Consider the data generated from a constant pressure filtration conducted at 200 kPa. Suppose the filtrate has a viscosity of 0.02 Pa-s and the slurry has a specific cake resistance of 3.61 x 108 m/kg and a concentration of 10 kg/m³, find the total filter area in m². Round off your answer to two decimal places. Show the graph as well Time Elapsed (min) 0 0.67 1.21 2.76 5.1 8.51 11.62 Cumulative volume collected, m³ 0 1.82 3.01 5.72 8.51 12.05 14.92

Consider the data generated from a constant pressure filtration conducted at 200 kPa. Suppose the filtrate has a viscosity of 0.02 Pa-s and the slurry has a specific cake resistance of 3.61 x 108 m/kg and a concentration of 10 kg/m³, find the total filter area in m². Round off your answer to two decimal places. Show the graph as well Time Elapsed (min) 0 0.67 1.21 2.76 5.1 8.51 11.62 Cumulative volume collected, m³ 0 1.82 3.01 5.72 8.51 12.05 14.92

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The traffic volume data table below counts was taken on rural a highway during the morning peak hour at (8:00-9:00 am) on Monday of a week. Time periods (minute) 8:00-8:15 AM 8:30-9:00 AM Number of vehicles 385 790 The average time headway (sec) during 8:00-9:00 am 2.25 a) Find the traffic volume for the period from 8:15 to 8:30 am. b) Determine the hourly volume (HV), the maximum rate of flow within the hour, and the peak hour factor (PHF). c) Estimate the density and speed of traffic if an average spacing of 150 ft. d) Estimate the daily volume for Monday if the hourly expansion factor (HEF) is 22.05.
A circular pipe 50 meters long tapers from 3 m to 2 m in diameter. What is the velocity per meter run at the bigger section, if the velocity there is 44 mps, and the fluid is flowing from the larger section to the smaller section? Round-off answer to the nearest hundredths.
Suppose you make the following sequence of measurements for the segments in laying out a compressed air line: 4.61 m 211 m 0.500 m What should be the reported total length of the air line? options: 216.1 216.110 220 216.11 216
Please show steps I keep coming up with -0.0044
56.0 mL of two different liquids are poured through a funnel with a narrow exit tube, and the time for all of the liquid to flow through is recorded. Here are some results: time to flow through funnel trial Liquid X Liquid Y 1.60 s 3.62 s 1.52 s 3.44 s 1.44 s 3.56 s Note: the two liquids have the same density. Which statement below is true about these liquids based only on the data in the table? O The intermolecular forces in liquid X are stronger than those in liquid Y. The boiling point of liquid X is higher than the boiling point of liquid Y. The viscosity of liquid X is greater than the viscosity of liquid Y. The surface tension of liquid X is greater than the surface tension of liquid Y. The viscosity of liquid X is less than the viscosity of liquid Y. 3.
Steam at a temperature of 240 °C has a specific volume of 0.15436 m3/kg. Determine pressure, specific internal energy, enthalpy and entropy. PLS REFER TO THE ATTACHED TABLE PLS SOLVE COMPLETE SOLUTION AND WRITE LEGIBLE. ROUND OFF ANSWER TO FOUR DECIMAL PLACES. USE LINEAR INTERPOLATION AND SHOW THE VALUES WHERE IT CAME FROM.
Good day. I require assistance as this will help in my examination review. (Basic Aerodyn Principles) A circular pipe 57 meters long tapers from 3 m to 2 m in diameter. What is the velocity per meter run at the bigger section, if the velocity there is 39 mps, and the fluid is flowing from the larger section to the smaller section? Round-off answer to the nearest hundredths. **Would gladly appreciate an explanation. Thank you.
5. An engineer is planning to use gabion retaining wall to protect a section of Kennon road from landslide. A gabion is a wire mesh container filled with rocks. The engineer must estimate the volume of the rock to be used. If the gabion wall will have a thickness of 5ft, estimate the volume of the rocks given the measured depth of the wall every 10 ft of its width based from the road level. width, ft 10 20 30 40 50 60 70 80 90 depth, ft 5 12 20 18 17 13 10 5 a.) estimate the area of the wall using multiple trapezoidal rule with n=9 b.) estimate the area of the wall using single application of Simpson's 3/8 rule c.) estimate the volume of the rocks to be used using the area in a.) and b.)
As we explained in earlier chapters, the air resistance to the motion of a vehicle is something important that engineers investigate. The drag force acting on a car is determined experimentally by placing the car in a wind tunnel. The air speed inside the tunnel is changed, and the drag force acting on the car is measured. For a given car, the experimental data generally is represented by a single coefficient that is called drag coefficient. It is defined by the following relationship: F, where air resistance for a car that has a listed C, = drag coefficient (unitless) measured drag force (N) drag coefficient of 0.4 and width of 190 cm and height of 145 cm. Vary the air speed in the range of 15 m/s
THERMODYNAMICS UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS/DIAGRAMS LEGIBLY. NO LONG EXPLANATION NEEDED. USE 3 DECIMAL PLACES. BOX THE FINAL ANSWER. A pump discharges into a semi spherical tank at the bottom and cylindrical on top with a radius of 2 meters, and a total tank height of 8 meters. The flow rate is 80 gallons per minute and fluid specific gravity= 1.1. Determine the following: A) flow rate in kg/sec and time it takes to fill the tank in hours. Flow Rate and Time
THERMODYNAMICS UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS/DIAGRAMS LEGIBLY. NO LONG EXPLANATION NEEDED. USE 3 DECIMAL PLACES. BOX THE FINAL ANSWER. A pump discharges into a semi spherical tank at the bottom and cylindrical on top with a radius of 2 meters, and a total tank height of 8 meters. The flow rate is 80 gallons per minute and fluid specific gravity= 1.1. Determine the following: A) flow rate in kg/sec and time it takes to fill the tank in hours. B) the weight in tons of the liquid if full tank local gravity is 32.1 ft/sec squared. C) volume of the tank in metric gallons. D.) how many drums will be needed to transfer all of the tank contents (tank being full) to the drums?
Actual lengths of stay at a hospital's emergency department in 2009 are shown in the following table (rounded to the nearest hour). Length of stay is the total of wait and service times. Some longer stays are also approximated as 15 hours in this table. Hours Count Percent 1 18 3.40 2 58 10.94 3 82 15.47 4 118 22.26 85 16.04 6 64 12.08 7 37 6.98 8 19 3.58 18 3.40 10 14 2.64 15 17 3.21 Calculate the mean and variance for the random variable (length of stay). Round your answers to two decimal places (e.g. 98.76). Mean = i Variance = i 5.