Consider an OFDM system in which 1000 subcarriers are each to be modulated at 1000 bits per second. Assume that each subcarrier is to be modulated using QPSK. (a) What is the symbol transmission rate? (b) How close can the subcarriers be spaced and still be orthogonal? (c) Assume that at least one subcarrier always carries QPSK symbols. What is the lowest data rate that can be supported by this scheme?

Consider an OFDM system in which 1000 subcarriers are each to be modulated at 1000 bits per second. Assume that each subcarrier is to be modulated using QPSK. (a) What is the symbol transmission rate? (b) How close can the subcarriers be spaced and still be orthogonal? (c) Assume that at least one subcarrier always carries QPSK symbols. What is the lowest data rate that can be supported by this scheme?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider an OFDM system with 192 subcarriers. The duration of the OFDM symbol including the cyclic prefix is 11.8 µs. Find the data rate, if the code rate is 1/2 and BPSK is used?
In ADSL, the OFDM symbol rate across all subcarriers is 4000 symbols per second. Assume that in the downstream direction, 25 subcarriers use 1024-QAM, 50 use 256-QAM, 100 use 64-QAM and 100 use 16-QAM. What is the overall bit rate
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. Assuming it is possible to combine several circuits, how many circuits does it take to keep the transmission time of a 1 Mbyte file below 15 seconds?
2. (a) In FDM, time synchronization is not necessary. Yes or No? Give proper reasons behind your answer. Write one example of TDM where extra information load (overhead) could be 300%.. (b) We need to use Time Division Multiplexing and combine 9 digital sources, each of 900 Kbps. Each output slot carries 9 bit from each digital source, but no extra bit is added to each frame for synchronization. Now, answer the following questions: i) What is the output frame duration? ii) What is the output frame rate? iii) What is the output bit rate? iv) What is the output bit duration? v) What is the size of an output frame in bits? vi) What is the input bit duration?
Consider a communication channel with bandwidth B = 8000 Hz. Suppose the channel has a signal-to-noise ratio S/N = 541. What is the maximum data rate of this channel? ? What is the minimum number of signal levels needed to achieve a data rate of 64000 bps?
Five Channels each with a 100 KHz bandwidth are to be multiplexed together using Frequncy division multiplexing(FDM) scheme.What is the minimum bandwidth of the link if there is a need for a guard band of 10 Khz between the channel to prevent interference?
In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in total in the system.What is the bandwidth for a single direction (user to base station) according to the information given above??
2. In FDM, if there are 8 input signals each requiring a bandwidth of 3 MHz, what is the minimum bandwidth required for the combined signal?
A voice channel occupies a bandwidth of 28 kHz 10 voice channels are to be multiplexed together using the FDM (Frequency Division Multiplexing) technique, considering a guard band of 12 kHz. Illustrate the configuration of the multiplexing and demultiplexing using the frequency domain with proper labeling.
Given a channel with an intended capacity of 20 Mbps, the bandwidth of the channel is 3 MHz. what signal-to-noise ratio is required to achieve this capacity?
06: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi (t), i 1,2,3, ...10. each signal has a band of 1 kHz. Consider all ten signals are multiplexed using the TDM technique after each signal is multiplied by the carrier illustrate below. What is the largest value of the time period in milliseconds? 27
Six channels, each with a 200 kHz bandwidth are to be multiplexed using FDM together. What is the minimum bandwidth requirement for the multiplexed path?