Eight (8) kg of 20 °C air is compressed from 95 kPa to 628 kPa. The inlet air has relative humidity of 80%. Compression is according to the law PV1.3 = Costant. After compression, the air is cooled again to the inlet temperature. Determine the partial pressure due to air at he inlet, Pal = kPa.

Eight (8) kg of 20 °C air is compressed from 95 kPa to 628 kPa. The inlet air has relative humidity of 80%. Compression is according to the law PV1.3 = Costant. After compression, the air is cooled again to the inlet temperature. Determine the partial pressure due to air at he inlet, Pal = kPa.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: dy² Pg , where g is the acceleration due to gravity μ

Q: A gas tungsten arc welding operation is performed using a current 650 A and arc voltage of 10 V at a…

Q: 2. If the beam is subjected to a bending moment of M = 50 kN m, sketch the bending stress…

Q: A sign advertising the headquarters of a certain orga by a cable strung over a horizontal beam, as…

Q: 13. For Problems 1 to 3. Three forces were applied to the horizontal beam of negligible mass, as…

Q: Q4. Electric heater wires are installed in a solid wall having a thickness of 8 cm and k=2.5W/m. Cº.…

Q: A Kaplan turbine works under a head of 10 m. The design speed is 50 rpm and turbine develops 40000…

A: We know that a Kaplan turbine can operate at a head of 10 metres.The turbine has a design speed of…

Q: partition. One compartment contains 3 kmol of N₂ at 600 kPa pressure and the other compartment…

Q: Without writing the shear and moment equations,draw the shear and moment diagrams. 20 kN/m Im 100 KN…

Q: 4.23 Two kilograms of water are contained in a piston/cylinder (Fig. P4.23) with a massless piston…

Q: QUESTION 2 a) The 20 kg crate as shown in Figure Q2 is subjected to a force with direction and…

A: Givenm=20kgP=200Nθ=30oϕ=200when S=15m , U=6m/swhen S=30m , V=?μK=0.25

Q: A UHart Dynamics experiment consists of collar B (mg = 10 kg) traveling to the left at vB = 1.5 m/s…

Q: 12 ksi 8 ksi 6 ksi

Q: Find height P⋅E= 33.355 m = 3kg g=10m/s2

Q: A lever with an output of 0.8 meter has a mechanical advantage of 6. What is the length of the input…

A: Calculated the length of the input arm.

Q: Q4. A hollow tube having an inside diameter of 2.5 cm and a wall thickness of 0.4 mm is exposed to…

A: Given: The diameter of the tube, d = 2.5 cm wall thickness, t = 0.4 mm The heat transfer…

Q: ᴀ 14" x 12", ꜱɪɴɢʟᴇ ᴄʏʟɪɴᴅᴇʀ, ᴅᴏᴜʙʟᴇ-ᴀᴄᴛɪɴɢ ᴀɪʀ ᴄᴏᴍᴘʀᴇꜱꜱᴏʀ ᴡɪᴛʜ 6% ᴄʟᴇᴀʀᴀɴᴄᴇ ᴏᴘᴇʀᴀᴛᴇꜱ ᴀᴛ 12ʀᴘᴍ. ᴛʜᴇ…

A: Given data Clearance = 6% Suction Pressure = 14 psia Delivery Pressure = 42 psia N=1.25 We have to…

Q: 20. Determine the required force P that must be applied at the blade of the pruning shears so that…

Q: 1- The effective porosity is the value that is used in a gas reservoir engineering calculations.

A: Disclaimer: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 90 bar…

Q: .6 A piston/cylinder arrangement shown in Fig. P4.6 initially contains air at 150 kPa, 400°C. The…

Q: In the arrangement as shown; Gate 'OA' has width of 2 m inside. Hinge passes through O and rope AB…

Q: nd the angle between along diagonal and an adjacent face diagonal of a cube..

