25.6Find the force on one face of a right triangle of sides 4m and altitude of 3m. Thealtitude is submerged vertically wit the 4m side in the surface."62.64 kN58.86 kNO 66.27 kN53.22 kNAccording to the Hooke's Law, the force required to stretch a helical spring isproportional to8cm. A force of 4kg will stretch it to a total length of 10cm. Find the work done ino thedistance stretched. The natural length of a given spring is

given data; side of triangle (a)=4maltitude of triangle(b)=3mwhen triangle submerged verticaly then…

Answered: Find the force on one face of a right…

Find the force on one face of a right triangle of sides 4m and altitude of 3m. The altitude is submerged vertically wit the 4m side in the surface." O 62.64 kN 58.86 kN O 66.27 kN O 53.22 kN

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.20P: Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of...

See similar textbooks

Similar questions

Use the following figure for both questions below. 1. The end of a tank containing water is vertical and has the shape of the bottom of a half circle of radius 10m. Determine the hydrostatic force against the end of the tank. 2. A milk truck carries milk with density 64.6lb/f in a horisontal cylindrical tank with diameter 6/t. F'ind the force exerted by the milk on one end of the tank when the tank is half full.
A barge pulled by a tugboat can be described as a rect- angular box that is open on the top. A certain barge is 30.2 feet wide and 12.50 feet high, with the base of each side being 116 feet long. If the barge itself weighs 6.58 x 10 pounds, what will be the draft (depth in the water) if the cargo weighs 1.12 × 10°pounds in (a) sea- water with a density of 1.025 g/mL and (b) freshwater with a density of 0.997 g/mL?
The topic is all about Total Hydrostatic Force on Curved Surface. Show complete solution and step-by-step solution. Use three decimal places Thank you. 1) Determine the magnitude of the horizontal and vertical components of the total force per meter length acting on the 3-meter radius three- quart er cylinder gate shown. 2m 2m 2m
Fluid mechanics В FB 1.8 m Water Gate A Hinge A 5.5-m-long (in directen normal to this page) quarter circular gate of radius l-8m is hinged at A as shown Frg ure · Neglecting the weight of the gate and the hinged, determine a) The magnitude and direction of the resultant force to the water. the "gate due on The horizontal force Fe that must be apphed în place to hold the gate the density of water to be 1000 kg/m³ and the gravita fronal constant to be - 9:9.81 m/s² Take
A cylinder weighing 445 N and having a diameter of 1 m floats in salt water (sp.gr. 1.03) vertically. It has an anchor tied to the cylinder, where the anchor rest at the bottom of the earth. The anchor weigh 23540 N/m3 and has a volume of 0.280 m3. What height “h” above the water surface will be required to lift the anchor off the bottom of the water when a high tide occur? The part of the cylinder is submerged 0.30 m below the salt water.
A triangular plate with base 6 m and height 2 m is submerged vertically in water such that the highest vertex of the plate is 6 meters below the surface and the base is horizontal to the surface. 6 m 6 m 2 m Express the hydrostatic force against one side of the plate as an integral and evaluate it. (Round your answer to the nearest whole number. Use 9.8 m/s2 for the acceleration due to gravity. Recall that the weight density of water is 1,000 kg/m3.)
4. A rectangular gate having a width of 1.5 m is located in sloping side of a tank as shown in fig. (2.4).The gate is hinged along its top edge and is held in position by the force (P). Friction at the hinge and the weight of the gate can be neglected Determine the required value of (P). 3 1 Hinga Cate 1.8 m 50" Figure (2.4)
A wooden barge of rectangular cross-section is 8 m wide, 4 m high, and 16 m long. It is transporting in seawater (s 1.03) a total load of 1,500 kN including its own weight and cargo. If a weight of 75 kN (Included in the 1,500-kN) is shifted a distance of 2.5 m to one side, it will cause the barge to go down 450 mm in the wdge of immersion and also rise 450 mm in the corresponding wedge of emersion The barge floats vertically (on an even keel) before the shifting of the weight. Compute how far above the waterline is the center of gravity of the loaded barge. W = 1500 kN 4, D D/2 BF 8 m 25m 60 kN/m 75 kN 1425 k 0.45 4 m Bo o BF 3.42 m
A tank is filled with fluid under prcssurc anti the prcssurc gauge fixcd at the top indicatcs a prcssurc of 21 kPa. The curved surfacc of the top is quarter of a circular part of radius 2.6 m. calculate the magnitude (N) and direction (degree) of the resultant force on the cun'ed surface. (p=950kg./m³for fluid)
Please be xlear and detailed with your answer. Write an explanation in every formula and solution you used. Problem: A Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the vertical with vertex pointing upward The base of the gate is 2 70 m below the surface of oil s 0 80 What normal force must be applied at the vertex of the gate to open it? Show figure
+ 141% - 98 / 865 THIS TOICE cS OWwu, uougn e ceo or me paraone secuon, or a ustance 3x/8 force on the dam is 3.75 ft over from the origin, as shown in Figs. E2.8b,c. The resultant hydrostatic F= (Fi+ F = [(899E3 lbf) + (499E3 Ibf)2 1028 x 10' lbf at 29 Ans. %3D This resultant is shown in Fig. E2.8c and passes through a point 8 ft up and 3.75 ft over from the origin. It strikes the dam at a point 5.43 ft over and 7.07 ft up, as shown. • Commenis: Note that entirely different formulas are used to calculate Fy and Fy. The concept of center of pressure CP is, in the writer's opinion, stretched too far when applied to curved surfaces. Resultant = 1028 x 10' Ibf acts along z = 10.083 – 0.5555x 3.75 ft Fy 499 x 10 Ibf F=899 x 10' Ibf Parabola z = 0.24x? 29 7.07 ft 8 ft 5.43 ft E2.8c pile How these values come ?
H.W: A hypodermic syringe contains a medicine with the density of water. The barrel of the syringe has a cross-sectional area (2.50x10-5) m2, and the needle has a cross-sectional area (1.00x10 8 ) m². In the absence of a force on the plunger, the pressure everywhere is 1.00 atm. A force F of magnitude 2.00 N acts on the plunger, making medicine squirt horizontally from the needle. Determine the speed of the medicine as it leaves the needles tip.