ew1 A Zener diode is connected in parallel to a 1k ohm load. The combination is connected in series to a resistor. The wholecombination is connected to a15 volts supply. What value of R is required so that there is voltage regulationWhat is the power rating of R?R+15VVzо а. 1.5K, 0.6 wattsb. 1.5K, 0.410 wattsС.none of thesed. 1.5K, 0.054 watts• e. 1K, 0.014 watts A coupling capacitor isa. an AC open• b. a DC short and an AC open• c. a DC shortO d. a DC open and an AC short• e.none of these

Answered: Image /qna-images/answer/29060dee-cf5a-404f-9e36-8fc81f9c7311.jpg

Answered: What is the power rating of R? +15V Vz…

What is the power rating of R? +15V Vz 1.5K, 0.6 watts b. 1.5K, 0.410 watts С. none of these d. 1.5K, 0.054 watts e. 1K, 0.014 watts

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: PR4 i 352.94mA PR1 v 30.000V R1 V1 102 30V PR2 v 26.471V R2 PRa v 17.647V R3 502

A: THEY ARE CONNECTED IN SERIES. WHEN RESISTANCES ARE CONNECTED IN SERIES THE CURRENT THROUGH THEM…

Q: a- what is the physicalmeaning of system instability? b- All other things being equal, is a system…

Q: Write the expression for an AM voltage wave with the following values: Unmodulated carrier = 20 V,…

Q: HW1: let us determine H at P (4,0,5) in the field of an 6-A filamentary current directed inward from…

Q: Determine the minimum bandwidth (in KHz) for a binary FSK signal with a mark frequency of 63 kHz, a…

A: Given: Mark frequency, fm=63 KHzSpace frequency, fs=82 kHzInput bit rate, fb=2 kbps=2000 bps…

Q: A cold junction of a themocouple is at room temperature of 83°C. A voltmeter connected to the…

A: The solution is given below

Q: An amplifier has a power gain of 20dB, What willI be its output power in dBm if its input is 10dBm?…

A: We need to find out output power and voltage for given circuit

Q: concept of pure inductive circuit

A: Given: Pure inductive circuit

Q: 3. A unity feedback system with forward transfer function G(s) = 1/[s?(s+1)] is subjected to an…

A: In this question, We need to determine the steady state error If input is given and feedback is…

Q: 11. What is the reactance of a 7-pF capacitor at 2 GHz? 12. What value of capacitance is required to…

Q: 2. Find the inverse Fourier Transform of X (w) with the magnitude and phase spectrum below. |X(w)|…

Q: What is the one-bit half adder's purpose? What is the total number of inputs and outputs? What logic…

Q: circuit components. A three-input CML XOR gate using BJTS (bipolar junction transistors) is shown…

A: In this question we will write about list of electrical circuit components....

Q: What would the resonant frequency of a Wien bridge circuit be if the resistors are 400 KQ and…

Q: Home Work 2 62 Find V(t),wc(0) 24 V 120 42 Answer: 8e2 V, 5.33 J. ww

Q: Q. In the circuit shown below, measurement indicates V, to be +1.0 V and V, to be +1.7 V. What are a…

A: The solution is given below

Q: Question 1 Is the FSM a Mealy or Moore machine? Choose '0' for Mealy and '1' for Moore. Reset So…

Q: Determine the ampacity of a No. 8 AWG copper conductor with THHN insulation that will be used in a…

A: Given: Conductor size no.=8 AWGInsulation type=THHNConductor type=CopperAmbient temperature not…

Q: Q 6(a) Derive state-variable equations for the circuit in Figure 6, showing all steps clearly and…

A: 6a)

Q: Required: and total complex power j4 02 Z15", A -j2 IZz=3

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalized radiation…

Q: How do you define an IC, for short?

A: Integrated Circuit: An integrated circuit is a small semiconductor-based electronic device which…

Q: A friend supplies you with a filter with a difference equation of y[n] = x[n] + 0.8y[n-1]. Your…

Q: A certain electrical element draws the current i(t) = 119 cos 4t A at a voltage v(t) = 119 cos 4t V.…

A: In this question, We need to determine the energy E if voltage and current are given for time t= 2s…

Q: Briefly, write the advantages and disadvantages of Delta Modulation ? .Note( Don't copy and paste…

A: Given, Question related to Delta modulation. Please find the below attachment for the clear…

Q: 2. A discrete-time signal x[n] is shown in Fig. Q2. Sketch and label each of the following: a) x1[n]…

Q: For the circuit shown in Figure 1, answer the following questions: D1 - Y A D2 Figure 1 i. Explain…

A: For the circuit shown in fig. 1 answer the following questions. Working of circuit for different…

Q: Step 2: Karnaugh Map Grouping •Circle Groups to provide the simplest solution (bigger is simpler) CD…

Q: 2. Compute the Band width of FM for each steps

A: The solution is given below

Q: Explain briefly about the the circuit diagram and explanation of the analysis of equations.

A: In this question we will explain briefly about circuit diagram of unity follower....

Q: 2. Compute the Band width of FM for each steps

A: The solution is given below

Q: Find ww 12 2 Vỵ, Vc, lo Answer: 45e-0.251 V, 15e-0.251 V, -3.75e -0.251 A. Him

A: The solution is given below

Q: A series RL circuit with R=50 Ohms and L=10 H has a constant voltage V=100 V at t=0 by closing of a…

Q: 2.11. The normalized radiation intensity of a given antenna is given by (d)U=sin²0 sin Ø The…

A: The solution is given below

Q: Express the diagram to boolean expression

A: This question belongs to digital electronics . It is based on the concept of Boolean expression by…

Q: Find the auerage and rims values for signal, the below 6.

