following transformer circuit VSource=12.0volts, RSource=4, the number of turn on the left-handside is 100 and on the right-handside is 800. RLis 700. a.Find the voltage across RL

Q: If you are planning to make an idea charger (step down transformer) with an  output of 5.0V when it…

A: The required expression for the required ratio of output to input turns of coils is,

Q: An emf of 9.7mV is induced in a coil while the current in a nearby coil is decreasing at a rate of…

A:

Q: The maximum value of the emf in the primary coil (Np = 1600) of a transformer is 215 V. (a) What is…

A: Given that:- Vp=215 volt  Np=1600 Ns=350

Q: A step-down transformer produces a voltage of 6.0 V across thesecondary coil when the voltage across…

A: Given data The initial voltage across the secondary coil of a step-down transformer is: VS_1 = 6 V…

Q: The flexible loop in the figure below has a radius of 15 cm and is in a magnetic field of strength…

A:

Q: The self-inductance of a coil is 50 mH. What is the emf induced when the current in the coil…

A:

Q: Remembering that your transformer has twice as many turns in the secondary coil as in the primary…

A: transformer has twice as many turns in the secondary coil as in the primary coil, what is the ideal…

Q: A long solenoid has n=900 turns per meter and a current ? = 3.2 sin(??). Inside the solenoid with a=…

A: n= 900 turn , a= 0.5 m Nc= 100 turns, b= 0.2 m I= 3.2 sin wt

Q: A simple RL circuit includes a 0.125-H inductor. If the circuit isto have a characteristic time of…

A: The expression for the characteristic time of RL circuit is τ=LR Here, R is the resistance of the…

Q: In the transformer shown in the figure below, the load resistor on the right-hand side, RL , is 50…

A:

Q: An American traveler in China carries a transformer to convert China's standard 220 V to 120 V so…

A:

Q: A Transformer has an inpud voltage 12o.k(ims)ac The desire outage voltge is li36xl0v (Ems). frimary…

A:

Q: An electric power station that operates at 15 kV and uses a 20:1 step-up ideal transformer is…

A: The output voltage is,

Q: Tthe length of a moving conductor L=0.25m (you may assume that this is the distance from “rail to…

A: Given that:- Length of moving conductor=L=0.25m

Q: Can a transformer be operated by a DC waveform at its input? What would be the secondary voltage of…

A: Can a transformer be operated by a DC waveform at its input? What would be the secondary voltage of…

Q: A step down transformer produces produces a voltage of 6 volts across the sec- ondary coil when the…

A: voltage in primary, Vp = 120 V  voltage in secondary, Vs = 6 V

Q: An inductor carrying a current of 3.9 A stores 0.45 J of energy. What is the inductance ofthis…

A: To determine inductance of inductor, the expression is, U=12LI2

Q: A solenoid with 35 x 103 turns per meter, a cross sectional radius of 0.6 m, and a length of 0.2…

A:

Q: An AC transformer in Okahandja operates at input voltage of eight-and-a-half kilo-volts to suppy 120…

A:

Q: The radius of the circle forming a coil of N=105 turns is given as r=4.3cm. The coil is placed in…

A:

Q: Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once converted…

A:

Q: The rectangular coils in a 355-turn generator are 13 cm by 19 cm.What is the maximum emf produced by…

A: Given: The number of turns is 355. The dimensions are 13 cm by 19 cm. The angular speed is 505 rpm.…

Q: What is the magnetic field due to an inductor of length 10 cm that has 300 turns if 0.25 A of…

A: B = magnetic field due a inductor.  B= uo n i Where n = number of turns  i = current L= self…

Q: In the given circuit an inductor of L = 6.20-mH and a resistor of R = 12.4-2 resistor are connected…

A: Since,  Voltage across inductor  VL = Ee-Rt/L  So voltage across resistance  VR = E - Ee-Rt/L

Q: PHYSICS 12 WCLN.ca 9. Calculate the load current and load voltage in this transformer circuit (2390…

A:

Q: How many windings would be needed to produce at output of 110V AC? Is this a step down or step up…

A:

Q: The magnetic flux through the loop increases according to the relation shown below. What is the…

A: Magnitude of Induced EMF is given by: EMF = N*d(phi)/dt phi = Magnetic flux = (6.5t^2 + 1.9t) Wb N =…

Q: A fixed 19.7-cm-diameter wire coil is perpendicular to a magnetic field 0.57 T pointing up. In 0.25…

A: Consider the change in magnetic field be dB, the time interval be dt, the diameter of the wire coil…

Q: what isthe current in the circuit after 1 μsec?

A: The equation for the current here is

Q: If the peak value of a 60Hz generator is 160V, what is the instantaneous voltage after the loop has…

A: Given data The frequency of the generator is given as f = 60 Hz. The Peak value of the generator is…

Q: What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose…

A: R = 4 mm  r = 0.5 mm

Q: A 50cm long solenoid, having 500 turns and radius 2cm ,is wound on an iron core of relative…

A: Length of solenoid: l = 50 cm = 0.50 m Number of turns : N = 500  Radius of solenoid; r = 2 cm =…

Q: Does the induced emf always act to decrease the magnetic flux through a circuit?

A: According to Lenz's law -  "An induced electric current flows in a direction such that the current…

Q: A 10 ohm resistance wire and a 0.5 H coil are connected in series between the ends of a generator…

A: SOlution: Given that R = 10 Ohm L = 0.5 H V = 100sin40t

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.