flow rate of water in a garden hose is measured using the bucket-andstopwatch method. Filling a 5-L bucket takes 75 seconds. If the inner diameter of the hose is 10 mm and the density and viscosity of water are approximately 998 kg m-3 and 0.9 cP, respectively, (a) is the flow inside the hose laminar or turbulent? (b

Q: The turbulent velocity profile in the pipe is given by the equation, ... Shear velocity 0,69 m/s,…

A:

Q: A new steel pipe, 15 cm in diameter and 1200 m long carries 0.020 m^3/s of heavy fuil oil with S=…

A:

Q: When water at 20 °C is in steady turbulent fl ow through an8-cm-diameter pipe, the wall shear stress…

A: Given data To determine axial pressure gradient (∂p/∂x) in pipe if  1) Horizontal flow with the…

Q: Take the density and dynamies viscosity of the water as follows, determine the value of friction…

A:

Q: A plate at 0.02mm distance from a fixed plate, moves at 60 cm/s and requires a force of 3 N/m? to…

A:

Q: certain garden hose is advertised to be able to deliver 550 gallons of water per hour. If the hose…

A: Given:Q=550 gallons/hr =0.000578327 m3/sL=50 feet =15.24 md=58 in =0.015875 mμ=1.002*10-3 Kg/m.s

Q: Gasoline at 20°C flows at 105 m3/h in a 10-cm-diameterpipe. We wish to meter the flow with a…

A: Given data: The discharge of the gasoline is Q=105 m3/h. The diameter of the pipe is d=10 cm. The…

Q: A pitot-static probe will be used to measure the velocitydistribution in a water tunnel at 20°C. The…

A: Given data as per the question  the specific gravity of liquid = 1.7 velocity in the water tunnel =…

Q: An ideal gas at 250 °C and atmospheric pressure flows through a smooth pipe with ID 6-in. The…

A:

Q: Make an analysis of the shape h ( x ) of the water–air interfacenear a plane wall, as in Fig. ,…

A: The small slope is given as, The pressure difference is given as,

Q: A solid cylinder of weight 9 kg slides in a vertical lubricated pipe. The clearance between the…

A:

Q: An empty vessel which is open at the top has a horizontal capillary tube of length 20 cm and…

A:

Q: If, for laminar fl ow in a smooth, straight tube, the tubediameter and length both double, while…

A:

Q: Under laminar conditions, the volume flow Q through asmall triangular-section pore of side length b…

A:

Q: An oil (viscosity 1 Pa.s, density 800kg/m3) is flowing in an axisymmetric pipe. The flow is fully…

A:

Q: Sulfuric acid with a density of 1980 kg / m3 and a viscosity of 26.7 cP flows in a pipe with a…

A:

Q: We are given laboratory data, taken by Prof. Robert Kirchhoffand his students at the University of…

A: Writing the parameters in MLT system as follows,

Q: Two parallel plates, one moving at 4 m/s and the otherfi xed, are separated by a 5-mm-thick layer of…

A: Given data           Velocity 'v'=4m/s           thickness 'dy'=5 mm          Specific gravity…

Q: Three pipes connected in series with lengths L1 = L2 = L3 = 150  m and diameters D1 =75 mm, D2 = 50…

A: (a) Write the expression of relative roughness. k=εD

Q: Explain the physical significance of the Nusselt. Calculate the Nusselt numbers for the following: A…

A: Given data:   Prandtl Number = Pr = 0.71 Dynamic viscosity = µ = 4.63 x 10-5 kg/ms Specific heat =…

Q: Take water density p = 998 kg/m° and dynamic viscosity u = 0.001 kg/(m.s). The total flow rate is…

A:

Q: A mixed berries cordial manufacturer changed to 5 m stainless steel tubing due to high amount of…

A:

Q: A smooth pipe of 100 mm diameter and 1000 m long is carrying water at the rate of 10 litres/sec. If…

A:

Q: Water has a coefficient of viscosity of 0.001 Pa/s. What pressure difference is necessary to keep…

A: The viscosity coefficient is a measurement of the fluid's resistance to flow. Gas viscosity is often…

Q: A settling tank for municipal water supply is 2.5 m deep,and 20°C water fl ows through continuously…

