Answered: Find the total weight of a 10 ft' tank…

Find the total weight of a 10 ft' tank of oxygen if the oxygen is pressurized to 500 psia, the tank itself weighs 150 lbf, and the temperature is 70°F?

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter20: Hydrogen

Section: Chapter Questions

Problem 7P

See similar textbooks

Related questions

Q: A 0.025-cubic meter metal block is tied to one end of a 3000-mm long square wooden plank with…

A: Given, The volume of metal block=0.025 m3 Dimensions of wooden plank=210mm×210mm×3000mm Weight of…

Q: Calculate the dynamic and kinematic viscosities of water at 350 degrees Kelvin

A: Given data, Temperature= 350 degree kelvin to find dynamic and kinematics viscosities

Q: Which has greater buoyancy at a pressure of 1000 hPa, an air parcel with a temperature of 315 K and…

Q: Given the subsequent statistics for liquid methanol, decide its density in h/f * t^ three and…

Q: A 4-in diameter solid cylinder of height 3.75 in weighing 0.85 lb is immersed in liquid (y= 52 pcf)…

Q: Air is kept at a pressure of 200 kPa absolute and a temperature of 30 degree celsuis in a 500 liter…

Q: QUESTIONS AND PROBLEMS: 1. If 5.6 mm3 of oil weighs 46,800 N. Calculate its density and its specific…

Q: You are in an old spy movie and have been locked into a small room (volume 1,000 ft3). You suddenly…

A: Assumptions that we consider in this particular problem There is no flow rate The reaction rate is…

Q: 1. A silver bullet used to kill vampires in the late 19th century was found to be suspended in a…

Q: 13. A bottle consisting of a cylinder 30 cm in diameter and 30 cm high has a neck 5 cm in diameter…

Q: Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively,…

Q: A volume of 15.5 cu.ft of a liquid weighs 782 lb. Compute the mass density of the liquid.

Q: Suppose you decide to define your own temperature scalewith units of O, using the freezing point 113…

A: First determine for the scaling of the new setting with the help of given conditions for oleic acid.…

Q: 3. A metal sphere cools at the rate of 3 degrees Celsius per minute when its temperature is 50…

Q: If a vessel that contains 9.2 ft3 of water at 50°F and atmospheric pressure is heated to 160°F, What…

Q: What is the ratio of the dynamic viscosity of air to that of water at standard pressure and a…

Q: Liquid ammonia has a specific gravity of 0.826. Calculate the volume in cm 3 that would weigh 5.0 lb

A: 1 lb= 453.592 gm G=0.826

Q: The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the…

Q: Absolute pressure = Gauge pressure + Atmospheric pressureA pressure gauge in a refrigerator system…

A: Given: The gauge pressure is 119.6 psi. The atmospheric pressure is 14.7 psi.

Q: The unit weight of water at 50ºF is 62.4pcf. If the volume of the vessel that contains water is…

A: The change in volume is calculated by comparing the 50-degree Fahrenheit water temperature unit…

Q: What is the equivalent value of T = 120° F in kelvins?

A: Given: The temperature is 120°F.

Q: Find the pressure in the pipe cortaining gasoline in kPa. Ir the given conditions, cir has a density…

Q: Water at 68 has a dynamic viscosity of 1 centipoise. Compute its dynamic viscosity and kinematic…

A: The viscosity is defined as the measure of the resistance developed in the fluid against the flow.…

Q: A sample of air analysed at 0ºC and 1 atm pressure is reported to contain 0.02 ppm (parts per…

A: Given data: k=22.4 liters per mole M=46 gm

Q: atmospheric pressure? (Tla

A: To find : Change in pressure percentage

Q: theoretical oxygen demand,

A: If the organic compounds and their concentrations present in water are exactly known,the oxygen…

Q: 8. An empty warehouse room, 12 meters long, 8 meters wide and 4 meters high is at room temperature.…

A: Density = mass / volume specific weight = weight / volume

Q: The figure below shows a closed tank that contains gasoline floating on water. Calculate the air…

A: Solution: Given Data S.G for mercury=13.54 Pressure is given byP=ρghρ=density of…

Q: Calculate the partial pressure of oxygen in the air at 100 kPa if nitrogen has a partial pressure of…

A: Since the question number to be solved is not specified, the solution for Question a is as follows:…

Q: An open tank contains water at a height of 3.6m. If the water is to be replaced by a liquid whose…

Q: In the Figure, if the local atmospheric pressure is 755 mm of mercury (specific ity 13.6),…

Q: A 100-L container is filled with 1 kg of air at a temperature of 27°C. What is the pressure in the…

Q: 4. A body cools from 60 degrees Celsius to 50 degrees Celsius in 5 minutes. How much time will it…

Q: A pump discharges a liquid into a drum at the rate of 0.032 m3 /s. The drum, 1.5 m in diameter and…

Q: Find the temperature in Celsius at which 0.654 miles of neon will occupy 12.30 L at 1.95…

A: Given data: Number of moles (n) = 0.654 moles Volume (V) = 12.3 L Pressure (P) = 1.95 atm.

