Derive the state-space representation in matrix form for the network in Figure Q3 and then determine H(s). v¡(t) + C₁ ic₁ VC₂ R=61 Q, C 1 = C 2 =61 F and L = 61 H. 0000 iR VL Figure Q3 R VR Ucz ic + vo(t)

Q: circuit to realization the functions: F1(A, B, C, D) = m(0,1,5,7,10,11,13,15) F2(A, B, C, D) =…

A: We need to design the given Boolean function by using of PROM.

Q: Question 6 Find the resistance of load which takes a power of 10kW from a shunt generator whose…

A: Given- Power P=10 kW, To Find- The resistance of load (RL).

Q: A PID controller is designed to control the robot leg, and the control system is shown in Figure 2…

A: Type of control system Closed-loop control system  The more accurate response even in the case on…

Q: In the circuit shown, determine the equivalent impedance with respect to terminal A-B by assuming an…

A:

Q: A coaxial cable with a conductor surrounded with 2 dielectric layers. The radius of the conductor is…

A:

Q: (a) Define Noise Immunity and Noise Margins in CMOS circuits. (b) Describe some of the key factors…

A: Noise immunity: It is a measure of the capability of a logic circuit reacting to the undesirable…

Q: 4- Compute the power factor of the network and the power delivered to the network 5- Determine the…

A:

Q: Find I1, I2 € using nodal analysis.

A: Given : A circuit diagram is with value of resistance and voltage source is given below,

Q: 7) Determine Ic, VcE, IB, Vg and VB (no order restriction) 39 ΚΩ ' 8.2 ΚΩ dia 9 18 V w 3.3 ΚΩ + VCE…

A:

Q: Q1. An indirect Armstrong method is used to produce a wideband frequency modulated signal with…

A:

Q: TASK 3-Y-Y Three phase system The circuit in Figure 1 is a balanced three phase system which has the…

A: It is given that: Van=2202∠0°VVbn=2202∠240°VVcn=2202∠120°Vf=50 HzR=R1=R2=R3=111 ΩC=C1=C2=C3=52.7 μH

Q: 8 Translate the BCD words 0111 into seven-bit words of the form ABCDEFG (display with seven…

A: 8. Given, BCD code is 0111. We need to determine the seven bit word of form ABCDEFG (from the…

Q: 13. If you used 600 W of power for 60 h, you have used A. 36 kWh B. 3.6 kWh C. 10 kWh D. 1 kWh

A: Given data, Power is given P = 600 W. Time is given t = 6 hour.

Q: Given x[n] = 3-"[u(n + 4) = u(n+1)] and h[n] = u(n-2)-u(n-6), determine convolution of x [n] and…

A: Given: x[n]=3-n[u(n+4)-u(n+1)],h[n]=u(n-2)-u(n-6), To find: Convolution of x[n] and h[n].

Q: Determine the Fourier coefficietns of x(t) = cos(4t) + sin(6t)

A: Given: xt=cos4t+sin6t Required: Fourier series coefficients.

Q: - The pnp cascode depicted in Fig. 9.46 must provide a bias current of 0.5 mA to a circuit. If Is =…

A: Given circuit, Given data, Current Is=10-16 A Constant β=100 Current Ibias=0.5 mA

Q: A FM wave is represented by the following equation, V=9sin (5 x 10ft +3sin1300t) Find: a) Carrier…

A: Given data,, FM wave is represented as V=9sin5×104t+3sin1300t.

Q: For the circuit shown in Figure 1, the transistor parameters are: ß= 100, VBE = 0.7 V, and VA = 80…

A:

Q: P3. For what values of "K" is the time constant of the closed-loop system has open-loop T.F.…

A:

Q: Problem IV. Find the solution of the following LTI homogeneous system. X(t) = [¹²]X(t) . -4 X(0) =

A: it is asked to find the solution for given state space representation

Q: The dark saturation current of a solar cell is 1.6X10-8 A/m2 , the cell temperature is 333 K, the…

A:

Q: Table 1: Laplace Transform Properties Linearity L{af(t)} = aF(s) Superposition L {f₁(t) + f₂(t)} =…

A:

Q: Resistances X, Y, and Z are connected in series. The voltage across X and Y is 21 V, across Y and Z…

A:

Q: A sinusoidal electric wave with maximum amplitude of 10 V/m is polarized in ŷ and travelling in…

