Tirofiban (C22H36N2O5S MWt = 440.6) is present as tirofiban HCI monohydrate(C22H36N2O5S.HCI.H₂O MWt=495.1) at 0.281 mg/mL in a concentrated solution.A solution for infusion is prepared by extracting 50 mL from a 250 mL bag of 5% glucose solutionand adding 50 mL of concentrated solution.Sofia who weighs weighs 87 kg requires a tirofiban dose of 0.1 mcg/kg/min for 12 to 24 hours.What would the infusion rate be (mL/h)? (Answer to 1 decimal place.)Answer: 125.28 X

Given: Drug is Tirofiban Concentration is 0.281 mg/ml Weight of patient is 87 Kg The ordered drug…

Answered: epared by extracting entrated solution.

Science

Chemistry

epared by extracting entrated solution.

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.107E

See similar textbooks

Related questions

Q: Propose a mechanism for the following transformation when an ethyl magnesium bromide in excess was…

Q: Show reagents and conditions you would use to convert aniline to the following aromatic compounds.…

Q: Radioactive emissions known as alpha, beta, and gamma are referred to as "ionizing radiation." This…

A: 1 ) We need to tell the correct statement for the term ionizing radiation

Q: The reaction of 50 mL of N₂ gas with 150 mL of H₂ gas to form ammonia via the equation: N₂ (g) +…

A: According to Avogadro's law ,at constant temperature and pressure , equal volume of different gases…

Q: Express Ksp in terms of molar solubility, x, for the salts with the given formulas.

Q: The first method is through a pH strip. To estimate the pH of the sample, Tricia used a pH strip.…

A: In pH strip method, 1 mL of the sample has a pH of 3.3 . Then 1 mL of the same sample was diluted…

Q: 3AgN03+FeCI3 3AgCI+Fe(NO3)3 25.0g of silver nitrate reacted with 45.0g of iron (lll) chloride. what…

Q: A dosage descibes the amount of medication administered over a specified period of time with a…

A: 1. Total amount of dosage for 61.0 lb child = 24.5 mg/kg/day x 61.0 lbs x 1 kg/2.2 lbs…

Q: A sample of aluminum metal absorbs 9.86 J of heat, upon which the temperature of the sample…

Q: Write down the condensed molecular formula, line and angle structure and full 3-D structures for…

A: Condensed formula: In this, a molecule is the formula where the symbols of atoms are listed in order…

Q: НС. енз CH -CH=CH₂₁₂ Bral сам (Bromination) Вр енз CH HC - CH - Bo Dehalogenation 11 CE CH сн ·CH· -…

Q: Which of the following would you expect to react positively with Baeyer's test? Toluene Propyne…

A: Baeyers test is used to detect the presence of double bond in a given compound. Alkaline KMnO4 upon…

Q: Phosphorous acid, H₂PO₂ (aq), is a diprotic oxyacid that is an important compound in industry and…

Q: Part B Enter a balanced equation for the reaction of NaCH3COO (also written as NaC₂H₂O2) and HCL…

Q: if the [OH-] is 1.45x10 to the power -10 what is the pH?

Q: 88. 2 g m 2 0 kg m 2 = ? - 2 S

Q: Indicate whether the statement below is true or false. The sum of the oxidation numbers in…

Q: reaction Mg(s) + Cl₂(g) → MgCl₂ (s) CH4 (8) +20₂ (8) CO₂(g) + 2H₂O(g) K Br(aq) + AgNO3(aq) →…

A: In that particular reaction , Mg combines with two Cl atom and form MgCl2. So,it is combination…

Q: (Q98) Electrolysis is being used to plate chromium onto a large plastic surface. If a total of 3.77…

A: Given, mass of Chromium (Cr) = 3.77 g Current (I) = ? Time (t) = ? min Note: molar mass of Cr = 52.0…

Q: Given data for electrolysis of Gd ions: mmol of Gd metal = 25 current: 1.0 Ampere t = 120 minutes…

Q: The Ksp of zinc carbonate, ZnCO3, is 1.46 × 10-¹0. Calculate the molar solubility, S, of this…

Q: phHệ CH 3 سار اي منهم مفقل الے۔ ph left (H3 ciz right CH₂ OM OH ؟ ko

A: The acidic strength depends upon the stability of conjugate base.Stable the conjugate base more will…

Q: Ksp =

Q: in a 63.17 gram sample of sulfur trioxide, how much of it is sulfur?

