Draw an HPLC instrument diagram by writing the name of the parts. Define the isocratic and gradient system. Write correctly the elution order of the compounds which are shown in the HPLC chromatogram below. Chromatogram Compound B These are called chrematographic peaks and each one representsa separated compound Compound C Point of sample injection into the calumn Compound A

Draw an HPLC instrument diagram by writing the name of the parts. Define the isocratic and gradient system. Write correctly the elution order of the compounds which are shown in the HPLC chromatogram below. Chromatogram Compound B These are called chrematographic peaks and each one representsa separated compound Compound C Point of sample injection into the calumn Compound A

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.2QAP

See similar textbooks

Similar questions

A method of quantitative determination of the concentration of constituentsof a sample analyzed by gas chromatography is area normalization. Thiscomplete elution of all sample constituents is required. Thearea of each peak is measured and corrected for the detector response to the diffe- renteseluatos. This correction involves dividing the area by an empiricalcorrection factorDetermined. The concen ration of the analyte is found from the ratio between itscorrected and the total corrected area of all peaks. For a chromatogram containing threerelative areas were determined as 16.4; 45,2; and 30.2, in the order ofincreased retention time. Calculate the percentage of each compound if therelative responses from the detector are 0.65, 0.73 and 0.85, respectively.
Given below is a diagram of separation of two components of a mixture in a reverse phase chromatographic column. From the diagram, which component is the most non-polar?
1) Study the chromatograph (below) of a mixture of Compounds A and B, run on the GCs in the teaching labs at CU Boulder. Compound A has the shorter retention time. STAAT 61 1.11 227 RT TYPE AREA XXXX XXXX XXXX AREAS 0.009 55874 44.117 ARIHT 0.61 XX XX XX 1.11 2.27 XX XX XX TOTAL AREA=XX MUL FACTOR=XX 1. What is the retention time of compound A? Compound B? 2. Which compound is present in a larger amount? 3. Which compound has the lower boiling point? 4. What would happen to the retention times of compounds A and B if the column temperature were raised? 5. You suspect that compound B is octane. What can you do to provide supporting evidence for this hypothesis?
True or False: Liquid-solid phase column chromatography is used to separate large up to multigram amounts of mixtures, based on their differences (however small) in polarity.
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
What is the role of specific visualizing agents in a Thin layer Chromatography? Please shortly answer at your own words. Answer should be to the point (4-5 lines).
Gas chromatography cannot analyze mixtures due to the sensitivity of the instrument. True False
The following data give the recovery of bromide from spiked samples of vegetable matter, measuredusing a gas–liquid chromatographic method. The same amount of bromide was added to each specimen(Roughan, J.A., Roughan, P.A. and Wilkins, J.P.G., 1983, Analyst, 108: 742).Tomato: 777 790 759 790 770 758 764 ug/gCucumber: 782 773 778 765 789 797 782 ug/g(a) Test whether the recoveries from the two vegetables have variances which differ significantly.(b) Test whether the mean recovery rates differ significantly.
would column chromatography separate ketone and alcohol
1 24) The method of internal standard was used to analyze and measure the concentration of chemical X by GC A known mixture of compounds X and Y (internal standard) gave the following chromatographic results: Compound X Y Concentration (M) 6.3 x 10-8 2.0 x 10-7 a) 2.0 x 10-6 M b) 8.4 x 10-7 M c) 6.6 x 10-7 M d) 4.1 x 10-7 M e) 2.9 x 10-7 M Peak Area 395 787 Then, an unknown was analyzed as follows. 3.0 mL of unknown X was treated with 0.100 mL of 1.6 x 10-5 M Y and the mixture diluted to 10.0 mL final volume. Peak areas were 633 (for X) and 520 (for Y). What is the concentration of X in the unknown. (The original 3.00 sample?)
two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used?