below. Complete the circuit indicating the imputs (the output is already shown). Size the devices so that the output resistance is same as that of an inverter with an NMOS WL=2 and PMOS W/L=6. Which input pattern(s) would give the worst and best equivalent pull-up or pull-down resistance? Show your work. b) What are the logic functions implemented by the circuits given below. Show your work. A B E WL-16 WIL-8 WL-8 E L-16I GWL-12 B E c) What is the function of the circuit given below? Can it store information? If yes how? TTIT

below. Complete the circuit indicating the imputs (the output is already shown). Size the devices so that the output resistance is same as that of an inverter with an NMOS WL=2 and PMOS W/L=6. Which input pattern(s) would give the worst and best equivalent pull-up or pull-down resistance? Show your work. b) What are the logic functions implemented by the circuits given below. Show your work. A B E WL-16 WIL-8 WL-8 E L-16I GWL-12 B E c) What is the function of the circuit given below? Can it store information? If yes how? TTIT

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

F=A+B'C+A'BC' I need to construct the circuit in multism with an inverter, and gate, or gate.
Reduce down to 3 variable terms with AND gate OR gate and Inverter if possible
Below is an example of an NMOS logic circuit. For all of the MOSFETs in the circuit below, assume V = 1 V and k = 50 mA/V². th R₂ = 5600 R₁ = 4700 M3 Ao M₁ M₂ a. Indicate and verify the state of each MOSFET and V for the following input 0 combinations. Fill-out the table below for each assumed state of the MOSFET for every input combination. Use R approximation for linear operation and three significant ds(on) figures for the voltages. Example: M1 is assumed to be in saturation. If Vgs = 2 V, Vds = 4V, Vds > Vgs - Vth 4>2-1 4> 1 (ok) Vgs > Vth (2>1) A B M1 state M2 state M3 state V OV OV 5 V OV b. What kind of logic circuit is implemented in the circuit above? 5V www. V₂ 0
Below is an example of an NMOS logic circuit. For all of the MOSFETs in the circuit below, assume V = 1 V and k = 50 mA/V². th W R₂ = 5600 PEETHIPPIN R₁ - 4700 M3 M₁ M. 0 a. Indicate and verify the state of each MOSFET and V for the following input combinations. Fill-out the table below for each assumed state of the MOSFET for every input combination. Use R approximation for linear operation and three significant ds(on) figures for the voltages. 오 Ao SV why
4. CMOS Logic Gate The PUN of a CMOS Logic Gate is shown below Vdd Q1 B- Q2 c -dPQ3 B-dCa5 Q6 D Y (a) Determine Y from the PUN. Express your answer in Sum-of-Product form. (b) Sketch the PDN of this CMOS logic gate. (c) Transistor sizing. If we set Peg = 5 for this CMOS logic gate, find W's for Q1 through Q7 if L is set at 0.25µm.
Am trying to design a pure sign wave dc to ac inverter, from what you know, make known to me three ways in which i can make that inverter and with reason, tell me which one you think i should use.
Q4: Suggest a control gate drive circuit for a Triac, which is used to control a fan regulator. The gate signals should be synchronized with the input voltage. Draw the complete: 1. Circuit diagram with the load and 2. The waveform of the input and output voltages. ) Q.13 Indicate whether the following statements are correct or not then correct the incorrect statements 1) the multi pulse selected notching technique used in inverter is used to eliminate the low order harmonics and to reduce switching frequency, 2) In 3-phase half-controlled half-wave rectifier, the firing angle can be varied from 0 to 180 degrees while in 6-phase half-controlled half-wave rectifier can be varied from 0 to 150 degrees Q.14 Indicate whether the following statements are correct or not then correct the incorrect statements 1) In rectifier circuits, lower pulse number and connecting either primary or secondary of 3- phase winding in delta will reduce the harmonics content of the drawr. current 2) In…
Which of the following is an important feature of the sum-of-products form of expressions? • The delay times are greatly reduced over other forms. • The maximum number of gates that any signal must pass through is reduced by a factor of two. • No signal must pass through more than 2 gates (not including inverters). • All logic circuits are reduced to nothing more than simple AND and OR gates.
An inverter with a resistive load, VDD = 3.3 V, P = 0.1 mW, VL = 0.2 V, K'n = 60 UA/V2 and VT N = 0.75 V. The value of (W/L)S is:
Q1) For the circuits shown in figures 1 and 2: 1. What is the function of output? 2. Find the max. and min. Vol. value? 3. Determine the static power (avg.)? 4. Design equivalent logic circuit by CMOC logic circuits? Use VDD= 10 V. Vr.o=1V. Vru-1V. (W/L)o= (5/2), (W/L)L (20/2), RD = 40k, KL = 10P A/V^2 and KO = 40pA/V`2? Figure 1 5 VDD RD Figure 2 बदना दे
Reduce the logic equation with circuit diagram and draw the simplified circuit.
3- In a square wave inverter the switches are controlled in square mode as shown in the bellow. In this inverter V₁ = 100 V and the main frequency of inverter is f = 60 Hz. The load consists of a R = 42 and L= 10 mH. If the main harmonics or this inverter be 1, 3, 5 compute THD voltage and current of load and the effective current of load and power of load and the average current of battery. 10 2.m @t $3,54 VAB Vd -Vd $1,52 N 51 $3 A B İA