Change 303°K to degree Celsius and degree Fahrenheit
Q: . GLYCERIN (SP.GR. = 1.26 AND ABSOLUTE VISCOSITY OF 1.49 ?? − ? ) FLOWS THROUGH A RECTANGULAR…
A: To find Head loss per kilometer length of the pipe
Q: Differential vacuum pressure between A and B equal to 10 kPa, and diameter for A&B equal to 1 50mm…
A: From Manometric equation,PA - 1000×9.81×0.25 - 0.9×1000×9.81×0.20 = PB - 1000×9.81×(0.45 + y100)PA -…
Q: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…
A: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…
Q: Problem # 3 a. What difference in temperature from standard if neglect in use of a steel tape an…
A: Given: a) L=50m ∆L=0.01m alpha=0.0000116 m/m-oC b) L=50m ∆L= -0.015m alpha=0.0000116m/m-oC To find…
Q: A reservoir is being planned for Albuquerque, NM. The design evaporation is set as the critical…
A:
Q: Soll layers are shown as the right figure. Given: H2m, k 10 cmsec H:- 3m, k- 32 x 10 cmsec Hy=4m,…
A:
Q: 12. If an air/water vapour mixture starts at 30% relative humidity, and you add more water vapour to…
A: For questions 12, 13 In both the cases, If we keep temparature and moisture constant by changing…
Q: 2. Suppose the following atmospheric altitude versus temperature data have been collected:…
A:
Q: B. The system in Fig. 2-5 is at 20 °C. If atmospheric pressure is 101.03 kPa and the absolute…
A: Here we have assumed specific gravity of SAE 30 oil as 0.89.
Q: A- A pan was set up adjacent to a lake. The depth of water in the pan at the beginning of a certain…
A: Given data: initial depth of water in the pan (di) =195mm rainfall depth (dr) =45mm water removed…
Q: Assume three different water masses, with: Water mass A: T1=19oC, S1=20, depth 0-50m Water mass B:…
A: ASKED: To determine the temperature and salinity of the water column upon mixing. Given, For water…
Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…
A:
Q: A steel tape, known to be of standard length at 20°C, is used in laying out a runway 2500 m long.…
A:
Q: The average weather conditions are; Net radiation = 100 W/square meter = 25 deg. C Air Temperature…
A: Introduction- (c)Combined method- By combining the two procedures, the influence of numerous factors…
Q: 26. What displacement would an accumulator have to be in order to supply 10 gallons of fluid between…
A:
Q: On 24 January 2020, the observed climate data in NAIA data are: temperature 17°C, relative humidity…
A: Given data: T=17∘CRelative humidity=83%wind speed=0.9 m/spsychometric constant=66.5 Pa/∘C
Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…
A: The length of line measured = 746.22mThe standard length of tape at 20°C, l1 =50mThe average…
Q: ater surface with air temperature 22°C, relative humidity is 40% and wind speed is 3 m/s, all…
A: According to given data an open water surface with air temperature 22°C, relative humidity is 40%…
Q: For the given w/c ratio =0.40 and mixing water content%3D190 kg/m3 determine the
A:
Q: Which technique is applied in analysing fresh water aquifers free of thermotolerant contaminant in…
A: WHAT ARE FRESH WATER AQUIFERS: Aquifers are underground layers of rock that are saturated with…
Q: Hydrology Problem: A reservoir is being planned for Albuquerque, NM. The design evaporation is set…
A: Given data- Month- July Net radiation i= 361 ly/day Pressure = 838 mb. Max Temperature = 92°F Max…
Q: Problems: Q1/ The inner and outer surfaces of a 5-m 6-m brick wall of thickness 30 cm and thermal…
A: My dear Given data Dimensions of wall Thermal conductivity Temperature difference of surfaces.
Q: Which has the lowest water content? a. dew point at 20 C b. absolute humidity at 0.5 c.…
A: The dew point is the saturation temperature for water in air. A high relative humidity implies that…
Q: The average weather conditions are; = 100 W/square meter = 25 deg. C = 55% Net radiation Air…
A:
Q: with water) and connected with the meter at the inlet and at the throat, what would be the…
A:
Q: The ground at a particular location is covered with snowpack at – 0°C for a continuous period of…
A: Note:- Taking the temperature for the snowpack = –10°C, for -0°C the depth value = 0 Given:- The…
Q: asap pls 10 mins The volume of atmospheric water is 12669km3. The evapotranspiration from land is…
A: Volume=12669km3 To fund residence time in month
Q: 13. Estimate formation permeability and skin factor from the buildup test data given the following…
A: Skin factor: The skin factor is defined as the pressure drop in the flow caused due to the…
Q: A swimming pool (20ft x 20 ft x 5 ft) has a small leak out the bottom. Measurements of rainfall,…
A:
Q: A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is…
A:
Q: the gas oil ratio = 560 Scf/STB at initial pressure of 4300 psia, calculate the GOR at bubble point…
A:
Q: Which has the lowest water content? a. dew point at 20 C b. absolute humidity at 0.5…
A:
Q: Find the number of degrees in the angle formed by the two parts of thisA-type evaporator coil.
