Answered: For an LC Oscillator, the value of the…

For an LC Oscillator, the value of the inductor is 25 mH and the value of the capacitor is 50 uF. Find out the frequency of oscillation.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Related questions

Q: Under dc conditions, find the energy (in Joules) stored in the capacitor. Give only the numeric…

Q: An industrial plant draws 500 kW at 0.6 pf lagging from a 3-phase system. In order to raise the…

Q: 8 Ω 2V ΖΩ 4Ω Va 1 ЗА

Q: 2(a). Show how the AND-OR array should be programmed to implement the SOP expressions. Y = ABC + ABC…

A: Given data, SOP expression Y=AB¯C+A¯BC¯+ABC AND-OR array,

Q: Problem: A series RLC circuit is compose of R = 50 Q2, XL = j40 Q2, Xc = -j15 22. The supply voltage…

Q: What is mass per volume? a. density b. pressure c. power d. work e. a & b This is caused by the…

A: 1. Option (A) (density) The formula for density is d = M/V, where d is density, M is mass, V…

Q: Q. What is the difference between the effect of resistance on current and volta drop through and…

A: Solution- Effect of resistance on current - ⇒Resistance is the property of a material to opposes…

Q: You can use the Laplace transform to solve differential equations with initial conditions. For…

A: Given, Resistance R1 = 8 Ω, R2 = 4 Ω, R3 = 6 ΩCapacitance C = 12F, Inductance L = 3.2 HInitial…

Q: Electrical Engineering given a CLTI system whose impluse response is h(t)=e^-3u(t) find the transfer…

Q: A 240 V, 4 pole wave wound dc shunt motor has 600 conductors on its armature. It has an armature…

A: Given, A DC shunt motor has V=240 VP=4 A=2 wave woundZ=600Ra=0.7 ΩE=210 Vϕ=10 mWb

Q: a current element J.dv is measured in terms of

A: given current element J.dv

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: The maximum power will be transferred to the load if the load resistor is complex conjugate of input…

Q: c) A linear sensor-transmitter is used in the flow control loop. The current transmitter output is…

A: Given parameters: For the calibrated Linear output flow sensor, Current output at 5 m3/hr flowrate =…

Q: If Vs = 32 V, find v (in Volts) at t=194us. Give the answer in 3 decimal places. (Unit is not…

A: For the given circuit : Vs=32 Vthen calculation of v at t=194 μs In the given circuit switch is…

Q: half-wave rectifier circuit

A: Given- Power rating= 100 W Voltage rating = 110 V Firing angle = 60 degree

Q: A current of 6 amperes branches into currents x, y, and z through resistors with resistences 6, 4,…

Q: 1.) For the following polynomial, for 1+ G(s)H(s) = 0 and using Routh's method for stability, find…

Q: From the following trifilar circuit let Van = Vnb = 120 ∟0° Vrms, determine: a.) InN b.) The active…

Q: For an LC Oscillator, the value of the inductor is 25 mH and the value of the capacitor is 50 uF.…

A: Given information: The value of the inductor is L=25 mH The value of the capacitor is C=50 μF The…

Q: A 555 MVA, 24 kV, 0.9 p.f., 60 Hz, 3 phase, 2 pole synchronous generator has the following…

A: We have an synchronous generator and data is as given in questions We have been asked to find, Ld…

Q: Find the parameters for the circuit in the figure. Take R₁ = 3, R₂ = 5, and R3 = 14. (Figure 1) V₁…

A: Given: Circuit diagram Z-parameter equation will be: V1=Z11I1+Z12I2V2=Z21I1+Z22I2

Q: 1) The voltage VCE with ß = 200 is i) ii) iii) + VBB 10 V 13.06 V 6.94 V 9.3 V RB www 47 ΚΩ Rc 330 Ω…

A: Given, Current gain, β=200

Q: Find the inverse DTFT of X(ejo): = 1- 13 12 13 e-jo +2 -jw e 12 + 1 4 e-2 joo

Q: Two impedance coils which have resistances of 2.6 and 3.7 ohms take 5 and 10 amperes respectively…

A: We have 2 coils connected in parallel and we have been asked to find current if this two coils are…

Q: The equivalent resistance of the resistive network shown below is 50 a www o 109 50 bo www O a. 2002…

A: Given circuit,

Q: 7. Calculate the magnitude & direction of the resultant [R] of two forces, A =5N and B=10N. The…

A: Given: Magnitude and direction of the force:A=5NB=10NθA=40°θB=70°

Q: But what precisely is meant by the term "digital audio"? The procedure through which analog sound…

A: Analog to digital converter : Analog signals get converted into digital signals. amplitude…

Q: Consider the following circuit shown in below figure. If Vo R; = 1 kΩ www E₁ = 5V V₂ + +V -V V₂ =…

A: Given circuit: Output voltage, Vo=10.3 V

Q: Find i at t=0" 4V 126.32mA 400mA 336.84mA 10 Ω Μ t=0 Χ. 3Ω 5 Ω www ell 36 nH

A: So first we have to draw the condition before the switching happened so that we can find the given…

Q: A 50μF capacitor initially charged to 125V is discharged across a series combination of a 1k0…

A: A 50 μF capacitor initially charged to 125 V. Resistor R= 1K-ohm Capacitor210 micro farad Find…

