F2-10. Determine the magnitude of the resultant force of the water acting on the triangular end plate A of the trough. Neglect the width of the opening at the top. How far does this force act from the surface of the water? 12 m 0.3 m 03 m

F2-10. Determine the magnitude of the resultant force of the water acting on the triangular end plate A of the trough. Neglect the width of the opening at the top. How far does this force act from the surface of the water? 12 m 0.3 m 03 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.114P: Determine the resultant force acting on the elbow of the thin-walled pipe when the pipe carries a...

See similar textbooks

Related questions

Q: Figure 1.84 shows an air spring. This type of spring is generally used for obtaining very low natura...

A: Initial condition is denoted as 1 and final condition is denoted as 2. The process 1-2 is an adiabat...

Q: A driver is traveling in a curved section of a roadway with a radius of 100m. The driver is travelin...

A: To obtain the tangential acceleration of the car , first angular acceleration must be determined usi...

Q: Example 1.1 Figure 1.5 shows the block diagram of a closed-loop flow control system. Identify the fo...

A: Showing the requirement of elements of closed loop.

Q: 5-86. Operation of exhaust and intake valves in an automobile engine consists of the cam C, push rod...

A: Given Data The copression of the spring is: 20 mm=0.02 m The stiffness is: 300 N/m To Determine T...

Q: Question: A particle P moves along the spiral path r=(10/θ)ft, where θ is in radians. Part C: ...

Q: Q10. The platform is rotating about the vertical axis such that at any instant its angular position ...

A: Find magnitude of acceleration of ball at time(t) =2 seconds

Q: calculate the power (kW) delivered by the pump

A: Need to calculate the power.

Q: An insulated rigid tank contains 5kg of air (an ideal gas) at 25C and 100kPa. A paddle wheel inside ...

Q: 7.5 ft A. Smooth wall 15 ft 9 ft

Q: A certain streched wire 120 cm long and 2.4 mm in diameter is fastened to a point in the ceiling. An...

Q: Cable AB exerts force د. ارشد ناظم شتر a of 80 N on the end of the 3-m long boom. Determine Fr ,Fg a...

A: Given data F=80 N Need to determine the x, y and z component of the resultant.

Q: Block 2 slides outward on link 1 at a uniform velocity of 6 m/s as shown in the figure. Link 1 is ro...

Q: 1B. Derive from first principles the moment of inertia for a right-angled triangle about its base an...

A: Consider a right-angle triangle with base b and height h as shown below,

Q: luid Mechanics A solid spherical ball has a radius of 50 cm and total mass of 400 kg. If it’s drop f...

A: To obtain the time for the ball to reach the ground in the lake, we must first calculate the acceler...

Q: -800 Dimensions in mm F1 600 F2 F3 900 -560--480- What is the x component of F1=701 N?

Q: 0 lb

Q: Two geometrically similar pumps are running at the speed of 1500rpm and 3000rpm. One pump has an imp...

Q: on steel 1.5mm fective resistanc 1eו והה )

Q: S moidpnl L69GION BL 7.5 ft Smooth wall 15 ft

Q: Problem 2: The slotted bar shown below is pinned at O. It has a constant angular velocity of 0 = 3 r...

Q: TOOL USE TO CUT WIRES?

A: Given Wires To find Tool to cut wires

Q: r surfaces is 22

Q: kes a surface which lux as measured indir

Q: 00 m/s w ne inlet is

Q: What type of drawing is shown (the bottom of the object is horizontal, all lines going towards the b...

A: LETS define each one of them ISOMETRIC DRAWING: Isometric drawing is just a 2D representation of a...

Q: system of blocks is pulled by a force P. The string connecting blocks A and B passes over a pulley w...

A: The ratio of tensions on the ropes of the pulley is related by the formula given below as- T1T2=eμθ ...

Q: 4. A submersible pump delivers 350 gpm of water to a height of 5 ft from the ground. The pump was in...

Q: Determine when a pitot tube should be used. 2. The Importance of Measurement of Airspeed in the fiel...

A: 1. Pitot tube should be used when The static pressure is to be determined Total impact pressure i...

Q: A thin rectangular plate is uniformly deformed as shown. Determine the total shear strain

Q: 1.7 A 90 N rectangular solid block slides down a 30° inclined plane. The plane is lubricated by a 3 ...

Q: F4 The tube is filled with mercury from A to B. and with water from B to C. Determine the height h o...

A: Given: The liquids used in tube are water and mercury.

Q: In Fig. 1.69, find the equivalent spring constant of the system in the direction of 6. 1.9 ki k2 000...

Q: A pump draws water from an 8 in. suction pipe and discharges through a 6 in. pipe in which the veloc...

Q: ᴛʜᴇ ᴘᴜᴍᴘ ɪꜱ ᴅᴇʟɪᴠᴇʀɪɴɢ ʜʏᴅʀᴀᴜʟɪᴄ ᴏɪʟ ᴡɪᴛʜ ᴀ ꜱᴘᴇᴄɪꜰɪᴄ ɢʀᴀᴠɪᴛʏ ᴏꜰ 0.85 ᴀᴛ ᴀ ʀᴀᴛᴇ ᴏꜰ 75 ʟ/ᴍɪɴ ᴛᴏ ᴀ ᴛᴀɴᴋ...

A: Calculated the power delivered by the pump in kW.

Q: 1. Assuming F is 90lb, coefficient of static friction: =0.2, and the coefficient of kinetic friction...