A: Given:- The two parts of the A-type evaporator coil are given To determine:- The number of degrees…
Q: rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…
A:
Q: topic: surveying A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded…
A:
Q: Evaporation pans provide an approximate estimate of (i)Evaporation from lakes (ii)Actual…
A: It is asked about the function of evaporation pans. Evaporation pans are installed in a catchment to…
Q: a. What difference in temperature from standard if neglect in use of a steel tape will cause an…
A: Answer To calculate the difference in temperature from standard based on the given data, we can use…
Q: 7. What is the default value of specific heat ratio in pipelines? a) 1 b) 1.2 c) 1.4 d) 2
A:
Q: Given: Open water source Net radiation = 200 W/m2 %3D Air temperature = 30 °C Density of water = 996…
A: Evaporation is generally the method that modifies the water from a liquid to a gas and also vapors.…
Q: a. Calculate the equivalent k in cm/sec. b. Calculate the rate of water supply in cm^3/hr c.…
A:
Q: 1. Because of elevation differences, the water pressure in the second floor of your house is lower…
A:
Q: If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what…
A: Given: The mass of the Al rod is 136.51 g. The specific heat of the Al rod is 0.9 J/ g°C. The…
Q: Problem 3.1. Compute the daily evaporation from water surface if the wind speed is 32 km/h (20mph)…
A:
Q: WATER RESOURCES ENGINEERING: Evaporation The temperature and relative humidity for the month of…
A: (a) It is required to determine the monthly evaporation from the lake. Here, EP is the evaporation…
Q: 4. Estimate the temperature at 1000 m given a surface temperature of 22 °C for a clear sunny day…
A: Surface temperature = 22• C Temperature required at 1000m or 1 km. Environment Lapse Rate(ELR) - It…
Q: Q2- Estimate the temperature of dry air at elevat sea level if the temperature on the ground 30 Cº ?
A:
Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…
A:
Q: 15mm of precipitation fell in Akkaya reservoir in July. At the beginning of July (30 days), the…
A: GIVEN DATA TOTAL PRECIPATION IN MONTH OF JULY=15 MM AREA OF RESERVOIR=3 KM2 WATER AVAILABLE BEFORE…
Q: 2.62 Water is at 20°C, and the pressure is lowered until bubbles are noticed to be forming. What…
A: Vapour pressure is the tendency of particles to escape from a liquid (or a solid). The temperature…
Q: Determine the minimum size of glass tubing that can be used to measure kerosene level if the…
A: given that Capillary rise (h) = 0.3 mm = 0.0003 mSurface tension (σ) = 0.459 N/mDensity of kerosene…
12. Change 303°K to degree Celsius and degree Fahrenheit
Complete FBD, FORMULA, AND SOLUTION
Step by step
Solved in 2 steps with 1 images
- Convert 68°F to °C.A steel tape having a correct length at 22 degree Celsius was used to measure a base line and the recorded readings gave the total of 856.815m. I fthe average temperature during measurement was 18 degree Celsius, determine the correct length of the line.2- A 100m tape was used to measure a distance between stations P and Q. The recorded slope distance was 880.00m under 45 Cº. The elevation angle measured by a clinometer was 30° 40/ 25" and the standardized length of the tape was shorter than its nominal length with 24 cm under 15 Cº. The coefficient of thermal expansion and contraction of the tape is 0.0002 /unit length/degree Celsius. Compute the corrected slope distance and the required horizontal distance PQ.
- The measured distance between the two poles is 318 m. The tape used was standardized at 20 degrees C, and it has a coefficient of thermal expansion of 0.0000116/degree C. If the adjusted/corrected distance between the two poles is 318.103 m, calculate the temperature during the actual activity. a. 46.54 C O b. none of the other choices C. 52.10 C O d. 47.92 CThe damping ratio of the system response shown in BLUE is 0.8 0.6 0.4 0.2 0 -0.2 -0.4 -0.6 -0.8 20 30 40 00.5 01.2 1011. Change 15°F to degree kelvin Complete FBD, FORMULA, AND SOLUTION
- Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m into the atmosphere. The total pressure is 100 kPa, air temperature is 28°C and the dew point temperature is 16°C near the ground, the lapse rate 6°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal placeA rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively.Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC. fundamentals of surveyingEstimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal place Add your answer
- Calculate the relative humidity if the psychrometer reads 20°C for the dry air temperature and 15°C for the wet air temperature. Or = 59% Or = 52.5% Or= 51% Or = 66% %3DCalculate the air density (kg/cu.m.) from an open water surface with air temperature 22°C, relative humidity is 40% and wind speed is 3 m/s, all measured at height 2 m above the water surface. Assume a roughness height of 0.03 cm. The net radiation is 200 W/m^2 *Kelvin = Degree Celsius + 273.2 computing for the density of air " use this inTAPE CORRECTIONS - Too Long Too Short 1 [Protected View] - PowerPoint (Product Activation Failed) Combined Corrections A line was determined to be 2395.25m when measured with a 30m steel tape supported throughout its length under a pull of 4kg. Determine the temperature during measurement if the tape used is of standard length at 20°C under a pull of 5kg. The cross-sectional area of the tape is 0.03sq.cm, its coefficient of linear expansion is 0.0000116/°C, the corrected distance is 2395.63m and the modulus of elasticity of steel is 2.10x106 kg/cm2. Ans. 35.04°C Slide 18 of 19 圍 豆 9:22 AM P3 * 4) 9/23/2021 N