Determine the scalar components Ra and R₂ of the force R along the nonrectangular axes a and b. Also determine the orthogonal projection Pa of R onto axis a. Assume R = 780 N, 0 = 118°, p = 29° R

Q: Chlorine gas is moving through a pipeline at a rate of 200 kilogram per hour while being pressured…

A:

Q: 2m В A -500 N 45° -2m- C

A: Given,

Q: A chain with length l is held stretched out on a frictionless horizontal table, with a length y0…

A: Solution: Given Data: *The length of the chain is: L *The length of the chain hanging down through…

Q: What is Bragg’s law? What is its use

A: intro- Bragg's law are used for defining the wavelength and lattice spacing of the crystal.

Q: As shown in the figure below, air is contained in a vertical piston-cylinder assembly such that the…

A:

Q: As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the…

A: Givenρ=845 lb/ft3d=5inθ=20oPatm=14.7g=32.2 ft/s2

Q: Consider a crank rocker mechanism with L1 = 90 mm, L2 = 180 mm, and L3 = 270 mm. The design…

A: Given data, Length of side 1, L1 = 90 mm Length of side 2, L2 = 180 mm Length of side 3, L3 = 270 mm…

Q: A pressure gauge 6 m above the bottom of a liquid-filled tank reads 90 kPa. Another gauge 4 meters…

A:

Q: A piston-cylinder assembly contains 2 lb of water, initially at 100 lbf/in.² and 400°F. The water…

A: Given data m= 2 lbP=100 lbf/in2x=0.6 Here m is the mass and P represents the pressure. Now we have…

Q: The figure belows shows an object whose mass is 5 lb attached to a rope wound around a pulley. The…

A:

Q: A force P of magnitude 520 lb acts on the frame shown at point E. Determine the moment of P about…

A:

Q: Can some please help me to solve this problem while showing all work, formulas, and diagrams. Please…

A:

Q: A tank of water has a gate in its vertical wall 6 m high and 3 m wide. The top edge of the gate is 2…

A:

Q: OTTO CYCLE 5. The cycle net work of an air standard Otto cycle is 900 kJ/kg with a maximum cycle…

A:

Q: Three forces are concurrent at C point if their lines of action ... at C can not be be forces O…

A: CONCURRENT FORCES: When two or more forces acting on a body such that their line of action must pass…

Q: Determine the moment of inertia about the y-axis of the shaded area of the figure shown:*

A:

Q: Part of the landing gear for a light plane is shown in figure. The compressive stress in the strut…

A: Given R = 20 KN Angle = 53.1 Outer diameter of the cylinder = 40 mm Inner diameter of the cylinder =…

Q: 1500 liters/s of ammonia gas at 100°F and pressure of 30 in.Hg has a specific heat ratio of 1.304.…

A: Given data Q=1.5 m3/sT1=100°FT2=180°Fγ=1.304 Here, Q is the flow rate and T1 is the initial…

Q: If the equal tensions T in the pulley cable are 320 N, express in vector notation the force R…

A:

Q: 8. What is the specific weight of five liters of liquid weighing 50 N? 9. For item 8, what is the…

A:

Q: The resultant of the 50 lb and 30 lb forces in figure 5 is R. If R = 65lb, determine the angles ?…

A:

Q: A 4.0-cm-diameter sphere is heated to a temperature of 200°C and is enclosed in a large room at 20…

A: Given data diameter o sphere (d) = 4 cm =0.04 m temperature of sphere(T1)  = 200°C = 200+273 =473k…

Q: Heat loss through an insulation (k = 0.05 W/m·C) is 125 W/m2. The temperature gradient across the…

A:

Q: An experimental device imparts a force of magnitude F = 41 lb to the front edge of the rim at A to…

A:

Q: The magnitude of the moment is depend on Force and the perpendicular distance between the force and…

A: Given data The magnitude of moment is depends on which value. Find. To select the correct option.…

Q: A straight steel rod of circular cross-section and length 72 cm rotates about an axis through one…

A: Given data, Length of the steel rod, L = 0.72 m Maximum tensile stress, σt,max=55.85 MPa Specific…

Q: Please find the points of likely failure and give their corresponding stress states. All forces are…

A: Given: The torque acting, t = 100 N.m The force acting at one end, F = 500 N The length of the beam,…

Q: The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 700…

A: Given  Tension, T = 700 N   Length, L = 1.2 m         Angle = 52o Find  Components of force

Q: Draw (FBD) and calculate the support reactions in the simply support beam ABCD below 0.3m 3kN B *…

A:

Q: Explain in your own word the Components and Flows in Water Systems

A: Given question: Explain in your own words the components and flows in water systems.