A:

Q: 1- In a buck DC/DC converter: V₁ = 100 V, R = 82, D = ton = 0.8, f == 20000 Hz, L = 200 μH, C =…

A:

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A:

Q: N 2301 8HP Ori 0.8pf 10HP ≤ 10 6.7pf 2000 h det Pr, QT, St, pft det. the value of Compacitor meded…

A: Power factor of resistive load is 1 Power factor of induction load is lagging in nature  Power…

Q: TASK 3-Y-Y Three phase system The circuit in Figure 1 is a balanced three phase system which has the…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: In this inverter V₁ = 100 V and the main frequency of inverter is f = 60 Hz. The load consists of a…

A:

Q: 3. For the circuit below, determine the ff: (a) voc as seen at terminals a and b, (b) is at…

A:

Q: TASK 3-Y-Y Three phase system The circuit in Figure 1 is a balanced three phase system which has the…

A: It is given that: Van=2202∠0° VVbn=2202∠240°=2202∠-120° VVcn=2202∠120° Vf=50 HzR=R1=R2=R3=100…

Q: Note: E=Volume, P=Power and W-Energy E = 20 v.; I= 4 a.; t = 3 seconds. P = W E = 15 v.; 1= 6 a.; t…

A: In this question We need to determine the power and energy of the given system.  We know Power P=…

Q: 13 for a certain load the power is -735 VAR, 1040 VA, the values of of the power factor and the…

A: Given data, Reactive power Q = - 735 VAR. ( Here negative sign shows that reactive power will be…

Q: Question 1 Find V₁ and V₂ in the circuit shown in Fig. Q1 www "990 12V www +92- Fig. Q1 10V

A:

Q: 7.1 In the circuit in Fig. P7.1, the voltage and current expressions are v=160e-10V, 120t: i =…

A: the voltage and current expression of series RL circuit is given it is asked to find the values of…

Q: B. A two-storey residential house has 100 sq. mtrs per floor. Having 2 circuits for small…

A: The given values of loads for a two-storey residential house are written below. 3 units ACU with…

Q: Q5. The commonest insulating liquids are: A. Petroleum oils B. Askarels C. Fluorocarbons Q6.…

A: The insulating liquids is used to prevent the transformer. Suspended solid particle mechanism is…

Q: P16. Consider unity feedback has an open loop transfer function below. Find: 1-The static error…

A:

Q: In the given circuit, find the following: a. b. voltage magnitude across the load in volts voltage…

A:

Q: Using general-purpose open-loop zero crossing logic a Vo = 5 V = OV an op-amp, design. based on the…

A: Types of op-amp Inverting Op-amp Non-inverting Op-amp  The Ideal operational amplifier is an…

Q: (c) Consider the circuit shown in Figure Q2-2, where u(t) is the unit-step function, i. Calculate…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: 1) The AC circuit shown in Figure Q3-1 is expressed in the phasor domain. Given that V₁ = 50 Z V…

A:

Q: Resistive Voltage The supply across the terminals of this circuit is 170 V, 50 Hz. An ammeter is…

A: Given: A circuit,  Supply voltage across the terminals is 170 V, 50 Hz. An ammeter is connected to…

Q: 208 Volt, 10 HP, single pole number 4, 60 Hz, star- connected asynchronous motor, full load slip…

A: Given data, Supply voltage V = 208 V. Number of poles P = 4. Frequency f = 60 Hz. Output power…

Q: Q. 13. When a bank of capacitors is disconnected from the power system, interruption takes place A)…

A: When a bank of capacitors is disconnected from the power system, interruption takes place when A)…

Q: 5) Calculate the value of current and voltage in circuit below? 12V 5ΚΩ Ge 1₁ 5ΚΩ 1.5ΚΩ Si GsAs Vo…

A:

Q: You are tasked to characterize a certain AC circuit by specifying its Thevenin equivalent.…

A: The detailed solution is provided below.

Q: 3.5 The current i in the circuit of Fig. 3.48 is: (a) -2.667 A (b)-0.667 A (c) 0.667 A (d) 2.667 A…

A: Given: A series network with two resistor and two independent voltage sources. To find: Current i…

Q: Parameter name Voltage source A with ground as reference Voltage source B with ground as reference…

A: We need to find the system power factor (pf).

Q: 9+w=-3 What is the value of w in this equation

A: it is asked to find the w in given equation