…

A: Given: A diode network, with VD=0.7 V and input wave forms as,  To find: Voltage V0.

Q: VL (S) Problem 2. Find the transfer function, G(s) = for each network shown below. Solve the V(s)'…

A:

Q: What are the advantages of using Digital Signal Processing in audio systems?

A: In this question we discuss about the advantages of using Digital Signal Processing in audio…

Q: Design a series RLC bandpass filter (see (Figure 1)) with a quality of 6 and a center frequency of 7…

A:

Q: Find the currents (in A) flowing in the circuit in the figure. (Indicate the direction with the sign…

A:

Q: For the circuit shown find: i) The Voltage across the capacitance, with the polarity as shown, at…

A: Given Data: An RC transient circuit with DC sources To Find: i) The Voltage across the capacitor Vct…

Q: Question #2: Answer the following questions. Use DTFT tables. (a) Compute the DTFT of (b) Compute…

A: Note: Since you have posted multiple question we will provide solution to the first question as per…

Q: F(s) = (s+2)/[(s+2)2 + 102] use the final value theorem to find f(0). A) f(0) = 1 B) f(0) = ∞ C)…

A: We need to find out the f(0) , for given F(s) .

Q: a transformer, two coils of vire are wound around a toroidal iron core. swer true or false. If the…

A:

Q: Use the Newton-Raphson power flow to calculate the voltage magnitude and angle at bus two (Perform 3…

A: Given a single line diagram of a power system. To calculate the voltage magnitude and angle at bus 2…

Q: Consider the system H which is described by t-3 H : x(t) → y(t) = √ x(27 + 1)dr − 1. - 88 Find and…

A: Given: yt=∫-∞t-3x2τ+1dτ-1

Q: 9.28 (Properties) Let x(t) = 4 sinc(4t). Find its Fourier transform X(f) and use the result to find…

A:

Q: What is the equivalent capacitance of five 10 microFarad capacitors in parallel?

A: Given data, Capacitance is given C=10 μF. Number of capacitors n = 5.

Q: A9 Volt Battery has an energy rating of 500 mAH. A 1.5 Volt AA Battery has an enegy rating of 2500…

A: Given data: A 9 Volt Battery has an energy rating of 500 mAH. A 1.5 Volt AA Battery has an energy…

Q: find the natural frequencies lambda 1 and lambda 2 (ie the zeros of the characteristic polynomial )…

A: The given question requires finding the natural frequencies lambda1 and lambda2 which are zeros of…

Q: The internal resistance of an ammeter (0 - 10 mA) is 100. If the range is to be extended to 150A,…

A: Given: Internal resistance of ammeter, Rm=10 Ω. Meter current, Im=10 mA. Extended range of current,…

Q: Question 2 Given the following block diagram. R(s) (a) (b) G₁ H₁ H₂ G₁₂ Draw the signal flow graph…

A:

Q: Find the values of R₁, R2, R3, and R4, if V₂ = -25 V R₁ 0.625 A 40 Ω + 50V- + R₂ Z V₂ 02 5Ω R3 1.25…

A:

Q: The two-wattmeter method of three phase power measurement can accurately measure the active power…

A: In this question we need to verify the given statement is true or false. For 2nd question we need to…

Q: 3. Some GPS receivers use 1 bit ADCs (Analog-to-digital Converters) to sample and quantize the…

A: Given: GPS receivers use 1-bit ADCs. The output of the ADC is simply 2 quantization levels.

Q: For the circuit given, a) Find VO in terms of V1 and V2. b) If V1=2V and V2=6V, find VO. c) If the…

A: The required parameters can be obtained considering the ideal opamp characteristics and then by…

Q: Daily load of an industry is 200 kW for first one hour, 150 kW for next seven hours, 50 kW for next…

A: In this question We need to determine the annual bill of the electricity.  We know energy E= power ×…

Q: Use a 560 nFnF capacitor to design a low-pass passive filter with a cutoff frequency of 59…

A: In this question we need to design a low-pass passive filter with a cutoff frequency of 59 krad/s

Q: 2) The electric bill for a family for a month is $120.00. Assuming a 30-day month and using each day…

A: Given Data: Electric Bill per month Cmonth =$120 Number of days in a month N=30 days Usage time per…

Q: QUESTION 5 Find the magnetic force when a charge 3.5C with flux density of 4 units is having a…

A: Given: charge, Q=3.5 C Flux density B=4 units Velocity, V= 2m/s

Q: The accuracy of a 0-100 mV voltmeter is ±5%. A full-scale reading of a 100 mV may be due to a…

A: Given data, Voltmeter reading 0-100 mV. Accuracy =±5%. Full scale reading = 100 V.

Q: Problem 2: For the circuit shown below: Use the nodal-analysis method and the supernode concept to…

A:

Q: 4. Consider the RC circuit shown at right. a) If S1 is held closed for 10 s before it is re-opened,…

A:

Q: In the circuit in (Figure 1), take R = 24 kn. Figure 2.5 mA ( 8 kn R w + % - 80 ΚΩΣ Հ w 15 ΚΩ 40 V 5…

A: In this question we need to find a voltage Vo using source transformation and mesh current method.

Q: In the circuit shown, the voltage Vx is 0.5 V 5A1 1002 200 802 0.25 V

A: In the given circuit , finding the voltage Vx

Q: sin(t-2). 2. Calculate the Fourier transform (X(jw)) of x(t): x(t) = (2) Determine @M, such that for…

A: The above question is based on the Fourier transform of sinc function and application of Nyquist…

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.