coil has a resistance of 4 ohm and an inductance of 9.55 mH. Calculate the reactance, the impedance, and the current taken from a 240V, 50 Hz supply. Determine also the phase angle between the supply voltage and current.

coil has a resistance of 4 ohm and an inductance of 9.55 mH. Calculate the reactance, the impedance, and the current taken from a 240V, 50 Hz supply. Determine also the phase angle between the supply voltage and current.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Solve for the Vrms (magnitude only) across the resistance if R2 = 1093 ohms and Xc=2318 ohms. www не…

Q: Question 7: A 415V, three-phase, 50 Hz, 4-pole, star-connected induction motor runs at 24 rev/s on…

Q: The book says I should have found 46amps. Is this a misprint?

A: as the given explanation in the previous is correct.

Q: Use the circuit shown in the image. Compute only the current though the 20 ohm resistor. 140 A 0.50…

A: Given, The circuit is,

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: ISOTROPIC ANTENNA PROPERTIS No pre- specified direction of the radiated wave It can radiate in any…

Q: Determine T.F Y(S)/U(S) And Please use Proper Form to represent T.F Explain steps Briefly.

A: In this question, We need to determine the transfer function. We are solving this problem using…

Q: Im not sure if i am correct. I dont have any way to check my answers. Does this circuit not work…

A: The circuit can be analyzed by verifying the elements in the circuit that are open-circuited. The…

Q: B: Drive the radiation intensity equation of an isotropic antenna.

Q: Find the complement of the Boolean function F F(x, y, z)=x + yz Select one: O a. y'z O b. O c. x'y'…

A: Given, The Boolean function, Fx,y,z=x+yz.

Q: A magnetic circuit has a m.m.f. of 400 AT and a reluctance of 2 x 105 AT/Wb. The magnetic flux in…

Q: What are the modes of operations used in 8253?

Q: subtract 10012 from 10112

A: The given binary numbers are: 1001210112 The above number in decimals is represented as:…

Q: A communication channel has magnitude spectrum and phase spectrum defined as: H()=1 0h() = sin 2xƒT…

A: We need draw magnitude and phase response ,

Q: A 6-pole lap wound dc shunt motor has 60 conductors. The armature and shunt fields resistance are…

A: A self-excited DC motor with field windings connected parallel to the motor's armature winding is…

Q: - الترد وتم - Y(s) 2s+1 U(s)

Q: Q) Design a logic circuit with four inputs and one output that will produce "1" in the output only…

Q: discribe the key step in the design a Contral System

A: There are basically 4 step to design a desirable control system. The block diagram of the control…

Q: A DSB-SC modulation generates a signal y(t) = Acm(t) cos (wet+0). (a) Sketch the amplitude and phase…

Q: The values of Vmax and Vmin as read from an AM wave on an oscilloscope are 2.6 and 0.29,…

Q: A 50 Hz, 2 pole turbo generator rated 100 MVA, 33 kV has an inertia constant of 4 MJ/MVA. If the…

Q: Determine the overall transfer function for a control system shown below Input a. b. Y(s) 2 X(s) s-6…

A: Given, A closed loop system is shown below,

Q: Calculate the distribution factor of an alternator for a 36 slot, four poles, three phase winding of…

Q: R(s) G₁(s) G3(s) H(s) G₂(s) G4(s) C(s)

A: We need to find out the transfer function, loop gain and forward path and signal flow graph for…

Q: QUESTION 10 10V Figure 9.1 1292 12 Ω 15,4 Ω 3.4 Ω www 8 Ω 69 a www See Figure 9.1. What is the…

Q: How can the noise level of a photomultiplier detector be reduced below the level of shot noise? a.…

A: Photomultipler detectors Used to measure intensity of visible and UV radiation It can amplify the…

Q: 6.. The phase voltage of a 3-phase voltage source is 120 V. It is supplied to a star connected load…

A: Given data, The phase voltage of the 3-phase source is VP=120 V The impedance of the given balance…

Q: What is the number of turns of wire needed to provide a potentiometer with a resolution of 0.05…

Q: 2Α 6Ω 8 Ω (b) I get 3 Ω 4A

Q: Compute for the total resistance. Complete the table and provide solution in each. R1 = 430 ohms…

A: In this question, We need to determine the equivalent resistance. We know If two resistances R1…

Q: For the circuit shown R 200 V + 120 V { 24 Ω 2 {8n 8 Ω The current in Amperes at the 200 V source is…

A: Given circuit,

Q: sed on } s) Briefly compare major methods to generate AM signals. Also Communication Theories (CHs…

A: The method of amplitude modulation involves changing the amplitude of the wave signal before it is…

Q: Calculate the current through R₂. B 5.0 + amp I R₂ R₁ R₁ = 102 R₂ = 592 V = 15V

A: Given circuit, Where, R1=10 Ω.R2=5 Ω.V=15 V.

