Consider the solubilities of a particular solute at two different temperatures. Temperature (*C) Solubility (g/100 g H,O) 20.0 45.9 30.0 68.7 Suppose a saturated solution of this solute was made using 70.0 g H,O at 20.0 °C. How much more solute can be added if the emperature is increased to 30.0 °C? mass:

Consider the solubilities of a particular solute at two different temperatures. Temperature (*C) Solubility (g/100 g H,O) 20.0 45.9 30.0 68.7 Suppose a saturated solution of this solute was made using 70.0 g H,O at 20.0 °C. How much more solute can be added if the emperature is increased to 30.0 °C? mass:

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter12: Solutions

Section: Chapter Questions

Problem 12.55QE

See similar textbooks

Similar questions

For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Oxygen gas in water with P = 1 atm and T = 10C Oxygen gas in water with P = 1 atm and T = 20C b. Nitrogen gas in water with P = 2 atm and T = 50C Nitrogen gas in water with P = 1 atm and T = 70C c. Table salt in water with P = 1 atm and T = 40C Table salt in water with P = 1 atm and T = 70C d. Table sugar in water with P = 3 atm and T = 30C Table sugar in water with P = 1 atm and T = 80C
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
The freezing point of a 0.21 m aqueous solution of H2SO4 is -0.796C. (a) What is i? (b) Is the solution made up primarily of (i) H2SO4 molecules only? (ii) H+ and HSO4- ions? (iii) 2H+ and 1SO42- ions?
A sample of aluminum sulfate 18-hydrate, Al2(SO4)3. 18H2O, containing 125.0 mg is dissolved in 1.000 L of solution. Calculate the following for the solution: a The molarity of Al2(SO4)3. b The molarity of SO42. c The molality of Al2(SO4)3, assuming that the density of the solution is 1.00 g/mL.
A sample of potassium aluminum sulfate 12-hydrate. KAl(SO4)212H2O, containing 101.5 mg is dissolved in 1.000 L of solution Calculate the following for the solution: a The molarity of KAl(SO4)2. b The molarity of SO42. c The molality of KAl(SO4)2, assuming that the density of the solution is 1.00 g/mL
A compound has a solubility in water of 250 mg/L at 25C. Should this compound be characterized as a soluble or insoluble compound at 25C?
The solubility of ammonium formate, NH4CHO2, in 100. g of water is 102 g at 0 C and 546 g at 80 C. A solution is prepared by dissolving NH4CHO2 in 200. g of water until no more will dissolve at 80 C. The solution is then cooled to 0 C. What mass of NH4CHO2 precipitates? (Assume that no water evaporates and that the solution is not supersaturated.)
Simple acids such as formic acid, HCOOH, and acetic acid, CH3COOH, are very soluble in water; however, fatty acids such as stearic acid, CH3(CH2)16COOH, and palmitic acid, CH3(CH2)14COOH, are water-insoluble. Based on what you know about the solubility of alcohols, explain the solubility of these organic acids.
Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:
Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur when 65.0 g LiCl is present in 100 g H2O at 40 C? Explain your answer. (b) Consider a solution that contains 95.0 g LiCl in 100 g H2O at 40 C. Is the solution unsaturated, saturated, or supersaturated? Explain your answer. (c) Consider a solution that contains 50. g Li2SO4 in 200. g H2O at 50 C. Is this solution unsaturated, saturated, or supersaturated? Explain your answer. Figure 13.10 Solubility of ionic compounds versus temperature.
A patient has a “cholesterol count” of 214. Like manyblood-chemistry measurements,this result is measured inunits of milligrams per deciliter (mgdL1). Determine the molar concentration of cholesterol inthis patient’s blood, taking the molar mass of cholesterolto be 386.64gmol1. Estimate the molality of cholesterol in the patient’sblood. If 214 is a typical cholesterol reading among men inthe United States, determine the volume of such bloodrequired to furnish 8.10 g of cholesterol.
Maple syrup sap is 3% sugar (sucrose) and 97% water bymass. Maple syrup is produced by heating the sap toevaporate a certain amount of the water. (a) Describe what happens to the composition and boilingpoint of the solution as evaporation takes place. (b) A rule of thumb among maple syrup producers is thatthe finished syrup should boil about 4 C higher than theoriginal sap being boiled. Explain the chemistry behindthis guideline. (c) If the finished product boils 4 C higher than the originalsap, calculate the concentration of sugar in the finalproduct. Assume that sugar is the only solute and theoperation is done at 1 atm pressure.