Q: A car passes over a hill as shown. Determine the following. a. Equation for the maximum speed of the…

A: For solution refer below images.

Q: A U-tube manometer filled with mercury is attached to a gas tank. The level of mercury on the open…

A:

Q: A rectangular aluminum plate of uniform thickness has a strain gauge at the center. It is placed in…

A:

Q: ᴀ ꜱʜᴀꜰᴛ ɪꜱ ᴛʀᴀɴꜱᴍɪᴛᴛɪɴɢ 189 ᴋᴡ ᴀᴛ 180 ʀᴘᴍ. ɪꜰ ᴛʜᴇ ᴀʟʟᴏᴡᴀʙʟᴇ ꜱᴛʀᴇꜱꜱ ɪɴ ᴛʜᴇ ᴍᴀᴛᴇʀɪᴀʟ ɪꜱ 60 ᴍᴘᴀ, ꜰɪɴᴅ…

A: GivenP=189kWN=180rpmσa=60MPa =60 N/mm2θ≤10L=3m=3000mmG=80GPa=80×103 N/mm2

Q: Four people are attempting to move a stage platform across the floor. If they exert the horizontal…

A:

Q: 2-14 A person gets into an elevator at the lobby level of a hotel together with his 30-kg suitcase,…

A: Given:Mass of suitcase, m=30 kgHeight of the 10th floor, h=35 m

Q: Q2) Water at a temperature of T1 = 4°C flows in a cylindrical pipe. On a winter day, the outside air…

A: Given data:- The inner radius of the cylinder pipe ri= 8 cm Inside cylinder pipe temperature T∞1=40C…

Q: 300N 30° 1m 0 1m 722N 390N 12 5 Compute the resultant of the three forces shown in the figure.…

A:

Q: * is the force resisting the relative motion of two surfaces in contact Normal force friction the…

A:

Q: Four balls of equal radii form a pyramid supported by a smooth horizontal plane surface. The three…

A: Given there are four balls of equal radius the structure shown is in the form of tetrahedron.…

Q: Which of the following set of internal loads develop in section a-a with the application of the…

A: To find set of internal loads develop in section a-a with the application of the downward force

Q: 65 km/hr to m/s 5.324 g/cm^3 to lb/ft^3

A:

Q: 1-Static: is defined as the state of equilibrium of bodies affected by a system of force does not…

A: According to the company's guidelines, When multiple choice questions are asked only first 3 have to…

Q: A Diesel engine has a state before compression of 100 kPa, 290 K, a peak pressure of 6000 kPa, and a…

A: Given that: Pressure and temperature at the inlet of compression process is 100 kPa and 290 K…

Q: An aeration fan has a Q = 2.45 m³ per second with Static pressure head, hp = 2.94 cm WC, a…

A: The given data is shown in the following attached image:

Q: If the velocity distribution over a plate is given by u = y - y² in which u is the velocity in meter…

A:

Q: Why we need for superheated steam in the bottoming cycle (Rankine cycle).

A: Since you have been posted multiple questions. So, we are solving only first question for you. If…

Q: If heat is added to a system and the temperature of a system increases, then the internal energy…

A: It is true that if heat is added to a system and the temperature of a system increases, then the…

Q: A 5-cm-external-diameter, 10-m-long hot water pipe at 80°C is losing heat to the surrounding air at…

A:

Q: Link AB, of width b =50 mm and thickness t = 6 mm, is used to support the end of a horizontal beam.…

A: Given Width = 50 mm Thickness = 6 mm Allowable normal stress = 2140 MPa Allowable shear shear stress…