Calculate the work in megajoules (1 MJ = 1 × 106 J) required to pump all the water out of a full trough from which waterexits by pouring over the sides.baIhCAssume that a = 7 m, b = 12 m, c = 10 m, and h = 4 m. The density of water is 1000 kg/m³, and g = 9.8 m/s².(Use decimal notation. Give your answer to two decimal places.)

Given data a=7m,b=12m,c=10m and h=4m Density of water = 1000(kg/m3) Find the work required to pump…

Calculate the work in megajoules (1 MJ = 1 × 10⁰ J) required to pump all the water out of a full trough from which water exits by pouring over the sides. a = 9.8 m/s². Assume that a = 7 m, b = 12 m, c = 10 m, and h = 4 m. The density of water is 1000 kg/m³, and g = (Use decimal notation. Give your answer to two decimal places.)

Calculate the work in megajoules (1 MJ = 1 × 10⁰ J) required to pump all the water out of a full trough from which water exits by pouring over the sides. a = 9.8 m/s². Assume that a = 7 m, b = 12 m, c = 10 m, and h = 4 m. The density of water is 1000 kg/m³, and g = (Use decimal notation. Give your answer to two decimal places.)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Somewhere along the middle of a horizontal pipe which has a constant diameter of 10 cm a water pump is installed. At the inlet of the horizontal pipe, the pressure is 101,325 Pa. The water then exits the pipe with a pressure of 130,000 Pa. What is the head added by the pump in meters? Take the specific weight of water as 9810 N/m^3. Round your answer to 3 decimal places. Add your answer
A 118-mm-diameter pipe enlarges to a 149-mm-diameter pipe. At section 1 of the smaller pipe, the density of gas in steady flow is 264.656 kg/m3, and the velocity is 23 m/s; at section 2 of the larger pipe, the velocity is 15 m/s. Find the unit weight (in kN/m3) of the gas at section 2. Round off to three decimal places.
A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D = 3 ft and h = 1.5 ft, what is the rate of change of depth of the water in the tank in inches per minute? Vin. h O 1.15 inches/minute O 2.04 inches/minute 4.60 inches/minute
The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 35 psi. The difference in elevation between the suction and discharge side is 2.3 ft. The diameter at suction is 6.7 in, while at the discharge is 4.9 in. Calculate the power delivered by the pump in hp if it delivers 1800 gpm. Write your answer to 1 decimal place.
Find the work done in pumping gasoline that weighs 42 pounds per cubic foot. A cylindrical gasoline tank 3 feet in diameter and 8 feet long is carried on the back of a truck and is used to fuel tractors. The axis of the tank is horizontal. The opening on the tractor tank is 5 feet above the top of the tank in the truck. Find the work done (in ft-lb) in pumping the entire contents of the fuel tank into the tractor. (Round your answer to the nearest integer.) X ft-lb
The pressure in a water tower is 20,674 Pascals (N/m2) higher than at an open faucet. The density of water is 1000 Kg/m3. Use Bernoulli’s equation to determine the velocity of outflow from the open faucet. If the height difference between the top water level in the tower and the faucet is 7.2 meters, then the velocity of outflow is ROUND TO 3 DECIMAL PLACES
A venturi meter has air flowing through it. The diameter at the entrance is 2.1 in and at the throat is 0.7 in. The gage pressure measured at the entrance is 13.3 psia and at the throat is 11.3 psia. Neglecting frictional effects, determine the flow rate of air. Use 0.075 Ibm/t as the density of air. Round your answer to 2 decimal places and in fts.
A man is standing on a board on a frozen lake where there is no friction between the board and the ice surface. Tha man's mass is 2 m and the boaf's mass is 4 m. The board has length L. He walks from 1/5 Lfrom the left end of the board to 1/5 L from the right end of the board. How far and in which direction does the board move during this process?
A dam on a river is built so that the wall facing the water is shaped like the region above the curve y = 0.52 and below the line y = 280. (Here, distances are measured in meters.) The water level is 40 meters below the top of the dam. Find the force (in Newtons) exerted on the dam by water pressure. kg m³ (Water has a density of 1000- and the acceleration of gravity is 9.8- m sec² L 80 SHE GRADE
The vat shown in the accompanying figure contains water to a depth of xo = 1.4 m. Find the work required 4 m 6 m %3D to pump all the water to the top of the vat. 3 Use 9810 N/m as the weight density of water. 3 m NOTE: Enter the exact answer. Work J %3D
Hello i have an example with an answer , please show the solution since only the answer was shown in this example. And i need its solution to review properly. Thank you 1. ) Question : A pump has a brake horsepower of 35 hp with an efficiency of 68%. Neglecting frictional losses, calculate the volume flow rate (m3/min) if the discharge is raised 60 meters above.Answer: 1.82
Help me please