Find the instantaneous value of alternating=10 sin(3 л×104 t) volt at i) Os ii) 50 µsvoltage uiii) 75 µs.

It is given that: v=10sin3π×104t volt

Answered: Find the instantaneous value of…

Engineering

Electrical Engineering

Find the instantaneous value of alternating voltage v = 10 sin(3 л×104 t) volt at i) 0 s ii) 50 µs iii) 75 µs.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8P: Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor...

See similar textbooks

Related questions

Q: A plot of H (e) is shown below. What is the value of when |H(e") |=0? O 3 O 3.176 O 2 |³H| 3.5 3 2.5…

A: In this question We need to choose the correct options What is frequency if magnitude of the H(ejw )…

Q: E www R₁ RT = 20 02 P=12W 01-1A and E = 20 V O₁1-0.5 A and E= 10 V O1=2A and E= 40 V O13 A and E= 60…

Q: Calculate the Velocity of Propagation of a signal if it has anInductance of 0.75mH/meter and…

A: In this question We need to determine the Velocity of Propagation of a signal. We know Velocity of…

Q: Use phasors and nodal analysis on the circuit below to find V1 and V2

A: Given:

Q: Question: Two parallel conductors, each of 0.6 m length, separated by 6 mm carry equal currents of…

A: Given two parallel conductors, Each of length, l = 0.6 m Separated by distance, d = 6 mm Carrying…

Q: -Find • Reg, Total Current (I); Current in every branch; Vab and Power Balance. (Using Reg Method)…

A: The required parameters can be calculated by using the resistance reduction techniques, voltage…

Q: given the following system of equations -9x-5y+z=14 4x-3z=27 7x-y+z=2 forming the augmented matrix…

A: Given that System of linear equations as follows. -9x-5y+z=14 4x-3z=27 7x-y+z=2

Q: a loss angle of Example 4.9 An 11 kV 50 Hz, single-phase cable has a diameter of 20 mm, and an…

A: It is given that: εr=2.4R=15r=10f=50 HzV=11 kVδ=0.031l=2.5 km

Q: Calculate the value of IH(w) for the following values of HdB. () If HdB=0.20 dB, then IH(w)| = (i)…

A: Here we have to calculate the Hw for the given HdB

Q: 15. In measurement of impulse voltage by using a resistance divider, its low voltage side is…

A: Given, Input impedance, Zin = 1 MΩ, and, Characteristic impedance, Zo=75Ω

Q: Q3) A Series DC Motor having a series field resistance of 0.25 ohm and an armature resistance of…

Q: In the below-given diagram, find the current through R₁ and R₂ resistance using KCL.

A: It is given that:

Q: QUESTION 1 Find all unknown currents and their directions in the circuit below 11 = 12 = 20 A 11…

Q: Problem 1 Find the input-output differential equation relating the input signal f(t) to the output…

A: We need to find out the differential equations for given circuit for input and output .

Q: Q2\ A continuous-time linear control system is described below, where u, x. and y are the input, the…

Q: Use Norton's theorem to find I, in the circuit below.

A: According to the question, for the given circuit as shown below We need to find the current I0 by…

Q: 2. Consider the interconnection shown in Fig. 2. a) What value of a is required to make this a valid…

A: Given data, Circuit diagram is given as,

Q: 2. List only one Euler's path for part (1) by drawing graphs for PUN and PDN.

A: Since you have posted the multiple questions so we are supposed to answer the 2nd one as you told.…

Q: Plot an Excel surface model of a Gaussian light intensity distribution at z = 539 mm, whereby the…

A: To plot an Excel surface model of a Gaussian light intensity distribution at z = 539 mm, whereby the…

Q: 2. Consider the circuit shown below. Assume the capacitor is initially uncharged, and the switch is…

Q: Find Rx for Wheatstone Bridge, if R1=400 and_R2=5 KQ and R3=2 KN, in case balance of whetstone…

A: It is given that: ∙R1=400 Ω,R2=5 kΩ and R3=2 kΩ∙R1=10 kΩ,R2=60 kΩ and R3=18.5 kΩ∙R1=1.25R2…

Q: Based on the given figure, a) what is the peak input voltage (V1) b) what is the peak output…

Q: The value of C, if the energy stored in the capacitor in the figure equals the energy stored in the…

A: Given circuit figure,

Q: The process of changing a half-wave or a full-wave rectified voltage to a constant dc voltage is…

Q: Question 1: Use Block Diagram Reduction Reduce the system shown in Figure to a single transfer…

A: In above block diagram we have to reduce it into the Transfer function T(S)=C(s)/R(s) . This we…

Q: Convert the following boolean expressions to their standard expanded form. Show all steps and…

A: In the given questions we need to find the standard expanded form of the given Boolean expression.

Q: 1. Determine the Fourier transform of the following signals: (a) f(t)= e (b) g(t)=t.e2¹.cos(5t) (c)…

A: NOTE: As per our guidelines we are supposed to answer first 3 sub-parts only. Kindly re-post other…

Q: . Which of the following statements are incorrect regarding power amplifiers? 1. Push-pull amplifier…

A: Given: Which of the following statements are incorrect regarding power amplifiers? 1. Push-pull…

Q: If the source voltage was increased to 24 Volts would Pdmax exceed 650mW

A: In this question We need to determine the power dissipate in the BJT. We know VCE sat = 0.2V

Q: Learning Goal: Consider the circuit in the diagram, containing two identical. resistors, RA and Rn,…

Q: R₁-50KQ Select one: 0 60 R:-10KQ The voltage gain of the above amplifier is:

Q: 5.32. (a) Find the drain current for the transistor in Fig. P5.32 if λ = 0. (b) Repeat if λ = 0.05…

Q: T(S) = K 52 52 tazunstw₁²

A: The expert who did the solution got the transfer function which of the first order of "s" but your…

Q: 11. Determine from microcells 1 and 2. the output expressions for X₁ and X₂ 4444 A*** B C D D…

A: We need to find out logical expression for given Boolean function.

