Determine the resultant R of the system of distributed loads and locate its line of action with respect to the left support for y w = 200x – 25x2 N/m 400 N/m A B. 4m 2 m
Q: Represent the resultant of the force system acting on the pipe assembly by a single force R at A and…
A:
Q: If the force vector F=(33i-45j+53k) N. a=4 m; b-3 m; c=2 m; a a a F 4a) Determine the magnitude of…
A: Those physical quantities which have both magnitude as well as direction. For example, velocity,…
Q: Determine the magnitude of the resultant force at A. F=840 N 6 m Fe 420 N 3 m B. 2 m 3 m 2 m E
A:
Q: The device is used for surgical replacement of the knee joint. If the force acting along the leg is…
A: Data given F = 360 N Angle between force F and x axis = 60° Angle between force F and axis y' =…
Q: Determine the resultant R of the system of distributed loads and locate its line of action with…
A: Given Data: The distributed load-1: w1(x)=100x2. The distributed load-2: w2=400 N/m.
Q: Q3/ Determine the magnitude and the direction of the resultant force. (Use Cartesian vector…
A: Expressing the forces in cartesian form as F1→=F1×810 i^+0+F1×610 k^F1→=500×810 i^+500×610 k^F1→=400…
Q: y 30 kN 60° 40 kN
A: Draw diagram representing all forces and their directions Write all forces in vector form
Q: If the force vector F=(33i-45j+53k) N. a=4 m; b-3 m; c=2 m3B a a a F 4a) Determine the magnitude of…
A: Those physical quantities which have both magnitude as well as direction. For example, velocity,…
Q: The distributed load acts on the beam as shown. Determine the magnitude of the equivalent resultant…
A: w= -2x2 + 4x + 16 x= 0 to 4 ft
Q: The cable BC carries a tension of 750 N. Determine the projection of the tension on the line BO and…
A:
Q: The slab is to be hoisted using three slings shown. Determine the resultant force R and the point…
A: F1=6kF2=-(5cos45°×sin30°)i+(5cos45°×cos30°)j+5sin45°kF2=-1.7677i+3.062j+3.535kF3=(4cos60°)i+(4cos60°…
Q: The resultant of the three cable tensions acting on the flagpole is the force R acting vertically at…
A: Given:- The resultant of the cable is acting on the force on the flagpole is:…
Q: From the figure above, determine the y-component of the Resultant Force if (a) is equal to 56N and…
A:
Q: If the force vector F=(33i-45j+53k) N. a=4 m; b=3 m; c=2 m; a C a a F 4a) Determine the magnitude of…
A:
Q: Replace the distributed loading with an equivalent resultant force. What is its location on the beam…
A: Given data: The distance between A and B is LAB = 3 m. The distance between B and the free end is…
Q: D FDA= 3.5 kN, 9 m FDB= 2.5 kN FDc= 3.0 kN B 4.5 m 3 m 3 m 3 m A - 30°
A: Given data: The value of force in the cable DC is, FDC=3 kN. The value of force in the cable DA is,…
Q: Determine the resultant of P and T as shown if P=848 N and T=696 N. T 6 m C 60
A: Write the given values with suitable variables. P=848 NT=696 N
Q: The resultant of the three cable tensions acting on the flagpole is the force R acting vertically at…
A:
Q: y 500 N 300 mm 500 N 500 N
A: Find the resultant.
Q: Determine the magnitude of the tension (T) in the supporting cable and write the force acting on the…
A:
Q: Determine the resultant force acting at A. 15 m 2 m 4 m -40 N F=55 N 6 m 3 m 4m.