Q: A 150 MW power plant using a regenerative cycle is utilizing steam at 5 MPa, 510°C. The open heater…

A: Answer: ◆ The % mass extracted for the 1 MPa open heater is: 9.646%◆ The % mass extracted for the 3…

Q: 8. Consider the right-handed coordinate system below. The force F = 800 N has its line of action…

Q: Fnd the Face applied W=2.355 J d= 1.124m

A: Given data : Work done=W Displacement=d To find : Force applied

Q: A model of an aircraft is being tested in a wind-tunnel. If the model was replaced by one that is…

Q: 8 The tongs are designed to handle hot steel tubes which are being heat-treated in an oil bath. For…

Q: Find the velouty у сия K-E = 11773 K SS man= 55 kg

A: Given data : Kinetic energy=K.E Mass=m Required : Velocity

Q: A cylindrical machine part moves within a surrounding cylinder. The centrelines of the part and the…

A: The viscous force exerted on the machine part as it moves along the cylinder is 41.60 N.

Q: A tank with square bottom, 45 cm on a side rests on a horizontal surface with coefficient of static…

Q: 40-mm sides glass polymer fibers composite cube shown in Figure.2. The Glass polymer fibers aligned…

A: INTRODUCTION: The internal force per unit area of the cross-section is termed as stress. Stress is…

Q: A continuous and aligned fiber-reinforced composite is to be produced consisting of 30% vol aramid…

Q: Use table AT-7 , Faires A 5000-lb. gear box is provided with a steel (as rolled B1113) eyebolt for…

Q: how to simplif the equation 1 and 5?

A: Given data as per the question Mass of A = 59 kg Mass of B = 95 kg A horizontal force (P)=468N

Q: 5 Calculate the forces in members AC, AD, and DE for the loaded truss. Restraining link BC is…

Q: magnitude of the force P. 30KN A) 43.43 N B) 31.57 N P >X 40kN C) 25.75 N 36.66 N D)

A: The calculated magnitude of the force P.

Q: Discussion: 1. The effect of distance between blocks on the balance force.

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 5-An 80-L rigid tank contains an ideal gas mixture of 5 g of N₂ and 5 g of CO₂ at a specified…

A: Given data as pew question The volume of the rigid tank =80 Litre Mass of N2 =5g Mass of CO2 =5 g…

Q: Fnd the potential energy m = 33kg h = 10m g=lomis2

Q: Po Air R-22 FIGURE P4.31 4.31 A vertical cylinder (Fig. P4.31) has a 90-kg piston locked with a pin…

Q: 5/2 The 700-N force is applied to the 100-kg block, which is stationary before the force is applied.…

Q: ind the rotation velocity of lead screw n and the velocity of liquid in syringe needle if the…

A: Given Inner diameter of barrel, D = 1.5 cm Inner diameter of needle, d = 1.5 cm…

Q: HW1: A gas flows through a horizontal pipe with cross-sectional area of 30 cm². At certain point,…

Q: Which of the following equations below describes the system head of the piping shown below. The…

Q: Draw the shear-force and bending-moment diagrams for the simply supported beam shown. Determine the…

Q: For a water column of height 6 m, calculate (i) intensity of pressure (kPa) (ii) mm of mercury (iv)…

A: We must compute the intensity of pressure (kPa), mm of mercury, m of mercury, and N/m2 absolute for…

Q: A body of mass 15 kg moving with velocity of 2 m/s is acted upon by a force of 75 N for two seconds.…

A: Given, Mass of the body = m = 15 kg Initial velocity = u = 2 m/s Force applied on body = F = 75 N…

Q: The figure deg/sec. In this case, the times are given as t = 5 sec and t-30 sec. In addition, the…

Q: Stefan-Boltzmann law. Thermal radiation by a grey body.

A: Given question: Stefan-Boltzmann law and thermal radiation by a grey body. The given question is…

Concept explainers

Numerical Calculations

In the mid-20th century, the availability and the growth in power of digital computers led to the increase in the mathematical model in the field of engineering and science. The analysis of these detailed models needs to be increased.

Question

Hand by written answer.

can you pls answer this and i will upvote your answers

Eight (8) kg of 20 °C air is compressed from 95 kPa to 628 kPa. The inlet air has
relative humidity of 80%. Compression is according to the law PV1.3 = Costant. After
compression, the air is cooled again to the inlet temperature. Determine the partial
pressure due to air at he inlet, Pa1 = kPa.
93.129
92.181
93.571
94.186

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q5/ A small auditorium is required to be maintained at 22°C dry bulb temperature and 70% relative humidity. The ambient conditions are at 30°C dry bulb temperature and 75% relative humidity. The amount of free air circulated is 200m³/min. The required conditions are achieved by first cooling
Relative humidity represents .3 the water vapour in the air under low temperature to the water vapour amount in the air under high temperature. the real water vapour amount in the air per the maximum vapour amount that the air could contain. none of these answers. O the water vapour amount in the air per unit mass of the air.
A 20% quality saturated water mixture (boiling water) is in a pressure cooker at 100 kPa (atmospheric). The pressure cooker is closed allowing the pressure to increase during a constant volume process. What is the quality of the mixture when the pressure is 200 kPa? OA 0.383 OB.0.475 OCO.524 OD.0.731
At a climate station, air pressure is measured as 100 kPa, air temperature as 24°C, and the wet-bulb or dew point temperature as 19°C. Calculate the corresponding relative humidity in percent.
Exercise 17.6 Air at 20°C and 60% relative humidity is heated to 90°C and then enters a continuous dryer in an adiabatic operation. The air exits at 40 °C. Calculate: a) the inlet volumetric flow rate of air required to remove 20 kg of water/h from the product and b) the required energy to heat the air.
A quantity of moist air of mass 4 kg has a humidity ratio of 0.019 and a relative humidity of 65%. The pressure is 95 kPa. -What is the dry-bulb temperature in °C?-What is the volume of the air sample in m^3?-What is the dew-point temperature in °C?-What is the enthalpy in kJ/kg?
Use the tables of moist-air properties to find the enthalpy and specific volume for air at 125°F (51°C) if the humidity ratio is 0.040. (1) yois-
Two streams of air, (A: Absolute humidity = 24 g water/ kg dry air; RH= 60% and B: T db =19 °C & RH = 80 %) at same ratio mix together. What is the wet bulb temperature of mixed airs?
Air (mass of dry air: 3 kg) with a relative humidity of 50% at 25 °C is supplied isobaric 30 kJ. What is the relative humidity after that?
Q NO1: A mixture (i.e., thermodynamic system) of 0.182 kg of helium (He) and 0.091 kg ofoxygen (O2) is compressed polytropically (PVn = const.) in a piston-cylinder devicefrom 101.352 kPa and 15.56C to 413.69 kPa according to n = 1.4. Determine for theprocess: (a) the final temperature, (b) the work done, and (c) the heat energy.Clearly mention whether the work is done on or by the mixture, and whether the heatis supplied to or rejected by the mixture to the surroundings.Take the specific heat capacity at constant volume, cv for He = 3.119 kJ/(kg·K) andfor O2 = 0.659 kJ/(kg·K), and the value of gas constant R for He = 2.0769 kJ/(kg·K)and for O2 = 0.2598 kJ/(kg·K).Draw the schematic of piston-cylinder device and display the process on a hypothetical indicator diagram for the process.
Air enters a cooling tower at a rate of 1100 cubic meters per minute, at 15 C ard 65% relative humidity. Atmospheric pressure is 100 kPa. Water enters the tower at 38°C and leaves at 17 C.Air leaves the tower at 31 C and saturated. calculate the quantity of heat gained by the air as it passes through the cooling tower 0n a per minute basis O12 643.55 kJ/min 97 333.09 kJ/min 150 874.22 k/min 42 033.10 kJ/min
Q1/ From Humidity chart calculate: a- The initial absolute humidity and relative humidity. b- The final absolute humidity and relative humidity. For air having a dry bulb temperature of 48.9°C and a wet bulb of 37.8°C is to be dried by first cooling to 21.11PC to condense water vapor and then heating to 26.7°C.