Q: Find RTH with respect to terminals a and b. b 8Ω iT Figure 2: 3ix 252 m

A: Here the above circuit contains the dependent source so resistor reduction not possible then apply…

Q: i. ww ii. 8 Ω 21, I 15 92 ww 15 V 20 92 ww 10 22 ww 1292 10 V www 2 RL Figure #4 The magnitude of…

Q: •• A 200 N resistor, 0.900 H inductor, and 6.00 uF capacitor are connected in series across a…

Q: What is the maximum number of multiplexed channels that can be achieved in a TDM circuit if all of…

A: According to the question, for the given diagram of CD 4520 as shown below What is the maximum…

Q: A 1 meter long solenoid with 200 turns carries 2A of current Calculate the magnetic field on axis.

A: Given: Number of turns,N=200 Current,I =2A Solenoid of 1m long. Need to calculate magnetic field.

Q: In differential amplifier differential gain is 20000 and CMRR is 80 dB. Find common-mode gain? (take…

A: It is given that: Ad=20000CMRR=80 dB

Q: Vilt)u(t) R ееее L - transform to - Transfer function? TLS) s-domain? Vo(+) - combing right parallel…

Q: 9.26 For the differential amplifier of Fig. 9.15(a) let I = 0.2 mA, Vcc=VEE=1.5 V, VCM = -0.5 V,…

Q: Plot VR1 for the following Conditions: a. If VGG is set to 10% b. If VGG is set to 20% c. If VGG is…

A: Given data Vs, RMS=7.07 V VGG=9 V R1=1 kΩ The voltage across the resistance R1 is VR1. To find out…

Q: In the circuit below, the operational amplifier is ideal. If V₁ =10mV and V₂ = 50 mV, the output…

A: It is given that: V1=10 mVV2=50 mV

Q: 4. An ac amplifier has a mid-band voltage gain of 250 and the cutoff frequencies are f₁ = 30Hz.…

A: In this question We need to determine the gain at the cut off frequencies. Also find the upper cut…

Q: Two uniformly charged rods, rod 1 and rod 2, are placed as in the figure. Both rods are 40 cm long.…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Find IRMS of i₁ (t). Find V (i.e., the magnitude of v₂) such that the average power received by the…

A: In this question we need to find IRMS and Vm

Q: 2 (b) In the circuit below, we set a = (the figure is clearly not drawn to scale). Find the average…

Q: 2. Consider the interconnection shown in Fig. 2. a) What value of a is required to make this a valid…

Q: 2. In the following series circuit the voltage measured across the inductance was 16.8V, the voltage…

Question

Find the instantaneous value of alternating
=
10 sin(3 л×104 t) volt at i) Os ii) 50 µs
voltage u
iii) 75 µs.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: The given information is shown below:

VIEW

Step 2: Calculating instantaneous value of alternating voltage at t=0s:

VIEW

Step 3: Calculating instantaneous value of alternating voltage at t=50us:

VIEW

Step 4: Calculating instantaneous value of alternating voltage at t=75usec :

VIEW

Solution

VIEW

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. An alternating voltage is given by V=230sin314t.Calculate i)frequency,ii)maximum value,iii)average value,iv)RMS valuć
Solve for Vx and give the magnitude of Vx (in Volts). Let the source V = 88 20°V. 10 92 j4 92 m -j2.5 92 2V (Give answer in 2 decimal places. Unit is not required.)
11. For the circuit below, determine the voltages across each component. 1k 50 mH50 nF 1 sin2pi1000t 1 cos2pi1000t
With frequency f= 500 cycles/sec, what is the pure element in series with the R=25 ohms which causes the current to lags the voltage by 20 deg.? O 2.9 mH 35 microfarad O 29 mH 3.5 microfarad
An alternating current is given by i(t)=10sin 314t. The time taken to generate three cycles of current is _______. 0.02 second 0.06 second 0.03 second 0.04 second
Calculate the average power delivered by the source. 6Ω 30/0° V rms (t +-j2 2 4Ω Note: You are given the voltage source in RMS.
• If the AC voltage frequency is increased from 60HZ to 6 KHZ, what will be the effect on inductive reactance? Decrease by 1000 times Increase 1000 times Decrease by 600 times Increase 100 times 4
The complex expression of voltage is 300 cis 90 deg. What is the instantaneous equation.
9 ohms 12V 8ohms 16 V || 7.0hms 18 V 17.ohms 3 ohms
The frequency of this voltage source is V(mV) 238 136 34 I I 10 10 Hz 20 Hz 50 Hz 60 Hz 720 t(ms)
Activity 1: You are testing an electrical device which can be modelled by the figure shown below: 18 -j12 j6 8 -j10 i1 E1 12 13 E2 13 The above electric circuit can be characterized by the following equations: 1811 + j6(I1 – 2) + 4(I1 – I2) = 1020° -j121, + 8(12 – I3) + 20290° + 4(12 – 1) + j6(I2 – 1) = 0 -j1013 + 1313 – 20290° + 8(I3 - 12) = 0 1. Rearrange the above three equations. 2. Write the set of equations in matrix form (A.x = b) 3. Find the determinant of the resulted matrix (A).
Determine the average power supplied by the current source and the average power absorbed by each element in the following series, + 6/0°A 1 VT 3 202 j2Q2 252 -j1Ω