Q: A 3-phase, 50 Hz,2000 kVA, 2300 volt alternator gives a short circuit current of 600 A for a certain…

Q: Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of…

A: Given: Current, I1=I2=20A Distance, d=5×10-2 m

Q: N₁ = h(t) = [1-e-Ju(t) No = ? to find (t). 18 N Use the convolution theoren to find

Q: = √3Vm 5 α 1 + 24 4T -sin 8T Answer 3 1/2 + 2a 2a)]₁

Q: ?Why discriminators are important in FM To decrease the bandwidth To decrease the noise O To…

A: SOLUTION Why discriminators are important in FM? ANSWER To…

Q: Determine the frequencies for periodic times of 4 ms, 4µs

Q: Simplify the following Boolean function, F F(A, B, C) =A'C' + ABC + AC' Select one: a. AB + C' A +…

Q: Question 2 For a two pole-pairs, 50 Hz, 3-phase synchronous motor, the speed of rotor is 1450 rpm…

A: Given: A 3-phase synchronous motor has, Number of pole pair is 2. Frequency, f=50 Hz.

Q: For the circuit shown, the potential of point A is zero. Determine the potential of poir 2.00 Q A…

A: Here basic properties are applied to solve it.

Q: 1. With the looming energy crisis in our country, as a future electrical engineer what solution (in…

Q: an output voltage of 20V across a 1K0 load with an input that will vary between 30V and 50V. That…

A: The required resistance and the maximum current have been identified.

Q: A 12 Volt lead-acid car battery, engineered for "up to 500 or more charge/discharge cycles," has a…

A: Given: Lead Acid Car BatteryBattery voltage = 12vBattery Amp-hour = 225Battery Carge/Discharge cycle…

Q: Problem I VTh Thevenin via Terminal Measurements qvt [v] RTh a b Ve 100 →it [A] Tit Determine a) Van…

Q: :One kilowatt-hour is the power consumed by a 1kW- load during one hour.a None of the answers is…

Q: Question 4 A load within a circuit absorbs 3 kW of average power with a lagging power factor of 0.2.…

A: In this question, We need to determine the reactive power Q? If active power P= 3kW And power…

Q: What will be the equation for 50 cycles current sine wave having RMS value of 20 amperes? O a. i=…

A: Given: RMS value of current, irms=20 A. Frequency, f=50 cycles=50 Hz.

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: The definition of radiation intensity is power per unit solid angle, or the power incident on the…

Q: A 4-pole lap connected DC motor draws an armature current of 100 Amperes at 220 Volts. The motor has…

Question

A coil has a resistance of 4 ohm and an inductance of 9.55 mH. Calculate the reactance, the impedance, and the current taken from a 240V, 50 Hz supply. Determine also the phase angle between the supply voltage and current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A non-inductive resistor is connected in series with a coil across a 230V, 50Hz supply. Thecurrent is 1.8A and the potential differences across the resistor and the coil are 80V and 170Vrespectively. Calculate the inductance and the resistance of the coil, and the phase differencebetween the current and the supply voltage.
An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable resistor R and a capacitive reactance of 15 ohm across 100V , 50 hz supply. a. Solve for the frequency so that the magnitude of the inductive reactance is 2 times the magnitude of capacitive reactance. b. Solve for the value of R so that the total current I will be maximum.
The inductive reactance of a 0.06-H coil connected to a 120-V, 60-Hz source is?
When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1 A. When it is connected to a 100 V, 30-Hz, ac supply, the circuit current is 1.38675 A. Find the resistance and the inductance of the impedance coil.
A 2.5A current is flowing in a series circuit comprises of a coil with inductance 15mH and resistance 102 and a variable capacitor. The supply voltage is 120V at 60 Hz. Estimate the following: i. The capacitance and impedance. ii. Angle between supply voltage and current. ii. The reactive power consumed
A coil has a resistance of 75 ohms and an inductance of 1.4H. When the applied voltage is 240V, at what frequency is the current 0.3A? 87.67Hz 93.25Hz 92.34Hz 90.55Hz
An inductive impedance of 40 + j40 ohms is connected in parallel with a pure capacitor. What must be the reactance of the capacitor in ohms so that the total current is in phase with the supply voltage of 230V?
Aresistor and inductor are connected in parallel to a 120 volt, 60 Hz line. The circuit nas a current flow of 3 amperes. The resistor has a resistance of 72 2. What is the induc- tance of the inductor? gaiau cladi slgns ads
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
Q20. A circuit comprises a coil of inductance 15mH and resistance 102 in series with a variable capacitor. The supply voltage is 100V at 60 Hz. Determine: i. The value of capacitance needed to cause a current of 2.5A to flow in the circuit. ii. Angle between supply voltage and current. ii. Draw the phasor diagram