A: The correct answer is given below

Q: When mixing 0.322 mol of substance X(g) with 0.353 mol of substance Y(g) in a 1.0 L container, it…

A: Which one of the following is correct

Q: A balloon can hold 10 liters of a gas. If you blow up this balloon with 2 moles of oxygen gas at a…

Q: Indicate whether the statement below is true or false. All batteries are Galvanic cells. Truc O…

A: Generally batteries will give electrical energy from chemical energy Batteries are of two types 1,…

Q: you have 3.25 kg of water. How many moles of water do you have? the molar mass of water is 18.02…

Q: 1. What is the oxidation number of S in each of the following substances? • H₂S SO3 H₂SO4 • SO₂ • ●…

A: Since you have asked multiple type questions, we will solve only first questions for you. If you…

Q: Which of the following is expected to form an ideal solution?

Q: A chemist prepares a solution of copper(II) sulfate (CuSO4) by measuring out 12. g of copper(II)…

Q: Calculate the hardness of water in terms of ppm CaCo3, V used, M EDTA, and Average M EDTA, Ave. ppm…

A: Ca2+ of the CaCO3 reacts with EDTA to form M-EDTA complex.. Mass of CaCO3=0.3889g Molar mass of…

Q: 1. Provide a systematic name for each molecule represented below and a structure for the one name.…

A: The names of asked molecules are as below ? 1) 6-ethyl-2,5-dimethyl-7-propylundecane 2)…

Q: Sodium sulfate is slowly added to a solution containing 0.0500 M Ca²+ (aq) and 0.0300 M Ag+ (aq).…

Q: In the reaction above, calcium hydroxide and hydrogen sulfide react to form calcium sulfide and…

Q: Epoxides are stabilized by its cyclic structure. True or False

A: Answer = False Epoxides are stabilized by its cyclic structure[ False] statement

Q: What is the IUPAC name of the ether that has the structure shown? -O-CH3

A: We have to predict the iupac nomenclature of given structure.

Q: need chemoselectivity. Under this 1. The relative reactivity of two different functional groups,…

Q: What is the volume in liters of 13.7 mol of krypton gas at STP?

A: We have to calculate the volume in liters of 13.7 mol of krypton gas at STP

Q: 1. Given that the electrochemical cell L gives a potential of 0.0570 V, determine the concentration…

A: Introduction: In the case of concentration cells, the concentration of a soluble component in both…

Q: a good leaving group such as iodide. .CO₂H base НО 15 17 co Mecarmis SN2 ميكا تكيه ها التفاعل + TM3…

Q: Carbon disulfide is prepared by heating sulfur and charcoal. The chemical equation is…

A: The reaction is ; S2(g) + C(s) = CS2 (g) Since the concentration of C is very large it can be…

Q: The arrow points to a particular carbon atom that carries an H atom or group of H atoms. This/these…

A: In this question, we will see that appearing of hydrogens in proton NMR spectra as a singlet,…

Q: thermometer insulated. container A sample of brass, which has a specific heat capacity of 0.375…

Q: The reaction of 50 mL of N2 gas with 150 mL of H2 gas to form ammonia via the equation:…

Q: A 6.00 1. tank at 1.5 "C is filled with 16.8 g of carbon dioxide gas and 10.6 g of dinitrogen…

A: Given-> Weight of CO2 = 16.8 gm Weight of N2O = 10.6 gm

Q: A chemistry student needs to standardize a fresh solution of sodium hydroxide. He carefully weighs…

A: Molarity of a solution =Number of moles of soluteVolume of solution in LNaOH + H2C2O4 →Na2C2O4 + 2…

