Difference in circuit breakerand isolator.

Q: It is the Insulator used when the Transmission Lines' path need to take a turn on a sharp corner or…

A: Choose the correct option Which insulator is used to change path of transmission line or dead end.…

Q: Which part of a lightning protection system is at the top of the structure? A. Ground terminal…

A: According to the question we have discuss about the lighting protection system.

Q: Function of circuit breaker!

A: A mechanical device called a circuit breaker is made to shut or open contact members, which closes…

Q: . Discuss the types of oil circuit breakers.

A: According to the question we have to explain oil circuit breaker types.

Q: Define circuit breaker and write any two types

A: Circuit Breaker - Circuit breakers are mechanical switching equipment that may individually or…

Q: Difference between circuit breaker and fuse...

A: Fuse- Fuse is used for the safety purpose of home equipment. It operates the over-current protection…

Q: Type of fuses and their discription

A: Solve the problem

Q: A Double Circuit Iransmission System will alwa have six cables or conductors suspended on the…

A: A double -circuit transmission line refers to the arrangement in which a total of six conductors are…

Q: what is the standing wave of a 75 ohm connected to 50 ohm transmission line?

A: The characteristic impedance is Z0=50 ohms.  The load impedance is, ZL=75 ohms The standing wave…

Q: explain what happened as the lamp load (serial no) gets increases.

A: An experimental connection diagram is shown in the question. It is done to study the Load…

Q: How the required number of branch circuits can be determined?

A: According to the National Electrical Code (NEC), for individual branch circuits, the value of the…

Q: "The arc across the contacts of circuit breaker will re-strike, if the rate of rise of re-striking…

A: Circuit breaker: An electrical circuit breaker is a switching device that may be used to manage and…

Q: Question: How do the secondary voltage and current react to the different types of load and how do…

A: It is asked how in transformer the secondary voltage and current react to the different types of…

Q: What Transient Voltage appears across the Circuit Breaker contacts at, or near Current Zero during…

A:

Q: What is a circuit breaker? What is the most important parameter that helps to determine the rating…

A: A circuit breaker is a device that can detect overloads above its rating in a circuit and…

Q: What are different types of fault in electrical power system

A: The fault in the power system is expressed as the any unwanted or abnormal condition of the system…

Q: complet The equivalent reactance of the double circuit line under post fault condition…

A:

Q: Explain the differences & relationship between fuses and circuit breaker in an electrical system.

A: Fuse- Fuse is used for the safety purpose of home equipment. It operates the over-current protection…

Q: What are the effects of faults on power * ?device

A: Since there are multiple questions present, according to company policy we will be answering only…

Q: Write specifications details of all types of wiring/ cables

A: Electrical wiring A method of connecting different accessories for electrical energy distribution…

Q: Circuit breaker is a device which opens by the instruction from monitoring device called

A: Relay is a switching device which gives a signal to the circuit breaker as soon as the fault occurs…

Q: are the main region 3 what enside System verilog simulation in time step?

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…

Q: What happens in a multi-wire branch circuit when the grounded (neutral) opens or becomes…

A: The explanation is as follows.

Q: Discuss how the rating of a circuit breaker is determined and how its operation is coordinated with…

A: Circuit breaker: An electrical circuit breaker is a switching device that may be used to manage and…

Q: Differentiate cable tester with multi meter.

A: A cable tester is an electronic device used to check the electrical connections in a signal cable or…

Q: Differentiate Phase Reversal Protection between Phase Failure Protection

A: Differentiation Phase Reversal Protection between Phase Failure Protection- Phase-failure protection…

Q: . What's the primary instrument for locating a break in a cable during emergency maintenance? A. OSA…

A: In this question we need to choose a correct option

Q: 10. In high-voltage switch gear, the irsulation used inside the breaker (arc chambers) is (a) Epoxy…

A: In high voltage switch gears, the insulation used in the arc chamber is generally epoxy raisins.

Q: A. Discuss the arcing phenomenon in a circuit breaker.

A: As per the policy, I can answer only one question at a time. Please ask the other question…

Q: New dishwasher circuits can be wired directly to NM cable. The circuit breaker is the disconnect. O…

A: NM Cable- NM cables is a type of cable in which the two or more insulated wires are again covered in…

Q: 14 Which type of Insulator is used in Substations to support connections for High Voltage…

A: Which type of insulator is used in substations to support connections for High voltage switchgears,…

Q: Mark all the parts of gas pressure cable in pictures

A: Gas pressure cable : it an coaxial or simple cable which filled with inert gas like nitrogen at…

Q: List down the 3 major components of a switchboard. Write the function and specification of each.

A: Power system protection is the subject. A switch board main function is to take power from the…

Q: What is the difference between Zener breakdown and Avalanche breakdown?

A: Difference between Zener breakdown and Avalanche breakdown :

Q: During faulty condition, high short circuit current

A: Due to No separation of primary and secondary windings hencw hysteresis doesn't apply.

Q: Tubular strip lights is an best example for |type lamp.

A: Given  Tubular strip lights

Q: Draw the schematic diagram of Induction type energy meter and explain the construction of the same.(

A: To explain the induction type energy meter

Q: For high-voltage protection, fuses are generally preferable to circuit breakers for all of the…

A: Fuse have following advantage over circuit breaker  1.  Initial cost of fuse is lower   2. Fuse is…

Q: b) The general function of the circuit breaker (CB) is to close and open the circuit to be able to…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: What type of modulation scheme is used but IS 95 system

A: In this case, the modulation scheme used by the IS 95 system is to be determined.

Q: "The arc across the contacts of circuit breaker will re-strike, if the rate of rise of re-striking…

A: Restriking voltage is the voltage that appears across the contact of the circuit breaker during the…

Q: Mention the difference between Zener and avalanche breakdown.

A: Breakdown takes place in reverse biased p-n junction diodes. During break down, the value of the…

Q: 4 Difference between circuit breaker and fuse...

A: Circuit Breaker Definition: A Circuit Breaker is a switching device which also offer protection…