Figure P24.54 shows a cylindrical Gaussian surface endosing a segment of a long charged wire Consider using a spheri- cal Gaussian surface to enclose the same segment of the wire. (a) Which surface, cylindrical or spherical, has the greater elec- tric flux through it? (6) Which surface is more appropriate for calculating the electric flux? Justify your answer. B

Figure P24.54 shows a cylindrical Gaussian surface endosing a segment of a long charged wire Consider using a spheri- cal Gaussian surface to enclose the same segment of the wire. (a) Which surface, cylindrical or spherical, has the greater elec- tric flux through it? (6) Which surface is more appropriate for calculating the electric flux? Justify your answer. B

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter24: Electric Fields

Section: Chapter Questions

Problem 61PQ: A total charge Q is distributed uniformly on a metal ring of radius R. a. What is the magnitude of...

See similar textbooks

Similar questions

A particle with charge Qis located a smalt dis- tance δ immediately above he center of the flat face of a hei sphere of radis R as shown in Figure P24.21 What is the electric flux (a) through the curved surface and (b) through the flat face as δ-* 0? Figure P24.21
54.A solid, insulating sphere of radius a has a uniform GP charge density throuhu ts volume and a total charge QConcentric with this sphere is ucharged. con- ducting, hollow sphere whose inner and outer radii are band cas shown in Figure P24.54 (page 744). We wish to understand completely the charges and electric fields at all locations. (a) Find the charge contained within a sphere of radius r< a(From his value, find the mag nitude of the electric field for r< a. (c) what charge is contained witi a sphere of radius r when a (d) From this value, find the magnitude of the elec- tric field for rwhena
Fostro Imssb1.mutah.edu.jo/me An infinite line carries a linear uniform charge density of 19.6 nC/m). Determine the magnitude of the electric field ( in units of kN/C) at a distance of 5.0 cm from the line.
A flat square sheet of thin aluminum foil, 25.0 cm on a side, carries 275 nC of charge,which is uniformly distributed across the sheet. a) How strong, approximately, is theelectric field 0.100 cm above the center of the sheet?b) What is the electric flux through a sphere of radius 15.0 m centered on the sheet?c) How strong, approximately, is the electric field 150 m above the center of the sheet?
A flat square sheet of thin aluminum foil, 40 cm on a side, carries a uniformly distributed 355 nC charge. What, approximately, is the electric field 1.0 cm above the center of the sheet?Express your answer using two significant figures.
A В R /D Sections AB and CD of a thin non-conducting ring of radius R are uniformly (with constant linear density) charged with charge + q and -q, respectively. The points ABCD form the vertices of the square. Find the electric field in the center of the ring.
c) (a) Using Gauss's law calculate the electric field above a charged conductor. The system is shown in the figure below. Present the results in terms of surface charge density o. 17 E (b) A thin square (thickness<
A point charge Qs located on the axis ofa disk of radius Rat a distance & from the plane of the disk (Fig. P24.68). Show that if one fourth of the electric flux from the charge passes through the disk, then R= v36.
The electric field on the axis of a uniformly charged ring has magnitude 400 kN/C at a point 6 cm from the ring center. The magnitude 15 cm from the center is 125 kN/C; in both cases the field points away from the ring. a. Find the rings radius b. find the rings charge
A rod of length L lies along the x-axis with its left end at the origin. The rod has a non-uniform charge density λ = ax, where a is a positive constant. P (a) Express the total charge Q on the rod in terms of a and L. (b) Calculate the electric field at point P, shown in the Figure. Take the limit d » L. What does the electric field look like in this limit? Is this what you expect? Explain. Hint: the following integral may be useful: x dx (x+a)² In(1+x)=x- a -+ln(x + a) X x + a +² 2 +... (for small .x)
esc A uniformly charged insulating rod of length 11.0 cm is bent into the shape of a semicircle as shown in the figure below. The rod has a total charge of -7.50 μC. ( .0 (a) Find the magnitude of the electric field (in N/C) at O, the center of the semicircle. 3505.08 X N/C (b) Find the direction of the electric field at O, the center of the semicircle. to the left O to the right Oupward Odownward Ointo the page out of the page X (c) What if? What would be the magnitude of the electric field (in N/C) at O if the top half of the semicircle carried a total charge of -7.50 μC and the bottom half, insulated from the top half, carried a total charge of +7.50 μC? 7010.165 XN/C ( (d) What would be the direction of the electric field at O if the top half of the semicircle carried a total charge of -7.50 μC and the bottom half, insulated from the top half, carried a total charge of +7.50 μC? to the left. to the right Oupward o downward into the page 1 20 F3 888 F4 1 F5 MacBook Air F6 F7 DII FB…
+Q dQ Consider a thin plastic rod bent into a semicircular arc of radius R. with center at the origin as shown in the figure. The rod carries a unformly distributed positive charge +Q. Let a point on the arc be specified by an angle 0, where 0 is measured from the positive y axis and increases in the counter-clockwise direction. Throughout this problem, use for Coulomb's constant. Determine the electric field dat the origin due to the indicated infinitesimal piece of the rod at an angle 0, that subtends an angle A0. Express your answer in terms of 0, A0, R. Q and fundamental constants. dB₂ (Q*k*Deltatheta)/(R^2 *theta) X Q.k. AO R².0 dEy= de 0 (Q*k*Deltatheta)/(cos(theta) X Q.k. A0 cos (0) R² dE, - 0