C. A 0.7 specific gravity gas will be compressed to 500 psia and cooled down to 50 oF. Is there a possibility of the hdyrate fomation under these conditions ? If the liquid water in contact with the gas contains 15% methanol by weight, how much the hydrate formation temperature can be depressed?

C. A 0.7 specific gravity gas will be compressed to 500 psia and cooled down to 50 oF. Is there a possibility of the hdyrate fomation under these conditions ? If the liquid water in contact with the gas contains 15% methanol by weight, how much the hydrate formation temperature can be depressed?

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter5: Distillation

Section: Chapter Questions

Problem 13Q

See similar textbooks

Related questions

Q: 10. Gaseous propane at 20 °C is burned with 70% excess air that enters the combustion chamber at a…

A: Given data: Air = 70 % Rate= 1.3 kg/min Temperature = 9° C Pressure = 1 atm Combustion of propane…

Q: 20L vessel contains 0.3 kg of R-134a at 400 kPa. The phase of R-134a is

A: The chemical name of R-134a refrigerant is 1,1,1,2-Tetrafluoroethane (CH2FCF3). The molecular mass…

Q: At 90 °F and 30.0 psi absolute, the specific weight of a certain gas was 0.0877 lb/ft³. Determine…

A: Idea gas equation is a equation which obeys gas laws under all condition of temperature and…

Q: The sublimation point of CO2 (solid) at 1 atm is -78.37oC and the enthalpy of sublimation (solid to…

A: "Since you have posted a question with multiple sub-parts , we will solve first three sub-parts for…

Q: 1. A gas is undergoing an isothermal process the pressure ratio of the final to the initial state is…

A: Given: The ratio of final pressure to initial pressure (P2/P1) = 2.5 Initial volume (V1) = 2 ft3…

Q: A 0.064 kg of octane vapor (MW = 114) is mixed with 0.91 kg of air ( MW = 29 ) in the manifold is…

Q: In a U tube manometer, one end is open to the atmosphere, the other end attached to a pressurized…

A: a. Given, Difference in pressure, ∆P = 40kPa = 40000 Pa Height difference, ∆h = h2 - h1 = 60-30 =…

Q: T UI ealil system isted Ih the first column of the table below, decide (if possible) whether the…

A: To check whether entropy is increasing or decreasing one just has to feel.that whether randomness is…

Q: The lowest temperature multiple of 2 C at which the oil is observed to flow after cooled at…

A: The answer is False. The explanation is given in next step.

Q: Stripping Tower. A liquid mixture containing 10 mo! % n-heptane and 90 mol % n-octane is fed at its…

Q: One gram-mole of methyl chloride vapor is contained in a vessel at 100°C and 10 atm.(a) Use the…

A: Given: The amount of methyl chloride vapors present in a vessel at 100°C and 10 atm is 1 mol.

Q: 1 kg of ethane gas is contained in a piston-cylinder device initially at 610 K and 34 MPa. The…

A: According to Gay-Lussac law,” the pressure of the given gas is directly proportional to the…

Q: A cylindrical tank is filled with fluid. A pressure gauge attached 7 meters above he bottom reads…

A: Solution -

Q: Calculate the total mass of precipitable water (the answer in tons) in the saturated air column 9.5…

Q: A solution of anhydrous salt in water contains 60% water by weight at 313 K. 80% of the solute in…

A: Let weight of solution = 100 gm => Weight of water in solution = 60 gm So weight of salt in…

Q: The volume of a vacuum manifold used to transfer gases is calibrated using Boyle's law. A 0.251 dm²…

A: Given :- Pressure of flask = P1 = 697 Torr Volume of flask = V1 = 0.251 dm3 Pressure of manifold…

Q: A stream of hot water at 150 °F flowing at a rate of 409 Ibm/min is to be produced by mixing water…

Q: Crude oil containing 5.0 mole per cent of gasoline is stripped by running the crude down a column up…

Q: hat are The Diffusion and Molar snductance for Sou at 25Cib you Know 3.

