Find Vo in the network using Norton's Theorem. 220°A 1220°v (A 12 12 Ix 2Ix -j127 Vo

Q: If the bode plot diagram is experimentally determined, one can find : (a) Transfer function of the c...

A: If the bode plot diagram is experiment determined,   

Q: Calculate the line and phase current drawn bythe load

A: In this question,  We need to calculate the line and phase current drawn by the load.  Current I= V/...

Q: 56. A transformer has a turns ratio of 5. If a 100-2 resistor is connected across the primary, what ...

A: Solve the problem

Q: When a 76.20 Hz sinusoidal voltage is applied to the input of a full wave rectifier, the output freq...

A:

Q: Most industrial loads (Motors, Fluorescent lights) are inductive in nature and have a lagging power ...

A: To select correct answer Most industrial loads (Motors, Fluorescent lights) are inductive in nature ...

Q: The inverse Laplace transform of the following function is: F(s)= s-3 a. f(t) = 5e-3'u(t) = 5e O b. ...

A:

Q: In two-wattmeter method, the readings of the wattmeter will be identica load in one of the two phase...

A: Option - b ( Answer )

Q: Determine the type of lead/contact shown in each of the pictures below.

A: Given chips are as below,

Q: How many nodes are there in the circuit? A. 2 B. 4 C. 6 D. 8 E 10 ii. How many circles are in the ci...

A: As per guidelines,we are supposed to answer only first three subparts of a question.Please repost th...

Q: In an RLC circuit, resonant frequency is directly proportional to the Resistance (R) used in that ci...

A:

Q: 12V A81 やる。 とzK VD=12 110K 0.68K find エs vs, VDs *Nach pr P-ch in

A:

Q: R = 30 2 R3 = 50 2 A 4 =? I3 =? I7 = ? VA = 120 V R2 = 40 2 R4 = 60 2 12 = ? I4 = ? R5 = 60 2 Is = ?...

A:

Q: Vi RL Vo mput waveform Output waveform Positive clamper with negative bias ysics and Radio-Electroni...

A:

Q: What is the angular frequency of a waveform having a period of 1 millisecond?

A: There is no correct answer in the option . I have checked the solution . This question belongs to el...

Q: 2. R=

A:

Q: A circuit is constructed with six resistors and two batteries as shown. The battery voltages are V, ...

A: 2Apply Kirchoff's law,The current I3 that flows through R3 isI2=I1+I3 .....1I3R3-I1R1+V1=0From equat...

Q: For the circuit in Fig. P3.31, find i, and then use current division to find i. Figure P3.31 ig 10 Ω...

A:

Q: 67. A 2200/200 V, 60-Hz, transformer takes 0.5 A at a power factor of 0.3 on open circuit when suppl...

A:

Q: In a series RLC circuit, at high frequencies, capacitance is dominant and the phase angle approaches...

A:

Q: iv. For a long high voltage transmission line with light loading: (a) The voltage is generally high ...

A:

Q: Contribution of fault analysis in power system netwrok?

A: Solution- Contribution of fault analysis in power system network- Fault analysis of a power system i...

Q: EXERCISE 5.9 Consider a family of logic gates that operates under the static discipline with the fol...

A: For a family of logic gates,The thresholds voltages are as follows,VIL=1.5 VVOL=0.5 VVIH=3.5 VVOH=4....

Q: Capacitors causes the voltage to lag the current by 90 degree. This is the same as saying that the c...

A:

Q: Determine the ac resistance for the diode of Fig. 15 at 0.75 V. Include an illustration in your solu...

A: To calculate ac resistance of diode

Q: G1 V1= 1.0L0° pu S2 = 0.2 +j0.05 pu G2 Bus 1 Bus 2 Yı2= - j4 pu Sa2 = 0.8+j0.2 pu Fig P 1. Apply Gau...

A: Disclaimer: "Since you have posted a question with multiple sub-parts, we will solve first part for ...

Q: R = 330 2 R3 = 91 2 Voltmeter E 10 V R2 220 2 %3D (DMM or VOM)

A:

Q: electrical circuit contains a capacitor of 11.24 microfarads and a resistor of 1124 ohms. If the cap...

A: The solution is given below 

Q: 25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respec...

A:

Q: • Solution of G2(s) = 2(s+10) s(s+1)(s+4) • Find the point of crossing from Q3 to Q2 which is at pha...

A:

Q: Consider the circuit below with the values of the elements as indicated. Find the following: 2F 7H e...

A:

Q: An AM signal has the following characteristics: fc = 150 MHz,  fm =3 kHz , Vc = 50 V , Vm = 40 V Fo...

A:

Q: ii. For any complex network containing R, L, C resonance occurs when (a) The imaginary part of Z onl...

A:

Q: (a) Calculate the voltage vout using (i)Simple Circuit techniques for the circuit shown: (b) What is...

A: Fir negative feedback op amp circuit, we can apply virtual short condition i.e. V+ = V-   Iop Amp ha...

Q: of 103 uit 202 502 & V1 -J252 2V1 V2

A:

Q: Using re model, compute for the AC characteristic of below circuit. (Av) 15 V 10 k2 45 k2 21 k2 10 μ...

A:

Q: 4 Ip (mA) 20아 %3D 19+ %3D Actual commercially available unit 18+ 3D 17- 3D 16- Eq. (1) 15- 14- %3D 1...

A:

Q: A C-filtered center-tapped rectifier circuit is used to rectify sinusoid of 110 Vrms, 60HZ. The mini...

A: Given:V=110 Vrmsf=60HzMinimum output voltage=35Volttransformer ratio= 2:1load resistance, RL=1.8kΩ

Q: 9. The effective voltage across a circuit element is (20 + j10)V and the effective current through t...

A:

Q: Find the pawcr and current dissipated in lO LED in the circuit,

A:

Q: Find the cross correlation of the sequences x(n) = {1, 2, 3, 4 } and h(n) = {2, 4, 6}

A:

Q: Which of the following actions Transistors can do during the Third Generation? a) Can solve many pro...

A: Transistors in third generation were designed and upgraded to do many things together. Punch cards w...

Q: The diode starts to conduct when the voltage across it is 0.6 V. Vin is a variable DC voltage source...

A: To find the input voltage at which diode starts to conduct

Q: Explain the following: 1. Why does magnitude impedance in a RC ciruit decreases when thre frequency...

A:

Q: For the given circuit for a 13.04 Vpeak sinusoidal input Vin, what is the value of Vout (in V) when ...

A: The diode will conduct only during the positive half of the input cycle. so replace the diode with i...

Q: sk 3 1. Determine the unilateral z-transform and ROC(Region of Convergence) of the following signals...

A:

Q: a I1 212 V,079 I3 -j10 b 10 j22 420°A I2 I5 e ll

A:

Q: 3. R, =_MQ = 50 MO R=50 kn

A: When two resistors are in series Their equivalent resistance will be addition of individual resistan...

Q: Determine the maximum voltage that can be applied across the series combination of a 150-ohm, 2 watt...

A:

Q: Calculate the transformer turns ratio required to connect four parallel 16 – N speakers so that they...

A:

Q: 22 n VIN 8 V Figure 8

A: The given circuit diagram is shown below:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.