A: The data given is, Water velocity, V = 35 cm/s = 0.35 m/s Water depth, h = 2.5 m Water temperature,…

Q: Q4) Water at 10°C flows from a large reserveir to a smaller one through a 5-cm-diameter cast iron…

A: Q=6L/sD=5cmA=πD2/4=1.963X10-3 m2avg velocity, v:v=Q/pA=6x10-3/999.7X1.963X10-3v=3.057X10-3m/s…

Q: Ah Assignment: The losses per unit length of pipe in tubulent flow through smnooth pipe depend ipon…

A: ∆hL=f V, D, g, μ, ρ

Q: A long fi xed tube with a rounded nose, aligned with anoncoming fl ow, can be used to measure…

A: Unit conversions: (a) Consider the diagram shown below for the device.

Q: Two oil tanks are connected by two 9-m-long pipes, asin Fig.. Pipe 1 is 5 cm in diameter and is 6…

A: Given data The length of both the pipe is L=9 m The diameter of the pipe 1 is D1=5 cm=0.05 m The…

Q: (a) The gap between two horizontal plates is 5 mm. The gap is filled with oil of a relative density…

A:

Q: Fluid flow through a horizontal circular pipe of inner radius of 2 cm with centerline velocity as…

A: Consider the first data and you can fellow the same procedure for other remaining data. Given data:…

Q: Heavy oil with a density of 912 kg/m^3; kinematic viscosity of 2.05 x 10^-4, is delivered to an…

A:

Q: Water at 20°C flows in a long horizontal commercial-steel 6-cm-diameter pipe that contains a…

A:

Q: A new steel pipe, 15 cm in diameter and 1200 m long carries 0.020 m^3/s of heavy fuil oil with S=…

A:

Q: Consider a large dirigible (like the Goodyear blimp) with length L = 240 m, and average diameter D =…

A:

Q: A piezometer and a Pitot tube are tapped into a 7-cm-diameter horizontal water pipe, and the height…

A:

Q: SAE 30 oil (density = 917 kg/m³, viscosity = 0.26 kg/(m*s)) is flowing through a 2 cm diameter tube…

A:

Q: An engineer monitored a flow of gasoline of about 50 m3/h and of density ,ρ 680 kg/m3 through a…

A: Solution: Given Data: Q=50 m3/hρ=680 kg/m3D=10 cmd=5 cmμ=2.92×10-4 kg/m-s   To Find: Which device is…

Q: A pipeline 0.5 m diameter and 1200 m long is used for transporting an oil of density 150 kg/m3 and…

A: Write the given data.  d=0.5 m L=1200 m ρ=150 kg/m3Q=0.4 m3/s μ=0.91 Pa·s Here, d is the pipe…

Q: ANSWER ASAP Using the velocity distribution for a laminar, incompressible flow of a…

A:

Q: The piezometric pressure gradient (aP/ az), where x is the downstream distance, is found to be…

A: Explaining the statement, when the pressure gradient is constant and negative for fluid flow in the…

Q: In his study of the circular hydraulic jump formed by afaucet fl owing into a sink, Watson  proposed…

A: Given: The volume flow rate is Q. The density of the fluid is ρ. The viscosity of the fluid is μ.…

Q: (THANKYOU)Liquid methyl ethyl ketone (MEK) flows through a pipe with an inner diameter of 3.565…

A:

Q: Freshwater (density = 1000 kg/m3, viscosity = 0.001 kg/(m*s)) is flowing through a 2 cm diameter…

A:

Q: 30 m length of smooth pipe? Calculate the total equivalent length of pipe that would produce a…

A: Given data :-  Diameter D = 1 inch = 0.0254 meters  Pressure drop (dp) = 70 kpa  Mass flow rate m =…

Q: flow is turbulent.

A:

Q: Oil is to flow through a pipe at 80°C, and for experimental purposes, the oil flow must be…

A:

Q: Determine the head loss due to friction of an oil of specific gravity 0.77 and viscosity 0.85 poise…

A:

Q: Water flows through a 10 mm diameter and 250 m long smooth pipe at an average velocity of 0.1 m/s.…

A: Diameter of pipe=10mm Long =250mm Velocity =0.1m/s2 Density =997 kg/m3 Viscosity =855×10-6 N. S/m2…