Q: ower! (a) (B) fo fa in a 488 m2 sample collected over water at 0.745 alm at 288.15K2 How many moles…

A: Given: Volume of sample = 488 mL Pressure = 0.745 atm Temperature = 288.15 K

Q: One mol of a gas is contained in a piston-cylinder device at 100 kPa. The piston rests at 10cm from…

A: Answer: Ideal gas equation that will be used to solve the problems is shown below: PV=nRT Here:…

Q: B. Methane at 10 MPa and 200°C is heated at constant pressure until its voli has increased by 75%.…

Q: of the system, decrease S, or leave S unchanged. If you don't have enough information to decide,…

A: Change in Entropy of System is always positive when randomness increases..!

Q: Crude oil containing 5.0 mole per cent of gasoline is stripped by running the crude down a column up…

Q: Using the calculated experimental average density of the liquid samples as reference, what is the…

A: Density = (Mass ÷ Volume)

Q: Why are precincts measures a dry basis? Estimate the wet & dry fluc gas composition if propane is…

A: The stoichiometric reaction for this fuel is represented as follows: C3H8+5O2 → 3CO2+4H2O

Q: A 19-ft3 rigid tank initially contains saturated refrigerant-134a vapor at 160 psia. As a result of…

Q: Compare and contrast the pros and cons manometers. of using water manometer in reading pressures…

A: A question based on analytical process that is to be accomplished.

Q: 1kg air is inside a 0.5m3 tank with pressure of 200kpa. Find its temperature

A: given quantities: m= 1 kg V= 0.5 m3 P=200 kPa

Q: The figures below are of temperature monitos with blue fluid in which a tube (that was also been…

A: Temperature is a physical quantity that expresses hot and cold nature. It is the manifestation of…

Q: mpressed to 3 cu.m, what is the resulti ssure assuming isothermal condition= a abs? (UP TO THREE…

A: Given, V1 = 8 cu.m V2 = 3 cu.m P1 = 200 kPa

Q: An open vessel containing liquid water stands in a sealed room measuring 5.0m wide x 4.0m long x 3m…

Q: A 3.1 kg mass of saturated liquid-vapor mixture of water is contained within a closed system in a…

Q: Explain the usefulness of a tie line on a P-Z phase diagram such as that of the figure below. 100…

A: A multiple choice question based on physical chemistry, which is to be accomplished.

Q: The mixing line is. a. . the line that contains the most of the points plotted. Ob.the vertical line…

Q: For an ideal gas of CO2 molecules at 1 bar, calculate (a) the collision frequency with the wall per…

Q: Extrapolation Extrapolate the data using the Clausius-Clapeyron equation to estimate the vapor…

Q: Example: methanol is burned with (20%) excess air, determine the stoichiometric air/fuel ratio and…

Q: ComPonent weight fraction e.65 0.15 0.10. n-C4 0.06. n-C5 0.04 Assuming real gas behavior,…

A: Gas formation volume factor can be calculated as given below.

Q: Solve the problem systematically. All assumptions and references(s) for the values obtained should…

A: Solution -

Q: An FCM displacement is to be designed in which a slug of butane is the primary displacing solvent.…

Q: The pressure difference of 1.1 x 103 Pa is needed to drive water (η=1.00 x 10-3 Pa.s) through the…

Q: 100kg/hr water is heated from 25 C to 200 C. Steam enters at 500kPa and 973.15K and leaves at 300kPa…

Q: 1. Consider a situation where two volumes of water, one hot, one cold, are both added to a foam cup.…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Methane at 20 °C and 1 atm pressure has a viscosity coefficient of 1.09x10-4 poise. Calculate the…

A: The solution of the given question is

Question

solve c given in the image.

c. A 0.7 specific gravity gas will be compressed to 500 psia and cooled down to 50
oF. Is there a possibility of the hdyrate fomation under these conditions ? If the
liquid water in contact with the gas contains 15% methanol by weight, how much
the hydrate formation temperature can be depressed?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Quality Assurance and Calibration Methods