A: we have to determine the distance travelled by the box along the plane

Q: If F = 180 N, determine the magnitude and coordinate direction angles of the couple moment. Note: Th...

Q: Q13. The collars are pin connected at B and are free to move along rod OA and the [C· (1+ cos 0)] m,...

Q: 5. Water from a reservoir A 10 m elevation is drawn by a motor driven pump to an upper reservoir B a...

Q: 1.26 Find the equivalent spring constant of the system shown in Fig. 1.82.

Q: An aircraft is flying at an altitude where the pressure ratio is O.25. Assume standard sea level con...

A: Given data: Pressure ratioPP0=0.25 Need to determine the altitude of the flying aircraft.

Q: Redondee sus respuestas al entero mas cercano ej.: 24 MPa, 6 -12 MPa. 20 KN 12 KN-m B.B 4 m 380 mm 2...

Q: ntained at 25°C DBT with 55% RH. The RSHL=150 kW and RLHL = 122 kW. The discharge fro

Q: on is given

Q: A clown juggle balls while doing other activities. In one act, she throws a ball vertically upward, ...

A: Given Data The distance of the table is: l=5.5 m The constant speed is: v=2.5 m/s To Determine The...

Q: In the figure shown below, set F1 710 lb, F2 = 120 lb, F3 = 320 lb, the shaft diameter to 0.5 in, th...

A: Given: The force along the x-axis, F1 = 710 lb The force along the y-axis, F2 = 120 lb The force a...

Q: A football is kicked off 40° above the ground with initial velocity of 40 m/s. If the ball landed on...

A: Given data: v=40 m/sθ=40° Need to determine the horizontal distance (range) covered by the football....

Q: Draw the shear and bending moment diagrams for the beam and loading shown 3 kN 3 kN 450 N- m B 300 2...

Q: expansion

Q: Q3: As shown in figure, find that at what distance body A will attain a velocity of 3 m/s from 2000 ...

A: To obtain the solution to the given question, we must the three statics equations which are- 1. The ...

Q: Water flows thru the entrance section of the pipe whose pressure is 280 kPa and is 4.5 m above the d...

A: Given: The pressure and datum of entrance section of pipe is P1=280 kPa and z1=4.5 m respectively. ...

Concept explainers

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.

Question

F2-10. Determine the magnitude of the resultant force of
the water acting on the triangular end plate A of the trough.
Neglect the width of the opening at the top. How far does
this force act from the surface of the water?
12 m
03 mX
0.3 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the resultant force acting on the 0.7-m-highand 0.7-m-wide triangular gate and itsline of action.
F2-14. Determine the resultant force the oil exerts on the semicircular surface AB. The tank has a width of 3 m. Take P. 00 kg/m. 15m
2-50. The uniform rectangular relief gate AB has a weight of 8000 lb and a width of 4 ft. Determine the minimum depth h of water within the container needed to open it. The gate is pinned at B and rests on a rubber seal at A. h 6 ft 30
The storage tank contains oil and water at the depths shown in Figure below. Determine the resultant force that both of these liquids together exert on the side ABC of the tank if the side has a width of b = 1. 25 m. Also, determine the location of this resultant, measured from the top of the tank. Take po = 900 kg/m³ , Pw = 1000 kg/m³ 0.75 m 15 m
Determine the resultant force USING GENERAL SOLUTION of the oil exerts on the semicircular surface AB.The tank has a width of 3 m. Take liquid density as 900 kg/m3.*USE GENERAL SOLUTION AND SHOW PRESSURE DIAGRAM
If the wall is 3.5 m, determine an show the resultant force that water exert on the overhang sea wall along ABC, as shown in Figure (1). 1.5 m Figure (1) 2 m 2.5 m
The tank shown is filled with oil to a depth of d=6 m. Determine the resultant force the oil exerts on the bottom of the tank if the density of the oil is 900 kg/m³. Sides A and B face the viewer. 3 4 m . 3 m A B d 649.6 kN O 767.3 kN 589.5 kN 581.4 kN O 635.7 kN
The semicircular drainage pipe is filled with water. Determine the resultant horizontal and vertical force components that the water exerts on the side AB of the pipe per foot of pipe length; w(water) = 9.81 lb/ft3. Take r =2m Determine the resultant vertical component of force that the water exerts on the side AB of the pipe per foot of pipe length. Determine the resultant horizontal component of force that the water exerts on the side AB of the pipe per foot of pipe length. Thank you!
The tank is fined with water. Determine the resultant force acting on the triangular plate A and the location of the center of pressure. Measured from the top of the tank. Solve the problem using the formula method
Determine the resultant force acting on the face of the sign if qh = 25.5 lb/ft 2 . The sign has a width of 32 ft and a height of 8 ft as indicated.
The tank shown is filled with water to a depth of d=6 m. Determine the resultant force the water exerts on side A of the tank if the density of water is 1000 kg/m³. Sides A and B face the viewer. 4 m 3 m A B d 706.3 kN 698.2 kN 763.1 kN 582.4 kN O 389.2 kN
The concrete gravity dam is held in place by its own weight. If the density of concrete is 2.5 Mg/m3, and water has a density of 1.0 Mg/m³, determine the magnitude of the total resultant force the water exerts on the dam. The width of the dam is 10 m, and d=3 m. F m- 6 m -d – 1–| 1861 kN 1789 kN 1776 kN 1941 kN 1960 kN