A: In this question, We need to calculate the average value and rms value of the given waveform.

Q: Consider the following network. If you are given that the Thévenin Equivalent of this circuit has…

Q: 20. Determine the current I. а. 4.10A b. 2.14 A 3 kΩ C. 2.10 A 5A 2 kn 3 kΩ d. 1.14 A 3 kn 3 kN

Q: The primary and secondary windings of a 500 kVA transformer have resistances of 0.44 Ω and 0.0027 Ω,…

A: The solution is given below

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalized radiation…

A: The solution is given below

Q: 4. On what variable of the information signal does the distains of the side band ocillation

A: FREQUENCY MODULATION (FM): FM is a way of coding the data on the signal (such as analogue signal or…

Q: In the figure the ideal batteries have emfs ɛ1 = 20.4 V, ɛ2 = 9.05 V, and ɛ3 = 5.40 V, and the…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: HW1: let us determine H at P (4,0,5) in the field of an 6-A filamentary current directed inward from…

Q: 4. On what variable of the information signal does the distains of the side band oscillation

Q: F-A'B'C'D'+A'BCD'+AB'C'D'+ABC'D It is found that the circuit input combinations A'B'CD', A'BC'D',…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: Required: average and effective values of the given i(t) (A) 10 2 4 6 8 10 12 14 t(s)

Q: The average output voltage is found from T/2+a T/2+a 3 3 Vac = Váe V3 Vm sin ( wt + d(ot) 6. Vab d (…

Q: 4- Describe the effect of increasing the clock frequency on the integrator output in the DM system.…

A: Please find the detailed solution in below images

Q: Vo RL Vin 5Ve -2V Find Vout and draw sub: alteranating current AC circuts

A: In this question, We need to draw the output voltage waveform if input waveform is given. Assume…

Question

100%

ew1

A Zener diode is connected in parallel to a 1k ohm load. The combination is connected in series to a resistor. The whole
combination is connected to a15 volts supply. What value of R is required so that there is voltage regulation
What is the power rating of R?
R
+15V
Vz
о а. 1.5K, 0.6 watts
b. 1.5K, 0.410 watts
С.
none of these
d. 1.5K, 0.054 watts
• e. 1K, 0.014 watts

A coupling capacitor is
a. an AC open
• b. a DC short and an AC open
• c. a DC short
O d. a DC open and an AC short
• e.
none of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

4 Listed are some of the uses of capacitors except: A. couples AC B. bypassing a shunt load C. signal amplification D. filters pulsating DC
A step down converter is feeding an inductive load with R-10 Ohms, L15 mH and E-1sV. The supply is Vs-200v, the switching frequency is 10 kHz and the duty cycle is k-0.5. The maximum peak to peak ripple current in the load is equal to 0.34A. The erage load current la would be equal to: Select one: a. 8.5A O b. 18A Oc 11A O d. None of these
An unipolar PWM full bridge circuit has a Vr.rms of 125V at a duty cycle D1 of 0.7. What is Vd? What is Vo.rms?
Boost Converter Design A boost converter is required to have an output voltage of 8 V and supply a load current of 1 A. The input voltage varies from 2.7 to 4.2 V. A control circuit adjusts the duty ratio to keep the output voltage constant. Select the switching frequency. Determine a value for the inductor such that the variation in inductor current is no more than 40 percent of the average inductor current for all operating conditions. Determine a value of an ideal capacitor such that the output voltage ripple is no more than 2 percent. Determine the maximum capacitor equivalent series resistance for a 2 percent ripple.
A three-phase bridge rectifier of Figure below has a purely resistive load of R 40 2 and is supplied from a 280-V, 60-Hz source. The b primary and secondary of the input transformer are a Primary + b Secondary ic Van in D₁D3 D5 D4D6D₂ 0₂ connected in Y. Determine the average output voltage of the rectifier if the source inductances are negligible.
What is unit step signal
6. The R-C circuit has a resistance of 100 ohms and a capacitive reactance of 150 ohms are connected in series across a A.C. voltage source. If a current of 0.9 A is flowing in the circuit determine (a) Power factor (b) Active power (c) Reactive power.
In the full-wave rectifier circuit of figure, the transformer has a turns ratio of 1:2. The transformer primary winding is connected across an AC source of 230V (rms), 50 Hz. The load resistor is 50ohms. For this circuit, determine the peak-to- peak ripple in the output voltage * Di i v2 = VmSin ot RL Vs(N V1 Vo + V3 = VmSin ot D2 Full-wave rectifier- Circuit operation during positive half cycle 460 V 207 V 325.3 V None of the above ell ell
An R-L load is connected to a 250 V, 400 Hz step down dc converter. The average load current is 100 A. The load resistance is 0.5 Ohm. The allowed ripple limit is 15%. The minimum value of inductor to limit the maximum ripple current is:
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A chopper circuit works at a frequency of 4 kHz of a 220 V dc supply. For 180 V output voltage, find the conduction and blocking periods of a thyristor in each cycle. Select one: a. 0.209 ms, 0.234 ms b. 0.404 ms, 0.055 ms c. 0.204 ms, 0.045 ms d. 0.704 ms, 0.897 ms
this is electric circuit questin ...plz solve it early .plz solve early