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

***28.10 An ammonium hydroxide solution is to be prepared at 77°F by dissolving gascous NH, in water. Prepare charts showing: (a) The amount of cooling needed (in Btu) to prepare a solution containing [ Ib mol of NH, at any concentration desired; (b) The amount of cooling needed (in Btu) to prepare 100 gal of a solution of any concentration up to 35% NHy; (c) If a 10.5% NH, solution is made up without cooling, at what temperature will the solution be after mixing?
1. Which of the following compounds can form hydrogen bonds with water?a. octaneb. HClc. NaCld. acetic acid2. Maria wants to determine the percent water content of an unknown hydrate of AB. Given the following data:mass of empty crucible - 12. 2784gmass of AB · xH20 + crucible - 17.4960gmass of AB + crucible - 15.1314gCalculate the % water content of the hydrate3. From the above data, give the correct formula for the hydrate. (AB₂ Molar mass = 129.84 g/mol)
GIve reason why is the temperature increased at compression and decreased at rarefaction?
SylvanPrep edx edX| Free Online... C Coursera| Online... = College Algebra B.. an... - Calcworkshop Resources O Hint Check Answer 45.9% Assignment Score: Question 32 of 41 A new linear temperature scale, degrees Zunzol (°Z), is based on the freezing point and boiling point of a newly discovered compound zunzol. The freezing point of zunzol, -141.5 °C, is defined as 0 °Z, and the boiling point of zunzol, -24.8 °C, is defined as 100 °Z. What is the freezing point of water in degrees Zunzol? | freezing point: What is the boiling point of water in degrees Zunzol? boiling point: 1037 10 A stv P. 2.
Define that When open to the atmosphere, water is in phase equilibrium with the vapor in the air if the vapor pressure is equal to the saturation pressure of water.
Calculate the pressure (in atm) at which the freezing temperature of water is -20°C = 253 K. H₂O(s)→ H₂O(l) AH°f (= AHM) V solid 1.963x10-5 m³/mole Vliquid 1.800x10-5 m³/mole = = = Caution: signs and units 6010 J/mole at TM = 273 K, (fusion = melting) Assume AH°f, Av₁ = V₁ - Vs are constant · · 1 atm = 1.013×105 Pa = 1 atm
Which of standard substance (or standardized solution) is correct standardization of Na2S½O;: for Na,Cr2O7; Na,B,O, 10H2O; H,C,O4 2H2O; As,O;;
12 (a) (b) Describe how you can obtain the integrated form of the Clapeyron equation as below. State any assumptions you have to make. Afus H (T-T) P₂≈ P₁+ AfusV T₁ The heat of fusion (Afus H) of Hg at its normal melting point (-38.9 °C) is 2.82 cal.g¹. The densities of Hg(s) and Hg(1) at -38.9 °C and 1 atm are 14.193 and 13.690 g cm Estimate the melting point of Hg at 100 atm using the result in (a). respectively. Ans 234.8K or -38.4°C
Show calculations for the experimental percentage of water for Trial 1Percentage of Water in Hydrate Average
10-44 Determine the liquidus temperature, soli- dus temperature, and freezing range for the following NiO-MgO ceramic compositions: (a) NiO-30 mol% MgO; (b) NiO-45 mol% MgO; (c) NiO-60 mol% MgO; and (d) NiO-85 mol% MgO. [See Figure 10-8(b).] 2800 2600 2400 L+S 2200 (Ni, Mg)O 2000, 'NiO 20 40 60 80 MgO Mole percent Mg0 (b) Figure 10-8(b) The equilibrium phase diagram for the NiO-MgO system. (Repeated for Problems 10-44, 10-50, 10-53, 10-57, and 10-71.) Temperature (°C)
4.a. Carbon dioxide is gas but water is liquid suitable phase diagram. at room temperature-Illustrate with
When dissolving an ionic solid in water, dynamic equilibrium is reached whenGroup of answer choices rate of evaporating < rate of bubbling. rate of dissolution < rate of recrystallization. rate of dissolution > rate of recrystallization. rate of dissolution = rate of recrystallization. rate of condensing > rate of dissolving.