please solve asap Problem 1. The resistivity of aluminum at 25°C has been measured to be 2.72 x 10-6 0 cm. Aluminumhas a valency of 3, a density of 2.70 %and an atomic mass of 27 g.ст3(a) Estimate their drift mobility,(b) Estimate the mean free time between collisions for the conduction electrons in aluminum at 25 °C,(make sure that the units in your calculation are correct and consistent)(c) If the mean speed of the conduction electrons is about 2 x 106 m/sec , calculate the mean freepath.

Answered: Image /qna-images/answer/743ef1e6-3a2c-4bac-b26b-92b609952024.jpg

Answered: Problem 1. The resistivity of aluminum…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter1: Atomic Structure

Section: Chapter Questions

Problem 6RQ: How many valence electrons are generally contained in materials used for insulators?

See similar textbooks

Similar questions

?Which one of the following statement(s) is false A substitution impurity in donor and acceptor atoms does not cause any disturbances in the crystal lattice of semiconducting material. In an n-type semiconductor, the free electrons concentration approximately equals the density of donor atoms Each donor atom contributes two free electrons to semiconducting crystal lattice. Mobility of charge carriers equals its average speed v divided by the applied electric field E.
2. When a current of 1A flows through a wire, the drift velocity of the electrons is 0.9 mm/s. What will be the drift velocity of the electrons when a 2A current flows through another wire of the same material having double the length and double the area of cross section and same temperature.
Electronics Physics -HW2 Q1. In a P-type germanium, ni = 2×10" electrons/m and the density of boron 4x1023 atoms/m'. The electrons and holes mobility are (0.4 and 0.2 m2/ V. s) respectively. What is its conductivity before and after addition of boron atoms? Note: For after addition of boron atoms you need to compare the actual and approximate conductivity ملاحظة: بعد اضافة ذرات البورون يكون حساب التوصيليه بالاستخدام التقريب وبدون استخدام التقريب والمقارنة بين النتانج
ähäi 15 Find the concentration of electrons & holes in (a) N-type Si at 300K, if the conductivity is 300(0.cm)^-1. (b) Also find these values for P-type Si. Given ni=1.5x10^12 /Cm^3, un-1200 *.Cm2/V.sec & pp3400Cm^2/V.sec
7. Each of three insulators forming a string has self-capacitance of "C farad. The shunt capacitance of each cap of insulator is 0-25 C to earth and 0-15 C to line. Calculate the voltage distribution across each insulator as a pecentage of line voltage to earth and the string efficiency. [31-7%, 29-4%, 38-9%; 85-7%]
15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between conduction band and valance band b. A semi-conductor material does not allow the flow of electrons at all time. c. A good insulator material has 8 valance electrons d. A good conductor material has 3 valance electrons.
A copper wire has a diameter of 2.05 mm and carries a current of 15 A due solely toelectrons. (These values are common in residential wiring.) Each electron has a charge of -1.60 x 10-19 C. Assume that the free-electron (these are the electrons capable of movingthrough the copper) concentration in copper is 1029 electrons/m³. Find the average velocity ofthe electrons in the wire.
A typical Cu wire might have 2 X 1021 free electrons in 1 cm of its length. Suppose that the drift velocity of the electrons along the wire is 0.05 cm/s. (A) How many electrons would pass through a given cross section of the wire each second? (B) How large a current would be flowing in the wire? outz mduz to elob beluberlba ol uoy wollo liw ainf.nokaimdu2 to etob beluberoz edt elin M? niy ina lona
Assume that the conductivity of a pure semiconductor at an applied electric field of 450 mV/m is 2.75 X 1013/2-cm. Given that the drift velocity of electrons is 0.135 m/s and that of holes is 0.048 m/s, determine the density of the charge carriers per cubic meter in this material.
specimen of slconis -2mm 2ong und has ucress the bar resuit s in Curvent F 8mA IP mob,lit is 1300 cm2/v.Sec find 1- Concentra tien of Free electrons. Drift velocity.
Find the hall coefficient of a silicon material used in a Hall generator with a gap distance is 2.0 cm. When a current of 300 A flows, the hall voltage is recorded as 10 V and a magnetic flux density of 0.2 T is produced. Lütfen birini seçin: a. 0.0461 b. 0.0074 c. 0.0695 d. 3.3333 e. 0.0033
1. A Germanium sample is 5 mm long and has a rectangular cross-section, 50 μm by 150 μm. A Phosphorus atom with concentration of 4.4 x 10¹5/cm³ at 300 K is added and corresponds to one impurity atom for 107 Ge atoms. A steady current of 3 juA exists in the bar. a. Set up the equations for concentrations, conductivity, resistance, and voltage. b. Solve for the electron and hole concentration, conductivity, resistance, and voltage. 2. A basic junction diode is operating at a room temperature of 25°C and has a reverse current of 1 nA. a. Set up the different diode equations. b. Solve for the diode current at room temperature, reverse current, and threshold voltage when the temperature becomes 72°C.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS