During the compression stroke of a certain gasoline engine, the pressure increases from 1.00 atm to 19.0 atm. The process is adiabatic and the air-fuel mixture behaves as a diatomic ideal gas. (a) By what factor does the volume change? Vanal -O Vinitial (b) By what factor does the temperature change? Tinal Tinitial Assume the compression starts with 0.016 mole of gas at 28.5°C. (c) Find the value of Q that characterizes the process. (d) Find the value of AEnt that characterizes the process.

During the compression stroke of a certain gasoline engine, the pressure increases from 1.00 atm to 19.0 atm. The process is adiabatic and the air-fuel mixture behaves as a diatomic ideal gas. (a) By what factor does the volume change? Vanal -O Vinitial (b) By what factor does the temperature change? Tinal Tinitial Assume the compression starts with 0.016 mole of gas at 28.5°C. (c) Find the value of Q that characterizes the process. (d) Find the value of AEnt that characterizes the process.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

During the compression stroke of a certain gasoline engine, the pressure increases from 1.00 atm to 19.5 atm. The process is adiabatic and the air-fuel mixture behaves as a diatomic ideal gas. (a) By what factor does the volume change? Vinal = Vinitial (b) By what factor does the temperature change? Trinal - Tinitial Assume the compression starts with 0.016 mole of gas at 26.5°C. (c) Find the value of Q that characterizes the process. (d) Find the value of AEnt that characterizes the process. (e) Find the value of W that characterizes the process.
In a spark ignition engine C8H18 is used fuel. Air coefficient under full load operation is 1.1. Pressure and temperature of air at the start of ignition are 20 bar and 400°C. If combustion takes place at constant volume without any heat loss, calculate the temperature pressure at the end of combustion. The lower calorific value of C3H18 is 42286 kJ/kg. Values of heat capacity at constant pressure for gases are and Gas CO2 H2O O2 N2 Cp (kJ/kg) 0.8624 1.96 0.908 1.029
A closed, rigid tank with a volume of 0.6m ^ 3 contans saturated water vapor at900 kPa the nital stale The tar pressures decreased to 300 kPa through heat exchange with the surroundings Question 1 to apply to Problem 1 What is the initial specific volume v, m^ 3 kg ?
Henry Ford’s Model T was originally designed and built to run on ethanol. Today, ethanol (190-proof alcohol) can be produced with domestic stills for about $0.85 per gallon. When blended with gasoline costing $4.00 per gallon, a 20% ethanol and 80% gasoline mixture costs $3.37 per gallon. Assume fuel consumption at 25 mpg and engine performance in general are not adversely affected with this 20–80 blend (called E20). Solve, a. How much money can be saved for 15,000 miles of driving per year? b. How much gasoline per year is being conserved if one million people use the E20 fuel?
Find the final pressure of the adiabatic compression in a cylinder is 15% of its initial volume. [Use: Initial pressure latm and diatomic gas] A. 321.0 atm B. 24.91 atm C. 15.00 atm D. 14.24 atm A. В. С. D.
A bituminous coal has the following compositions: C = 71.6 %, N2 = 1.3 %, A =9.1 %, H2 = 4.8 %, S = 3.4 %, W = 3.5 %, and O2 = 6.3 %. The dilution coefficient is 1.35and the coal consumption is 11762 kg/hr. Determine: a) the actual air-fuel ratio requiredfor combustion; and b) the actual air required per hour.
Determine the air-fuel ratio at 6000 m altitude in a carburettor adjusted to given an air-fuel ratio 15:1 at sea level where air temperature is 27°C and pressure is 1.013 bar. The temperature of air decreases with altitude and is given by the expression T Ts -0.0065 h, where 'h' is height in meters and Ts temperature at sea level in °C. 1.013 %3D The air pressure decreases with altitude as per the relation h 19220 In
Which one of the following figures correctly represents the variation of thermal efficiency (vaviel mixture strength (x-axis)? Lean Lean Rich Rich (a) Stoichiometric (b) Stoichiometric Mixture Mixture Lean Rich Lean Rich (c) (d) Stoichiometric Mixture Stoichiometric Mixture
RP-1 is highly refined form of kerosene used for many first stage rocket engines. The average composition of it is indicated by CH1.9 a. What is the stoichiometric mixture ratio (MR) for RP-1 and oxygen? b. Now, you have a mixture of air and RP-1 with three times more air (in terms of moles) than is needed to burn all the fuel. How high is the final temperature? The heats of formation are given in the table below. In molar quantities, assume 1 mole of air is (O2+3.76N2). The reactants have a temperature of 25°C before combustion. You may use the average values of the specific heats for each constituent. C. Would the adiabatic flame temperature be lower or higher for a rocket engine that uses pure oxygen instead of air? Explain. Constituent Qf kJ/kmol @ 298 K Cp kJ/kmol K CH19 9,358 CO2 (g) -393,522 51.9 O2 (g) 0 34.0 N2 (g) 0 31.6 H₂0 (g) -241.827 40.6
An engine operates on methanol with an equivalence ratio of 0.9. The air and fuel enter the engine at 298 K, and the exhaust is at 527 °C. The heat rejected to the coolant is 340 MJ/kmol fuel. (a) What is the enthalpy of the exhaust combustion products in kJ/kg.fuel? (b) What is the specific work output of the engine in kJ/kg.fuel? (c) What is the thermal efficiency of the engine?
What is the efficiency of this cycle? O 0.42 0.58 0.28 1.00 O 0.72
Combined separating and throttling calorimeter is used to find out dryness fraction of steam, following readings were taken: Main pressure = 12 bar abs. Mass of water collected in separating calorimeter = 2 kg. Mass of steam condensed in throttling calorimeter = 20 kg Temperature of steam after throttling calorimeter = 110°C Pressure of steam after Throttling = 1 bar abs. Assume Cp of steam = 2.1 kJ/kg K. Calculate dryness fraction.