Complete the table below by deciding whether a precipitate forms when aqueous solutions A and B are mixed. If a precipitate will form, enter its empirical formula in the last column. solution A solution B Does a precipitate form when A and B are mixed? empirical formula of precipitate potassium carbonate lead(II) nitrate yes no ☐ barium bromide potassium chloride yes no ☐ sodium hydroxide iron(II) nitrate ○ yes no 0

Complete the table below by deciding whether a precipitate forms when aqueous solutions A and B are mixed. If a precipitate will form, enter its empirical formula in the last column. solution A solution B Does a precipitate form when A and B are mixed? empirical formula of precipitate potassium carbonate lead(II) nitrate yes no ☐ barium bromide potassium chloride yes no ☐ sodium hydroxide iron(II) nitrate ○ yes no 0

Introductory Chemistry: A Foundation

8th Edition

ISBN:9781285199030

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter7: Reactions In Aqueous Solutions

Section: Chapter Questions

Problem 16QAP

See similar textbooks

Similar questions

When 85.0 mL of 0.250 M Ba(OH)2 solution is added to 85.00 mL of 0.250 M Al (NO3)3 solution, a white gelatinous precipitate of Al(OH)3; is formed. Assuming 100% yield, (a) what mass (in grams) of Al(OH)3 is formed? (b) what is the molarity of each of the ions Ba2+, OH-, Al3+, NO3- in the resulting solution?
68. Aluminum ion may be precipitated from aqueous solution by addition of hydroxide ion, forming Al(OH)3. A large excess of hydroxide ion must not be added, however, because the precipitate of Al(OH)3 will redissolve as a soluble compound containing aluminum ions and hydroxide ions begins to form. How many grains of solid NaOH should be added to 10.0 mL of 0.250 M A1Cl3 to just precipitate all the aluminum?
Twenty-five milliliters of a solution (d=1.107g/mL)containing 15.25% by mass of sulfuric acid is added to 50.0 mL of 2.45 M barium chloride. (a) What is the expected precipitate? (b) How many grams of precipitate are obtained? (c) What is the chloride concentration after precipitation is complete?
According to the Resource Conservation and Recovery Act (RCRA), waste material is classified as toxic and must be handled as hazardous if the lead concentration exceeds 5 mg/L. By adding chloride ion, the lead ion will precipitate as PbCl2, which can be separated from the liquid portion. Once the lead has been removed, the rest of the waste can be sent to a conventional waste treatment facility. How many grams of sodium chloride must be added to 500 L of a waste solution to reduce the concentration of the Pb2+ ion from 10 to 5 mg/L?
Describe in words how you would prepare pure crystalline AgCl and NaNO3 from solid AgNO3 and solid NaCl.
The Handbook of Chemistry and Physics (http://openstaxcollege.org/l/16Handbook) gives solubilities of the following compounds in grams per 100 mL of water. Because these compounds are only slightly soluble, assume that the volume does not change on dissolution and calculate the solubility product for each. (a) BaSiF6, 0.026 g/100 mL (contains SiF62- ions) (b) Ce(IO3)4, 1.5102 g/100 mL (c) Gd2(SO4)3, 3.98 g/100 mL (d) (NH4)2PtBr6, 0.59 g/100 mL (contains PtBr62- ions)
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
42. a. Fill in the following table as if it is a well plate and you are mixing two aqueous compounds at a time to see if a precipitate forms. If a precipitate is expected to form, indicate that by writing the correct formula for the precipitate in the corresponding box in the table. If no precipitate is expected to form, write “NO” in the box. CaCI2 Pb(NO3)2 (NH4)3PO4 Na2CO3 AgNO3 K2SO4 b. How do you prepare 300.0 mL of a 0.250 M CaCl2 solution using an available 2(X) M solution? Support your answer with calculations, but also make sure you describe how to prepare the solution.
What mass of solid aluminum hydroxide can be produced when 50.0 mL of 0.200 M Al(NO3)3 is added to 200.0 mL of 0.100 M KOH?
The molarity of iodine in solution can be determined by titration with arsenious acid, H3AsO4. The unbalanced equation for the reaction is H3AsO3(aq)+I2(aq)+H2O2 I(aq)+H3AsO4(aq)+2 H+(aq)A 243-mL solution of aqueous iodine is prepared by dissolving iodine crystals in water. A fifty-mL portion of the solution requires 15.42 mL of 0.134 M H3AsO3 for complete reaction. What is the molarity of the solution? How many grams of iodine were added to the solution?
Name the reagent, if any, that you would add to a solution of iron(lll) chloride to precipitate (a) iron(lll) hydroxide. (b) iron(lll) carbonate. (c) iron(lll) phosphate.
On the basis of the general solubility rules given in Table 7.1, predict which of the following substances are not likely to be soluble in water. Indicate which specific rule(s) led to your conclusion. :math>PbSe. BaCO3 :math>Mg(OH)2f. AlPO4 :math>Na2SO4g. PbCl2 :math>(NH4)2Sh. CaSO4