Continuation from Question no. 3: Determine the horizontal reaction at C. B 76.33 KN 75.33 KN 74.33 KN 73.33 KN None of the above A 40kN C 55kN 30kN 15m B F 20m 10m 10m 10m 10m

Q: P5 The pin-connected structure shown in the figure consists of a rigid beam ABCD and two supporting…

A:

Q: 4-73. The ends of the triangular plate are subjected to three couples. Determine the magnitude of…

A: Given :

Q: Three pipes steadily deliver water to a large exit pipe in the figure. The velocity v2 = 5 m/s, and…

A:

Q: The test driver for the Tar Foot drag racing team rests his coffee cup on the dashboard of his…

A:

Q: Calculate the specific gravity of the soil solids. A hand-carved sample of soft saturated clay…

A: Given, weight of saturated clay =350gvolume of sample=200ccweight of oven dryed clay =240 g

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions need to be solved.…

Q: 7-21. The steel rod is subjected to a shear of 30 kip. Determine the shear stress at point A. Show…

A: Given data:- The steel rod is subjected to a shear of, =30 kip The moment of inertia of the circular…

Q: 1.    A steel shaft is subjected to the torques shown. The shaft is solid with a diameter of 1 in…

A:

Q: Using the Portal Method, determine the Moment Reaction at point B of the given Frame. Answer should…

A: consider shear force in internal columns twice those of outer ones.

Q: an

A:

Q: Determine the horizontal reaction at C. A 76.33 kN B) 75.33 KN C) 74.33 KN D) 73.33 KN None of the…

A: Given data

Q: Many have suggested that OSHA penalties are weak and misdirected (aimed at employers rather than…

A: Following is required answer :

Q: Two wastewater streams A and B, having an identical ultimate BOD are getting mixed to form the…

A:

Q: Question 2 Each member of the truss shown is made of steel and has the cross-sectional area shown.…

A: Castigliano's Theorem : Alberto Castigliano who is an Italian engineer developed a method of…

Q: In a typical 3 hours storm producing 60 mm runoff from a basin and its flow ordinate are presented…

A: Given data: Time (Hour) Flow (cum/sec) 0 0 3 1220 6 4060 9 6750 12 5670 15 4500 18…

Q: Valuation of real properties may be done in many ways. [S1] We expect that on a per-square-foot…

A: Explanation : Statement 1 : The valuation will be different for large and smaller building when it…

Q: The following statements about vertical curves is TRUE, except? O A. The value of the algebraic…

A: - A. Sag curves, where change in grade is positive for example valleys. On other hand, crest curves…

Q: Why are dual-frequency and GNSS receivers preferred for high-accuracy control stations?

A: Dual frequency GNSS:- Dual-frequency GNSS belongs to the monitoring of several radio signals from…

Q: Determine the value of a so that the slope at A is equal to zero. Use P = 10kN, L = 10 meters, and…

A: The given beam is shown below: P=10 kNL=10 mEI=constant

Q: The water depth upstream of a sluice gate is 0.8 m and the depth just downstream (at the vena…

A: Given :

Q: Situation 4: A uniform 80-m pipe that weighs 960 kN is supported entirely by a cable AB of…

A:

Q: Find the reaction at both supports. 11. Identify the maximum moment. 12. Determine the maximum…

A:

Q: A water main 160 cm dia. contains water at a pressure head of 200 m. Take weight of water to be 1000…

A: The given data is: Diameter=160 cm Pressure head=200 m Permissible stress=400 kg/cm2

Q: Calculate the bending stresses in the beam using the transformed area method. Use a concrete…

A: Given values: b = 14 in D = 24 in Area of steel bars, 6#9 bars = 1 in2 * 6 = 6 in2 n =8 M = 110 ft-k…

Q: Determine the x, y, and z-coordinates of the mass center of the body constructed of three pieces of…

A:

Q: Three reservoirs are connected in a common junction. Following are the pertinent information:…

A: Reservior-1ZA=90 mL1=1800 mD1=0.4 mf1=0.02Reservior-2ZB=50 mL2=2000 mD2=0.5…

Q: Problem 4. The pipe bend is in a horizontal plane. Oil (s = 0.88) enters the bend with a velocity of…

A:

Q: 2m WIDE PI 3m Find the magnitude of the hydrostatic force. a. 146.7 kN b. 199.3 kN Im 4m c. 294.3 KN…

A:

Q: A 3% ascending grade meets a descending grade at the vertex at sta. 20+100 and at elevation 120 m.…

A:

Q: How many cubic metres of soil having void ratio of 0.7 can be made from 30m3 of soil with void ratio…

A: Given data: Void ratio = 0.7 Made from 30 m3 of soil Void ratio = 1.2  How many cubic meter of soil…

Q: VA1 6.345 m/s 60⁰ A B k = 100 N/m A 1-kg ball A strikes a 2-kg plate B that is supported by a…

A:

Q: Determine the slope at point C of the given beam. Use E = 200 GPa, I = 6(106) mm4

A: Given data  E = 200 GPA = 2 × 105 N/mm2  I = 6 × 106 mm4

Q: B.S Q3). Two points of A and B on opposite bank of a river, the level was setup near A and staff…

A:

Q: Design the concrete mix according to the following conditions:Design EnvironmentPavement slab,…

A: Mix design as per ACI:211 Assume 1% of the result is allowed to fall below the minimum compressive…

Q: It is the main reason why there is a deflection in the beam. A. Torsion B. Shear Force C. Bearing…

A: Beam Deflection- Deflection is the degree to which a particular structural element can be displaced…

Q: The truss in the figure is loaded by four external forces as shown below. Knowing that P1= 3 kN,…

A: Using the method of sections, determine forces on members GF,GC, CD. Using the method of sections,…

Q: Problem 5 The beam shown below is subjected to unfactored service live loads, Pui and w₁. Neglect…

A:

Q: Calculate what is the size of water tank for 30000 university students?

A:

Q: Q1/ For the footing shown in Figure (1). estimate the pile group capacity. 0.6m dia bored pile Clay…

A: Ultimate load carrying capacity of pile: It is the maximum load which can be applied on pile without…

Q: m) that should carry a load of 3600kN, what is the estimated settlement of the

A:

Q: LEED design innovation credits may apply if the designer can demonstrate the structure has unique…

A: A foundation for green buildings that are healthful, effective, low-emission, and economical are…

Q: 2

A: Given:- 4-16mm diameter  Es=200GPa P=5kN To find:- Cable DE force resultant reaction at base of beam…

Q: A 200 mm wide concrete block wall carries a vertical dead load of 120 kN/m and a verticallive load…

A: Given data:- Width of concrete block wall = 200 mm Vertical dead load = 120 kN/m  Vertical live load…

Q: Find the vertical and horizontal displacement at point C using the CASTIGLIANO THEROEM (de) v = ?)…

A: Given data:

Q: As a natural grown material, the properties of timber are orthotropic resulted in the strength of…

A:

Q: 19 In how many minutes after 7:00 PM will the hands the hands be directly opposite to each other for…

A: We have to asked how many minutes after 7.00 pm will the hand the hand be directly opposite to each…

Q: From Figure 1 shown below, Determine the following (Absolute value): A Than 5.00 meter W- 37.09-…

A:

Q: 6.59 A square section as shown in the figure below is subjected to bending moment M. y (c) Obc = %bl…

A:

Q: The data from a falling head test is shown. Diameter of standpipe: 6 cm. Initial Head: 94.49 cm.…

A:

Q: What is the percentage of sand in SOIL B?

A: Given Percent passing from sieve  Required  Percentage of sand in soil B

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.