Q: Present 5 chemical reactions involved in biological and industrial processes affecting life and the…

A: Answer - Present 5 chemical reactions involved in biological and industrial processes affecting life…

Q: A 250 mL beaker is filled with 100 mL of a 0.30 M solution of acetic acid (CH3COOH) and 150 mL of a…

A: Acetic acid is a weak acid , so it do not dissociate completely into its ions. NaOH is a strong base…

Q: A sample of He gas (3.0 L) at 5.6 atm and 25 °C was combined with 4.5 L of Ne gas at 3.6 atm and 25…

A: In this question first to find the total number of mole of gases then using the ideal gas equation…

Question

Tirofiban (C22H36N2O5S MWt = 440.6) is present as tirofiban HCI monohydrate
(C22H36N2O5S.HCI.H₂O MWt=495.1) at 0.281 mg/mL in a concentrated solution.
A solution for infusion is prepared by extracting 50 mL from a 250 mL bag of 5% glucose solution
and adding 50 mL of concentrated solution.
Sofia who weighs weighs 87 kg requires a tirofiban dose of 0.1 mcg/kg/min for 12 to 24 hours.
What would the infusion rate be (mL/h)? (Answer to 1 decimal place.)
Answer: 125.28 X

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A solution is made by dissolving 0.455 g of PbBr2 in 100 g of H2O at 50C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray contrast agent that aids with the radiologic imaging of the anatomy. One such contrast agent is sodium diatrizoate, a nonvolatile water-soluble compound. A 0.378-m solution is prepared by dissolving 38.4 g sodium diatrizoate (NaDTZ) in.l.60 102 mL water at 3 1.2C (the density of water at 31.2C is 0.995 g/cm3). What is the molar mass of sodium diatrizoate? What is the vapor pressure of this solution if the vapor pressure of pure water at 31.2C is 34.1 torr?
The dispersed phase of a certain colloidal dispersion consists of spheres of diameter 1.0 102 nm. (a) What are the volume (V=43r2) and surface area (A = r2) of each sphere? (b) How many spheres are required to give a total volume of 1.0 cm3? What is the total surface area of these spheres in square meters?
Which solute has the greatest effect on the boiling pointof 1.00 kg of water: 50.0 g of strontium chloride (SrCl2) or 150.0 g of carbon tetrachloride (CCl4) ? Justify youranswer.
A compound has a solubility in water of 250 mg/L at 25C. Should this compound be characterized as a soluble or insoluble compound at 25C?
6-35 Describe how we would prepare the following solutions: (a) 280. mL of a 27% v/v solution of ethanol C2H6O, in water (b) 435 mL of a 1.8% v/v solution of ethyl acetate, C4H8O2 in water (c) 1.65 L of an 8.00% v/v solution of benzene C6H6, in chloroform, CHCI3
Dimethylglyoxime [DMG, (CH3CNOH)2] is used as a reagent to precipitate nickel ion. Assume that 53.0 g of DMC has been dissolved in 525 g of ethanol (C2H5OH). s The red, insoluble compound formed between nickel(II)ion and dimethylglyoxime (DMG) is precipitated when DMG is added to a bask solution of Ni2+ (aq). (a) What is the mole fraction of DMG? (b) What is the molality of the solution? (c) What is the vapor pressure of the ethanol over the solution at ethanols normal boiling point of 78.4 C? (d) What is the boiling point of the solution? (DMG does not produce ions in solution.) (Kbp for ethanol = +1.22 C/m)
A gaseous solute dissolves in water. The solution process has H=15 kJ. Its solubility at 22C and 6.00 atm is 0.0300 M. Would you expect the solubility to be greater or less at (a) 22C and 1 atm? (a) 18C and 6 atm? (a) 15C and 10 atm? (a) 35C and 3 atm?
ow do the properties of a nonhomogeneous (heterogeneous) mixture differ from those of a solution? Give two examples of nonhomogeneous mixtures.