Consider the following equilibrium at 298 K. R = 8.314 J/K-mol Citrate <=> Isocitrate Using the equilibrium concentrations of [Citrate] = 2.15 M and (Isocitrate] = 0.00825 M, calculate K'eg, then AG. Which one of the following is the correct value for AG in units of kJ/mol? 5990 kJ/mol -2480 kJ/mol 2.48 kJ/mol 13.8 kJ/mol 5.99 kJ/mol -2.48 kJ/mol -5990 kJ/mol -9.99 kJ/mol -13800 kJ/mol 13800 kJ/mol -5.99 kJ/mol 9.99 kJ/mol 2480 kJ/mol 9990 kJ/mol -13.8 kJ/mol -9990 kJ/mol OO 0 0 O 000

Consider the following equilibrium at 298 K. R = 8.314 J/K-mol Citrate <=> Isocitrate Using the equilibrium concentrations of [Citrate] = 2.15 M and (Isocitrate] = 0.00825 M, calculate K'eg, then AG. Which one of the following is the correct value for AG in units of kJ/mol? 5990 kJ/mol -2480 kJ/mol 2.48 kJ/mol 13.8 kJ/mol 5.99 kJ/mol -2.48 kJ/mol -5990 kJ/mol -9.99 kJ/mol -13800 kJ/mol 13800 kJ/mol -5.99 kJ/mol 9.99 kJ/mol 2480 kJ/mol 9990 kJ/mol -13.8 kJ/mol -9990 kJ/mol OO 0 0 O 000

Human Physiology: From Cells to Systems (MindTap Course List)

9th Edition

ISBN:9781285866932

Author:Lauralee Sherwood

Publisher:Lauralee Sherwood

Chapter3: The Plasma Membrane And Membrane Potential

Section: Chapter Questions

Problem 1SQE: Using the Nernst equation, calculate the equilibrium potential for Ca2 and for C1 from the following...

See similar textbooks

Similar questions

For the following results of Thermodynamics of Borax Solubility, the volume of Borax solution titrated by HCI is 8.00 mL. Table 1. Volumes of hydrochloric acid required to titrate a saturated borax solution at varying temperatures. The hydrochloric acid was a solution standardized at 0.2912 M. Borax Volume added (mL) Temp. (°C) 8.00 8.00 8.00 8.00 8.00 HCI Volume (mL) 50.5 33.75 40.7 27.02 30.0 17.95 20.2 13.43 10.3 8.55 Using Thermodynamic formula (R= 8.31 J/K•mol) and the above results, (d) AH˚ = (kJ/mol) Type your answer....
For the following results of Thermodynamics of Borax Solubility, the volume of Borax solution titrated by HCI is 8.00 mL. Table 1. Volumes of hydrochloric acid required to titrate a saturated borax solution at varying temperatures. The hydrochloric acid was a solution standardized at 0.2912 M. Borax Volume added (mL) Temp. (°C) 8.00 8.00 8.00 8.00 8.00 HCI Volume (mL) 50.5 33.75 40.7 27.02 30.0 17.95 20.2 13.43 10.3 8.55 Using Thermodynamic formula (R= 8.31 J/K•mol) and the above results, (e) AS° = (J/K⚫mol) Type your answer...
For the following results of Thermodynamics of Borax Solubility, the volume of Borax solution titrated by HCI is 8.00 mL. Table 1. Volumes of hydrochloric acid required to titrate a saturated borax solution at varying temperatures. The hydrochloric acid was a solution standardized at 0.2912 M. Borax Volume added (mL) Temp. (°C) 8.00 8.00 8.00 8.00 8.00 HCI Volume (mL) 50.5 33.75 40.7 27.02 30.0 17.95 20.2 13.43 10.3 8.55 Using Thermodynamic formula (R= 8.31 J/K⚫mol) and the above results, (b) What is the y-intercept of the best fitting line for this data? Type your answer...
In vitro experiments are conducted at pH = 7.4 to simulate physiological conditions. A phosphate buffer system is often used. H₂PO → H₂PO¹²¯ +H+ pK₁ = 7.2 a. What must be the ratio of the concentrations of HPO to H₂POд ions? b. What mass of NaH2PO4 must be added to 500.0 mL of 0.10 M Na₂HPO4 (aq) in the preparation of the buffered solution?
Given that the relative molecular mass of potassium chloride (KCl) is 74.5513 g mol-1, calculate the concentration of potassium chloride solution which will be iso-osmotic with tears (305 mOsM). State your answer in both molar concentration (mol/L) and in percentage (g/100 mL). Please answer very soon will give rating surely
Calculate the unknown concentration of the PROTEIN C with an absorbance value of A412 given the standard curve indicated in the table below. Write your final answer (NUMBER ONLY) in two decimal places rounded off. Protein concentration (µg/mL) 0 0.02 0.04 0.06 0.08 0.10 Your answer APIENT Absorbance 0.000 0.161 0.284 0.438 0.572 0.762
The protein calcineurin binds to the protein calmodulin with an association rate of 8.9 × 103 M−1 s −1 and an overall dissociation constant, Kd, of 10 nM. Calculate the dissociation rate, kd , including appropriate units.
If we were handed a tuke of 2mg/mL BSA how much is required 20μL of each of the following Concentrations? to make zoul total bring up to volume with dH ₂0 @ 01125 mg/mL (1) 0,150 mg Ⓒ 0.50 mg/mL @ 0.75 mg/mL Ⓒ 1.0mg/ml /ML Can it be solved using C₂ C₁V₁ = C₂ V₂ If CI= V₁ yes, please show work. Vz
i) Write down the equation derived from your Excel generated standard curve and describe its components; ii) provide the values of the absorbance data of the unknown sample (do NOT show the absorbance data of the glycine standards). Show all details of the working out of your calculation. Indicate all units! Provide the answer with two decimals precision iii) state the answer in a full sentence. (note: avoid mathematical symbols [=, +, -, etc] in your answer sentence).
Calculate the concentration of an EDTA solution of which 24.22 mL were needed to titrate the Ca2+ions present in a 50.00 mL solution containing 246.7 mg CaCO3. Express your answer in terms of (a) molar concentration of EDTA (b) Ca Titer (mg Ca per mL of EDTA) MM Ca= 40.078 solve it in a way that it is in one equation already and cancelling all the values just like given in th epicture
Convert the experimental glucose concentration provided in below from mM (millimolar) to g/100 mL. Glucose Concentration is in mM 1.927 mM. ● Take the 1/100 dilution factor into consideration ● M will open the doors for you to get to g. ● Once at M assume 1L of solution. (Hint: this will help you when converting from M to moles) ● You will also need to calculate the molar mass of glucose which has the formula C6H12O6
1 Gren: molanty of CsP stlutan -010M = 0.10mol/L vdm me of SoutoL molar mass of csp= 249.68 g/ mole %3D moles af CSP = molahty of CSPX volume of shreoon mdes of asp = 0.10 mol/xIL moles of cSp: 0-10 mol mass of csP-moles of CSPXmolar mass of CsP = 0.10mol X249.c689/mde mass of CSP= 24.9689