Q: 3. Determine lo. 120/10° V (₁2+) 100 W RSITY IS RIE Io↓ to ution to jo 102 -jon

Q: The series RLC circuit has R-10 Ohm, C-5 mF, L-20 mH Source of the voltage (cos) has the amplitude…

Q: image

A: (a) An uncharged capacitor acts like a short circuit. So, all current goes through 10Ω resistor…

Q: Design an 8-4-2-1 BCD code converter to drive a seven-segment indicator. The four inputs to the…

A: We need to design an 8-4-2-1 BCD code converter circuit to drive a seven-segment display as shown…

Q: connected in parallel with an 90 Q resistor across a Vrms = 230<0° V, f = 60 Hz supply. Calculate…

A: Given R= 90 ohms C = 25 microF V= 230 v F = 60 Hz

Q: 1. A cylindrical capacitor is formed using two different circular metal plates and a dielectric…

A: Given parameters: A parallel plate capacitor with two circular plates Dielectric constant, k For…

Q: a.1) In a certain UJT, r'B1 = 2.5 k and r'B2 = 4 KQ. What is the intrinsic standoff ratio? a.2)…

A: The unijunction transistor is a electronic device which is used as an electrically controller…

Q: Design a 6th order Butterworth band-pass filter circuit with cut-off frequency is 4KHz and 7KHz,…

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

Q: A resistance oven employing nichrome wire is to be operated from 220 V single phase supply and is to…

A: All the steps are shown below

Q: Determine VAB in the circuit below. * 18/45 A ↑ O 11.62-59.9° V O 11.22-59.9° V O 11.8/59.9° V O…

Q: how did it came up with 2.5? can I see the process on how it was solved step by step? thank you! i…

A: The given circuit is shown below:

Q: Delta modulation uses_________ bits per sample.

A: In this case, the correct option related to Delta modulation needs to be selected.

Q: How much energy (in kilowatthours) is required to light a 60-W bulb continuously for 1 year (365…

A: Given: Power of bulb, P=60 W Time, t=365 days

Q: A 25 µF (25E-06 F) capacitor is connected in parallel with an 90 resistor across a Vrms = 230<0° V,…

Q: How many channels are available in the 2.4 GHz band? List all the channels. What is the…

A: 1. The frequency range between 2401 and 2484 MHz is used by 2.4 GHz WLAN or Wi-Fi Technology .There…

Q: A series circuit of resistance 60 2 and inductance 75 mH is connected to a 110 V, 60 Hz supply.…

Q: A dc motor running at full load on a 118 V line develops a back emf of 109 V and draws a current of…

A: Use basic equations to find out the power developed Here power developed mechanically is the product…

Q: 2 100 Capacitance Real Power (UF) (Watts) 90 80 m 50 Q 70 60 V1 220 Vrms 60 Hz 0° Computed Values…

A: RLC circuit:- A circuit that consists resistor (R), inductor (L), and capacitor (C) is called an RLC…

Q: 2. The de source supplying a single-phase inverter with is 99 V. The load is an R. L series…

A: Given information about a PWM controlled single phase inverter is, DC supply voltage Vdc=99 Volts.…

Question

For an LC Oscillator, the value of the inductor is 25 mH and the value of the capacitor is 50 uF. Find
out the frequency of oscillation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Multicolour LED Mono LED Dimensional LED The capacitor in a clamper circuit is in parallel with the voltage source * None True False For the following circuit, the vo waveform is wwwww
A full-wave rectified voltage of 18 V peak is connected to a 400micro F filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA?
Q/ Graph the input and output wave of the following circuit : R1 1kO ADI V1 RL 6.5 Vrms 10kQ 50 Hz V2 5 V
H.W: od vd babivoro R₁₂ = Ret dondbesit di duonds dondbest evitsyon. A Wien Bridge Oscillator circuit is required to generate a sinusoidal waveform of (5.2kHz). Calculate the values of the frequency determining resistors and the two capacitors to produce the required frequency. 2-926do 081 benistere not gniwolls fide-oesdg to IstoAct=3151891 golibros ow! Also, if the oscillator circuit is based around a non-inverting operational amplifier configuration, determine the minimum values for the gain resistors to produce the required oscillations. Finally draw the resulting oscillator circuit.
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz
For the following parts, identify the name of each circuit, plot the output waveform, and find the DC output average voltage. Part (a) V 1 cycle V₁ = V sin cor Part (b) PE Part (c) Vm Vi ele eeeeeeeeeeeeee D D₂ D₁ D₂ R Va + D₂ D₁
Draw variable capacitor and label it's parts
If the TIME/DIV is set to 0.2 ms, what is the time constant of the circuit? X ms An oscillator with a natural frequency of 380 Hz is driven by a 580 Hz sinusoidal signal. At what frequency does it oscillate?
What is the frequency of oscillation for RC phase shift oscillator with R = 10 kn and C= 0.001 µF in each of its three RC section? A) 5 kHz. B) 5.5 kHz. C) 6 kHz. D) 6.5 kHz.
A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor, what must be the capacitance of the capacitor to produce resonance to 250 volt, 60Hz main? QUICKLY I NEED IT IN5 MINS
3. Determine Vo and Sketch output waveform for the clamper network shown. 20 V Si C Vi 4 V- -20 V
The clamping circuit clamps or shift the * .input sinusoidal signal up or down FO