A:
Q: Find the resultant ( R ) of the force system shown. Show its position with respect to point (0).…
A: Given: A force applied to the system is magnitude os 500 N, 200 N, 400 N and 150 N. The moment is…
Q: Find the magnitude of the projected component of the force along the pipe OA. Hint: Use Dot product.…
A:
Q: Problem No. 2 Determine the Resultant force of the three forces. 120 N 150 N SO N 30 35 40°
A:
Q: Determine the resultant R of the system of distributed loads and locate its line of action with…
A: for the given distributed load To determine Resultant R of the system of distributed loads…
Q: replaces the entire system of forces and gives the same effect as that of the system Resultant…
A:
Q: Determine the resultant of three forces acting on the plate. Also, find the coordinates of the point…
A:
Q: Determine the resultant force and Specify where it acts on the beam measured from point a for the…
A: As per policy, the first question is solved. Feel free to submit next question as a separate…
Q: Determine the resultant moment of the forces about point B F=400N 100 N D \30° A 45° 0.3 m B JrooN…
A:
Q: Determine the reaction force acting on the pin at A as the vector, if the beam AB has a mass of 100…
A:
Q: Determine the resultant force of the distributed loadings that acts on the beam and its location…
A:
Q: The resultant of the three forces is a force R that passes through pointB.A Determine R and F
A: Consider the reaction at B is HB and VB. The resultant force passes through point B, the moment…
Q: Replace the loading by an equivalent resultant force and determine where its line of action…
A:
Q: are acting on a point given by 20N e= 30° , 15N e= -45° and 50N e= 160°. Determine the x and y…
A: Given:- First force 20N Second force = 15N Third force = 50N Angle 1=30 degree Angle 2=-45 degree…
Q: If the force vector F=(33i-45j+53k) N. a=4 m; b=3 m; c%32 m; a C a a 4a) Determine the magnitude of…
A: Dot product of any two vector is known as scalar product of two vectors. a.b vector means the…
Q: It is desired to replace these three forces acting on the bar. Determine the distance where this…
A: Solution:
Q: It is desired to replace these three forces acting on the bar. Determine the distance where this…
A:
Q: The pressure loading on the plate varies uniformly along each of its edges. Determine the magnitude…
A:
Q: Problem Number 1: In the given loaded beam determine the resultant force, R and its location from…
A: There is no horizontal force in given problem. Therefore horizontal component of resultant force is…
Q: 4. Wet concrete exerts a pressure distribution along the wall of the form. Determine the resultant…
A:
Q: If the two tensions T1 = 200 - 400 N and T2 = 300 - %3D 500 N act at B, determine the resultant…
A: Given, T1=200-400 NT2=300-500 N The coordinates of the points, A0 m, 0 m, 0 mB0 m, -1 m, 2 mC6 m, 2…
Q: Problem: H.W//Determine the resultant of coplanar force 200N system of the fig ( ) and locate it…
A:
Q: HW/Determine the resultant of coplanar force system of the fig ( ) and locate it with respect to…
A: All the forces acting on one plane is a coplanar force system with concurrent, non-concurrent,…
Q: Determine the resultant of the distributed load acting on the beam shown, and locate its line of…
A: Given data as per question W1 = 230 lb/ft W2 = 35 lb/ft A = 5.6 ft. B = 2.5ft Calculating resultant…
Q: QS/ Replace the three forces which act on the bent bar by a force-couple system at the support point…
A:
Q: If the tension in the gantry-crane hoisting cable is T = 28 kN, determine the unit vector n in the…
A:
Q: Replace the loading by an equivalent resultant force and determine where its line of action…
A: Free body diagram of given figure
Q: Determine the resultant of the line load acting on the beam.
A: The beam is under symmetric loading.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Determine the resultant of all parallel forces acting on the rocker arm. 4 ft 5 ft Select the correct response: 7 ft 50 lb 6 ft 4' 40 lb 20 lb 2' 3' 5' 60 lbAddition of Vectors by Component Method Direction: Solve the given problem correctly Given : F₁ 200 N, 30° above +x F₂= 100 N, 45° above-x F3 = 150 N, -x F₁ = 220 N, 53° below +x Find: F (resultant force) Solution: Show your solution.Determine the resultant R of the system of distributed loads and locate its line of action with respect to the left support for y 400 Ib/ft 300 Ib/ft 150 Ib/ft A 7 ft 8 ft
- HOME WORK 3 Determine the resultant force at A. for the figure below Hint : 1- Find the position of all points A,B,C (x, y, z) 2- Find FAR and FAC 3- Find |raR| and Iracl 4- Find FAR = F UAB and FAC = F UAC 5- Finally find R and a, B,Y 3m Fc= 500N FB= 500N 3m 5m 3m B 4m 2m 5mQ1 \ What is the equivalent resultant force of the system acting on the beam below? and where is it located with respect to point O?Using the component method, find the complete resultant of the following forces: F= 2m, 40° N of E, and G = 4m at 127° counterclockwise from East?
- Determine the resultant R of the system of distributed loads and locate its line of action with respect to the left support for y 200 Ib/ft 150 Ib/ft 100 Ib/ft A B 3 ft 3 ft 3 ftProblem 1d: Find the resultant for this system of forces: 7 ft F₁-81 lb F₁-100 lb 3 ft 40%touch & OL166% 00:27 MENG250 - Practice Assi... Not saved yet •2-77. Determine the magnitude and coordinate direction angles of F, so that the resultant of the two forces is zero. Y2 B2 a2 y 60° 15°. F= 180 N O
- Determine the resultant R of the system of distributed loads and locate its line of action with respect to the left support for y 500 Ib/ft 250 lb/ft A B 4 ft 3.5 ftDetermine the resultant R of the system of distributed loads and locate its line of action with respect to the left support for 800 N/m 400 N/m A 2.5 m 2.5 m 2.5 mThe rectangular framework is subjected to the following non-concurrent system of forces: a 30lb- force below the origin, a 20 lb-force,3ft above the origin and making an angle of30°N of E, a 100lb-force with a horizontal distance of 3ft and a vertical distance of 4ftfrom the origin and making an angle of 45°NW , a 60lb -force with the same distance like the previous force but along the positive x-axis, and a 100lb- force 4ft tothe right of the origin and making an angle of 60° S of W . Determine the magnitude and direction of the resultant, as well as its moment arm relative to the origin.