is a mass hanging by a spring under the influence of gravity. The force due to gravity, Fg, is actingin the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection.On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁.The gravitational constant g, is 9.81 m/s².DOC.DFrontlyуYour tasks:No DeflectionmkFg = mgInitial ConditionymkWrite down an expression for the total energy If as the sumWrite down an expression for the total energy HFg = mgFigure 3: System schematic for Problem 4.Yi&XWrite down, in terms of the variables given, the total potential energy stored in the system when it is held inthe initial condition, relative to the system with no deflection.as the sum of potential and kinetic energy in terms of y, y, yiC After the system is released, it will start to move. Write down an expression for the kinetic energy of thesystem, T, in terms of position, y, the initial deflection yi, and other constantsD What would happen to H as the system moves if a dampening element c is added in parallel to the spring?

Answered: Image /qna-images/answer/01453638-b355-422c-a4cb-a42ef1906c61.jpg

dow is a mass hanging by a spring under the influence of gravity. The force due to gravity, F, is acting in the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection. On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁. The gravitational constant g, is 9.81 m/s². 20 D only Your tasks: No Deflection m Fg = mg Initial Condition m Fg = mg Figure 3: System schematic for Problem 4. & Write down, in terms of the variables given, the total potential energy stored in the system when it is held in the initial condition, relative to the system with no deflection. (2 Write down an expression for the total energy H as the sum of potential and kinetic energy in terms of y, y, yi and element parameters. Will H change as the mass moves? C After the system is released, it will start to move. Write down an expression for the kinetic energy of the system, T, in terms of position, y, the initial deflection y, and other constants ( D What would happen to H as the system moves if a dampening element c is added in parallel to the spring?

dow is a mass hanging by a spring under the influence of gravity. The force due to gravity, F, is acting in the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection. On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁. The gravitational constant g, is 9.81 m/s². 20 D only Your tasks: No Deflection m Fg = mg Initial Condition m Fg = mg Figure 3: System schematic for Problem 4. & Write down, in terms of the variables given, the total potential energy stored in the system when it is held in the initial condition, relative to the system with no deflection. (2 Write down an expression for the total energy H as the sum of potential and kinetic energy in terms of y, y, yi and element parameters. Will H change as the mass moves? C After the system is released, it will start to move. Write down an expression for the kinetic energy of the system, T, in terms of position, y, the initial deflection y, and other constants ( D What would happen to H as the system moves if a dampening element c is added in parallel to the spring?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.18P: The drag on an airplane wing in flight is known to be a function of the density of air (), the...

