Develop an 8051 ALP to transfer data from code space starting at address 200H to RAM locations starting at 50H. After transferring the data to RAM, calculate the sum of the first four data and the difference of the last two data, store the result in RAM location starting at 70H and 91H respectively Also show the status of PSW register and final register contents. The data is as shown below: ORG 200H DB: 05H, 17H, 52H, 24H, 35H, 26H Comment on every line of the program

Q: ermine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es. If…

A: It is defined as the method to specify the operand of an instruction. The job of a microprocessor is…

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: your  answer is given below:

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: your answer is given below:

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: Addressing mode , of physical address and content of destination:   MOV[BX],BX copy BX contents  to…

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: The handwritten solution is given in the step-2.

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: Here, I have to find addressing mode, physical address and content of the destination.

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: Given The answer is given below.

Q: Determine the specific type of addressing mode (SMALL LETTERS only) and compute for the address/es.…

A: The handwritten solution is given in the next step:

Q: a) Design a memory address decoder circuit to interface 32KB of ROM starting from address 3CO00H to…

A: Here, we have to provide a solution for the above question.

Q: Suppose we have the instruction Load 500. Given that memory and register R1 con tain the values…

A: In immediate addressing mode, the value present is the operand itself. So here A = 500 In direct…

Q: 2. Suppose that DS = 1300H, SS = 1400H, BP = 1500H, and SI = 0100H. Identify the addressing modes…

A: Solution  (a) MOV EAX,[BP+200H] (b) MOV AL,[BP+SI-200H]

Q: Sketch the schematic and develop an 8086 assembly language program to send an ASCIII character as…

A: The Solution of the above question is :    PORTB   EQU  66H    PORTB   EQU  67H    CONTROL  EQU  68H…

Q: Q1/ two bytes 32 and 17 stored at [0500H] and [0501H] respectively. Write an instruction sequence…

A: Given:- Two bytes 32 and 17 are stored at [0500H] and [0501H] respectively.  The following…

Q: Topic : Writing MIPS code.   1.Consider the equation and write MIPS code for it:…

A: $s0 = Base address of array A[] $s1 = Base address of array B[] $s2 = X Given, X=(A[3]+B[5]) -…

Q: Develop an ALP to transfer the content of ROM location starting from 300H to RAM location 50H. After…

A: Answer: I have given answered in the handwritten format in brief.

Q: Q1/ two bytes 32 and 17 stored at (0500H] and [0501H] respectively. Write an instruction sequence…

A: The provided things are as follows: Given:- Two bytes 32 and 17 are stored at [0500H] and [0501H]…

Q: Design the memory mapping between the Cache memory of 512 MB to the main memory of 4 GB using 4 way…

A: Cache memory: It is a memory which optimized the gap between RAM and CPU means it stores the content…

Q: Design the memory mapping between the Cache memory of 512 MB to the main memory of 4 GB using 4 way…

A: Given question has asked to design memory mapping between Cache memory of 512 MB to the main memory…

Q: Given the following data definition x: .word  -10, +25, -56, -68, +88; and assuming that $t0=&x;…

A: Answer: Given x:-10,+25,-56,-68,+88  and $t0=&x;

Q: Develop a 64-bit wide memory interface that contains SRAM at locations (EEFE80000- EEFEFFFFF) H and…

A:

Q: Following is the memory map begining from addre= ACOOH and increasing addresses to the right, all in…

A: It is defined as a unique identifier used by a device or CPU for data tracking. This binary address…

Q: b) Given that the crystal frequency of 8051 Microcontroller is 11.059 megahertz, and one machine…

A: crystal frequency is 11.059 MHZ

Q: Assume a 960 ns execution time, a CPI of 1.61, and a clock rate of 3 GHz for the second benchmark,…

A: Given: CPI = 1.61 clock rate = 4 GHz execution time = 960 ns * 0.9

Q: Assume a 960 ns execution time, a CPI of 1.61, and a clock rate of 3 GHz for the second benchmark,…

A: Given Data : Execution time  = 960ns CPI = 1.61 Clock Rate = 3GHz

Q: Problem 4: Give a block diagram for a 8M x 32 memory using 512K x 8 memory

A:

Q: 6. A segment register =- for a physical address= 60000H and offset=D470H. 7. If an 8086 logical…

A: 6) Solution) 52B90H Explanation:  Since Physical Address = Base Address + Offset Hence, the value of…

Q: 1) Assume that we have 32 bit wide memory system that is byte addressable. For the purposes of this…