Q: 3. Find the total weight of a 10 ft' tank of oxygen if the oxygen is pressurized to 500 psia, the…

A: To determine Total weight?

Q: 1. A mechanical device rests in a level position on two supports, each 42 in. high, at 60°F.The…

Q: Find the dynamic and kinematic viscosities of kerosene, SAE 10W-30 motor oil, and water at a…

A: Given: The temperature is 50oC.

Q: The water in a hot water heating system is heated to 76°C. What is thistemperature reading on a…

A: Given values: Temperature in Celsius = 76°

Q: What volume (in liters) does the H2 occupy at standard temperature and pressure(STP).

Q: (2) The fuel gage for a car's gasoline tank reads proportional to the bottom gage pressure. If the…

Q: What is the ratio of the dynamic viscosity of air to that of water at standard pressure and a…

A: At 20 degree CelsiusDynamic viscosity of air : 1.8205×10-5 kg/ms Kinematic viscosity of air :…

Q: What isthe weight of a 10ft cube tank of oxygen if the oxygen is pressured ti 400 psia, the tank…

A: The given data is as follows: Volume of tank=10ft3 Pressure of oxygen=400 psia Weight of tank=100…

Q: Environmental Engineering If we approximate the atmosphere to be 79% nitrogen (N2) (by volume), and…

A: The ppm concentration of N2 in the air is 0.79x106.

Q: Read the question carefully and give me right solution according to the question. Consider the…

A: Density is the mass per unit volume of any material substance. The amount of material, or small…

Q: 31 A sample of air analysed at 0°C and 1 atm pressure is reported to contain 0.02 ppm (parts per…

Q: 1.72-m in diameter and 6-m long weighs 3,046 N. How many cubic meters (m3) of metal weighing 102…

A: VOlume of total cylinderV=π41.722×6=13.9411m3Volume of cylinder inside the liquid is…

Question

100%

Fluid (3)

3.
Find the total weight of a 10 ft' tank of oxygen if the oxygen is pressurized to 500 psia, the tank itself
weighs 150 lbf, and the temperature is 70°F?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

9. What is the dissolved oxygen concentration in water at 10°C if it is only at 60% sat uration? Express your answer in mg/L.
Calculate dissolved oxygen concentrations at 0 and 25 degrees using Henry's formula.
What isthe weight of a 10ft cube tank of oxygen if the oxygen is pressured ti 400 psia, the tank itself weighs 100 lb/ft and the temperature is 70F
a) Calculate the partial pressure of oxygen in the air at 100 kPa if nitrogen has a partial pressure of 82 kPa and carbon dioxide and water combined have a partial pressure of 0.77 kPa. b) A container of compressed helium has in it 15.0 L pressurized to about 2250 kPa at 24.5°C. How many moles of helium are in the container? c) i) Determine the volume of oxygen gas required to completely combust 5.5 mol of propane (C3H8) in a barbecue at 101.3 kPa and 28.0°C. ii) What mass of helium would be required to fill a balloon to 6.8 L at 100 kPa and 25°C?
If 4.56 g of chlorine gas are contained in a 0.750 L container at 100 Celsius, what is the pressure in the container?
Solve the density of liquid ethanol at 180°C and 200 bar.
Copper tubing 0.500 in. in I.D. (inside diameter) is 13.0 ft long. What is the volume of the refrigerant contained in the tubing (in inches cubed)?
A balloon filled with hydrogen gas has a volume of 5200 cubic centimeters at 44 degrees Celsius and 9.0 x 104 Pa. What volume (in liters) does the H2 occupy at standard temperature and pressure(STP).
Question 2 Lauren has worker bullding her house on a hot summer day. She prepares a drink for them by adding a certain amount of ice at 0.0 °C to 1.8 kg of tea, initially at 80°C. How much ice in kilograms does she need to get the iced tea to be at final temperature of 10C? The heat of fusion of ice is 333 kJ/kg, specific heat of ice is 2100 J/kg. "Cand that of tea is 4186 Jkg. C 1.0 kg 15 kg O 12 kg
A mechanical device rests in a level position on two supports, each 42 in. high, at 60°F.The support at one end is gray cast iron; at the other end, structural steel. What is the greatest amount the device can be out of level due to differences in expansion if the temperature rises to 165°F?
Which has greater buoyancy of a pressure of 1000 hPa, an air parcel with a temperature of 350 K and a water vapor of 20 hPa, or an air parcel with a temperature of 310 K at a water vapor pressure of 50 hPa?
A nozzle is a device for increasing the velocity of a steadily flowing stream of fluid. At the inlet to a certain nozzle, the specific enthalpy of the fluid is 3320 kJ/kg and the velocity is 60 m/s. At the exit from the nozzle the specific enthalpy is 2530 kJ/kg. The nozzle is horizontal, and the heat supply, the heat loss, the work input, and the work output to or from the nozzle are all negligible. (a) Determine the velocity at the nozzle exit