See similar textbooks

Similar questions

is a mass hanging by a spring under the influence of gravity. The force due to gravity, Fg, is acting in the negative-y direction. The dynamic variable is y. On the left, the system is shown without spring deflection. On the right, at the beginning of an experiment, the mass is pushed upward (positive-y direction) by an amount y₁. The gravitational constant g, is 9.81 m/s². No Deflection m k Fg = mg Initial Condition m k Fg = mg Figure 3: System schematic for Problem 4. Yi 8 Your tasks: A Write down, in terms of the variables given, the total potential energy stored in the system when it is held in the initial condition, relative to the system with no deflection. B Write down an expression for the total energy H as the sum of potential and kinetic energy in terms of y, y, yi and element parameters. Will H change as the mass moves? C After the system is released, it will start to move. Write down an expression for the kinetic energy of the system, T, in terms of position, y, the initial…
Q2: An object is projected vertically upwards with velocity 50 m/s . Find: The height it reaches ( Take g = 10 m/sq s ) %3D You can use the laws in Q1 Q1: A train moves with initial velocity 8 m/s 2 and accn = 2 m/s Find : Velocity after it moves 30 m You may use any of the laws : 1- V. V. + at 1 2 2 2- S = V,t + 0.5 a t 1 2 2 3- V. 2 V = 2 a S
1. In the laboratory, when you hanged 100 grams at the end of the spring it stretched 10 cm. You pulled the 100-gram mass 6 cm from its equilibrium position and let it go at t = 0. Find an equation for the position of the mass as a function of time t. 2. The scale of a spring balance found in an old Physics lab reads from 0 to 15.0 kg is 12.0 cm long. To know its other specifications, a package was suspended from it and it was found to oscillate vertically with a frequency of 2.00 Hz. Calculate the spring constant of the balance? (b) How much does the package weigh?
The small particle of mass (800 gm) spinning with angular velocity (w₁ = 2.3 rad/s, at r₁ = 400 mm), if we use force (F) to change the Angular velocity to (w₂, and r₂ = 250 mm) the value of F is: W1 Select one: A. None B. F = 5.63 N C. F = 9.47 N D. F = 3.52 N F
A closed thermodynamic system consists of a fixed amount of substance (i.e. mass) in which no substance can flow across the boundary, but energy can. For a closed themodynamic system we cannot add energy to the system, via substance (E ) (1.e. matter which contains energy is not allowed across the boundary) Across the Boundaries E° = No Q = = Yes W mass NO CLOSED = Yes SY STEM m = constant | energy YES Figure 1.1. If the substance inside the thermodynamic system shown in figure 1.1. (i.e. piston cylinder device) is air, is the system a Fixed closed system Moveable closed system A. В.
A:YV 36 ll 46.ll Test 3.pdf F1 F2 a F3 A d. C a F4 E Consider the following values: - F5 a = 12 m; b = 10 m; c = 10 m; d = 8 m; F1 = 6 kN; F2 = 7 kN; F3 = 8 kN; F4 = 9 kN; F5 = 10 kN; a = 30° 0 = 45° B = 60° 1] What is the resultant moment of the five forces acting on the rod about point A? a) - 111.6 kN.m b) 112.6 kN.m c) - 184.6 kN.m d) - 109.6 kN.m e) - 104.1 kN.m f) None of them 2] What is the resultant moment of the five forces acting on the rod about point B? a) -95.8 kN.m b) 42.7 kN.m c) 80.9 kN.m d) 10.9 kN.m e) 51.8 kN.m f) None of them 3] What is the resultant moment of the five forces acting on the rod about point C? a) 32.6 kN.m b) - 21.1 kN.m c) 17.4 kN.m d) - 16.5 kN.m e) 15.6 kN.m f) None of them 4] What is the resultant moment of the five forces acting on the rod about point D? a) 37.6 kN.m b) 73.8 kN.m c) 71.6 kN.m d) 52.1 kN.m e) 21.1 kN.m f) None of them 5] What is the moment of the force F2 about point E? a) 90.7 kN.m b) - 88.1 kN.m c) 54.6 kN.m d) 103.1 kN.m e)…
Physics 121 Spring 2021 - Document #11: Homework #04 & Reading Assignment page 4 of 8 Problem 1: Gnome Ride - This from a Previous Exam I. A Gnome of given mass M goes on the Gnome Ride as follows: He stands on a horizontal platform that is connected to a large piston so that the platform is driven vertically with a position as a function of time according to the following equation: y(t) = C cos(wt) Here w is a constant given angular frequency, C is a given constant (with appropriate physical units) and y represents the vertical position, positive upward as indicated. Part (a) - What is the velocity of the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Part (b) – What is the net force on the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Part (c) – What is the Normal Force on the Gnome at time t = 0? Explain your work. Present your answer in terms of the given parameters Some Possibly Useful…
2- find the center of mass, the velocity of the center of mass, the momentum, and the kinetic energy of the following system: do f(xd) xaf] m₁ = 1 kg T₁=1+2j+3 k v₁ = 2î+3ĵ m₂ = 1 kg T₂ = 1-j+ k v₂ = 2) + 3k
Q1. The image below shows an example of "absolute dependent motion analysis", where the motions of two objects depend on each other, and the goal is to find the relations in their motions (i.e., in their positions, velocities, and accelerations). Please put the suggested steps of analysis in the correct order. VA A B VB Differentiate the entire equation with respect to time, and extract the relation in velocities. Repeat for acceleration if needed. Set up a coordinate (s) along the direction of motion from a fixed point (O) or a fixed datum line. Represent the positions of the objects respectively. In some cases intermediate objects need to be considered too and their positions need to be represented as well. Recognize the constant length(s) and find the depending geometric relations between the position variables.
At the grocery store you place a pumpkin with a mass of 12.5 lb on the produce spring scale. The spring in the scale operates such that for each 4.7 lbf applied, the spring elongates one inch. If local acceleration of gravity is 32.2 ft/s², what distance, in inches, did the spring elongate? x= i inches
The friction force F on a smooth sphere falling in water depends on the sphere speed V, the sphere density ρ_s and diameter D_s, the density ρ and dynamic viscosity μ of the water, gravitational acceleration g. Choose the correct repeating variables. sphere diameter, dynamic viscosity, gravitational acceleration density, gravitational acceleration, dynamic viscosity friction force, gravitational acceleration, density density, sphere speed, sphere diameter friction force, sphere speed, sphere diameter
1.75m 1.5 m 2.75m Given: G/0 Find: 2.25m 6 o B 2.0m . h = 2.05 meters • Tension = 85 Newtons 26 1.5m W Magnitude of internal axial force (Newtons) Axial Force Bending moment V Shear force