A: …

Q: Add two 2-Byte values to find their 3-Byte sum. The first value $812C is stored in Little Endian in…

A: data segment a db 150,182,211 b db 215,214,236 data ends code segment start: mov ax,data…

Q: Given the following data definition x: .half -10, +25, -56, -68, +88; and assuming that $t0=&x;…

A: Given the following data definition x: .word  -10, +25, -56, -68, +88; and assuming that $t0=&x;…

Q: (B)- Identify the addressing modes used for the source and destination operands, and then compute…

A: Address modes of 8085:

Q: Identify the addressing modes used for the source and destination operands, and then compute the…

A: The different ways in which a source operand is denoted in an instruction is known as addressing…

Q: 2. The 8-bit registers AR, BR, CR, and DR initially have the following values: AR= 11010010, BR=…

A: Actually, AR,BR,CR and DR are registers. The 8-bit registers AR, BR, CR, and DR initially have the…

Q: Ql: Determine the physical address of the source operand base on the Based Indexed Addressing Mode.…

A: We need to compute the Physical address of the source operand base.

Q: Two interrupts have execution times of 7.5us and 10 us. Both occur at the same rate, Find the…

A: SUMMARY: -Hence, we discussed all the points.

Q: 7. Suppose that. DS = 0200H, BX = 0300H, and DI = 400H Determine the memo address accessed by each…

A: a)mov AL,[1234hH] given effective address=1234h DS=02000h this instuction is the example of dirct…

Q: 2. Create a new asm project “Lab2_Q2.asm". Assume that port B 8255A PPI is the source for 256 bytes…

A: Creating a new asm project “Lab2_Q2.asm”. Assume that port B 8255A PPI is the source for 256 bytes…

Q: Example: show the control signals needed to perform Add R1, R2, RO using: a. Three bus organization…

A: EXPLANATION Below is the answer for the given question. Hope you understand it well. If you have any…

Q: Section 5.5 states that modern server memory modules (DIMMs) employ SEC/DED ECC to protect each 64…

A: Given data: A single error correcting, double error detecting(SEC/DED) hamming code is present and…

Q: in 80886 microprocessor Suppose that. DS = 0200H, BX = 0300H, and DI-400H Determine the memory…

A: Given:- DS = 0200H BX = 0300H DI = 400H

Q: Q2) If BP=3000H, SI= 0022H, DS= 0200H. SS=0500H, BX=3471H, and CX=AB28H. Explain and draw the type…

A: BP = 3000HSI = 0022HDS = 0200HSS = 0500HBX = 3471HCX = AB28H Need to define type of addressing mode…

Q: Q2) If BP=3000H, SI= 0022H, DS= 0200H. SS=0500H, BX=3471H, and CX=AB28H. Explain and draw the type…

A: a) It is direct addressing mode, where the instruction contains register and an offset address. This…

Q: Memory locations 00390H through 00393H contain, respectively, 9A, 76, 65, and 1F. What does AX…

A: The answer is

Q: -) – Provide the format and assembly language instruction for the following hex values: Address…

A: Address 1000:13 The memory location 1000 is indicated by the address 1000. The HEX value 13 stands…

Q: Compute the physical address for the source operand in the following instruction if the contents of…

A: There are different methods for addressing an operand which is referred as Addressing modes. In the…

Q: For a second benchmark, libquantum, assume an execution time of 960 ns, CPI of 1.61, and clock rate…

A: Answer: Given: CPI = 1.61 clock rate = 4 GHz execution time = 960 ns * 0.9

Q: Create a Synchronous RAM with the following block diagram given below: Where • In_clk : timing for…

A: RAM(Random Access Memory) is a part of computer’s Main Memory which is directly accessible by CPU.…

Q: Find the physical  destination address of last instruction below. MOV BX,0AAH MOV AX,1BBH MOV…

A: In this question, we have to find the destination address of last instruction. In last instruction,…

Q: If BP=1000, DS=0400, SS=0700, CS=0500 and AL=EDH, for the following instruction: MOV [BP] + 1234H,…

A: Given Data: BP = 1000 DS = 0400 SS = 0700 CS = 0500 AL = EDH

Q: Q/ The following table includes the five individual stages of the datapath, Compute the following in…

A: (a) Pipelined: In a pipelined processor slowest stage of the pipeline determines the cycle time. In…

Q: 3. write ARM assembly program to load the three 16-bit hexadecimal numbers into memory locations…

A: Write ARM assembly program to load the three 16-bit hexadecimal numbers into memory locations…