b) i) Briefly define internal flow and external flow from the fluid mechanics perspective and give ONE example of fluid mechanics system (application) for each flow. [CO1:PO1] ii) Compressed air with a pressure of 400 kPa is stored in a cylindrical tank at temperature of 40°C. The tank diameter and height are 0.3 m and 1.5 m, respectively. Find the mass (kg) and specific weight (N/m³) of the compressed air given that for air, the specific gas constant, R is 0.287 kJ/kg.K. [CO1:P01]

b) i) Briefly define internal flow and external flow from the fluid mechanics perspective and give ONE example of fluid mechanics system (application) for each flow. [CO1:PO1] ii) Compressed air with a pressure of 400 kPa is stored in a cylindrical tank at temperature of 40°C. The tank diameter and height are 0.3 m and 1.5 m, respectively. Find the mass (kg) and specific weight (N/m³) of the compressed air given that for air, the specific gas constant, R is 0.287 kJ/kg.K. [CO1:P01]

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Using Newton's 2nd law (F = ma) and fundamental of fluid mechanics concepts, a) Write the force balance equations for the differential element. b) Derive the fluid statics equation VP = - pa c) Calculate the gage pressure at a point 1m below the surface inside a tank filled with water if the tank is 1) at rest, 2) freely falling, 3) accelerating upward (against gravity) with 10m/s^2. pg dx dy dz dy dz (P+) de d dx dy_ Given P-pressure, p=density, a-acceleration, 7=acceleration due to gravity, and 7 i + j+ k. Show allf a → ə→ əz P(x, y, z) OP dz az dx P+pg: dz dx dy dy ?x the important steps (assumptions, arithmetic/algebraic manipulations, etc.) as discussed in the class. Assume acceleration due to gravity=10m/s^2.
What is the volume of 92.4 grams of chlorine gas that is at a temperature of 46° C and a pressure of 694 mmHg? (Chlorine, R = 62.4 L- mm Hg/mole K and MW = 70.906 g/ mol) Computation: Show your Solution A lump of ice falls from an airplane as it comes into land. If the ice hits the ground with a vertical speed of 85m/s, what was the height of the plane when the ice fell off? (Assume that friction can be ignored.)
Using Newton's second law, the movement of a body in a viscous fluid can be modeled. For this case it will be a one-dimensional movement. ec.1) F -FR = ma F: Force applied to the body. FR: Resistance that opposes the fluid to the movement. m: body mass a: body acceleration For a sphere with initial radius R0 = 1 meter and density 8960 kg/m^3 to which a constant force of 3 Kilo Newtons is applied, it is requested: Using Euler's method, find the velocity as a function of time for the first 5 seconds of movement, considering that v(0) = 10 m/s. Use a 1 second step. For this case use: ec.2) FR = 210Rv R: Radius of the sphere. v: velocity Where, in addition, the sphere disintegrates as time passes in this fluid, so its radius is given by the following function: ec.3) R = R0*e^(-t/250)
Q3:- The density of liquid water is p = 1008 - [kg/m] with T in C. If the temperature increases, what happens to the density and specific volume? T 50 80 100
In the FLTΘ dimensional system, what is the dimensional representation and corresponding units in standard SI metric and standard english of a) mass flow rate, b) specific volume.
Convection heat transfer data are often reported as a heattransfer coefficient h , defined byQ= hA ∆Twhere Q= heat flow, J/sA = surface area, m 2∆ T = temperature difference, KThe dimensionless form of h , called the Stanton number, isa combination of h , fluid density ρ , specific heat c p , andfl ow velocity V . Derive the Stanton number if it is proportionalto h . What are the units of h ?
P1.8 The air pressure at the foot of a mountain is 101 kPa while at the top of the mountain the pressure and temperature are 75.7 kPa and 267 K respectively. The temperature of the atmosphere decreases linearly with altitude at the rate of 0.0065 K.m. Calculate the height of the mountain. [Answer: 2317 m]
The density of liquid water at 25 degrees celsius equals 62.2lbs/cube ft. Suppose the KD DF stud at the top of the page weighs 13.35lbs. And suppose the KD DF stud is thrown into a swimming pool, Twater=25 degrees celsius. Based on data would the stud: sink completely, partually. or float completely
c) The drag force Fp on a cylinder of diameter d and length / is to be studied. What functional form relates the dimensionless variables if a fluid with velocity V flows normal to the cylinder?
1- The thrust (P l ) of a propeller depends upon diameter (D); speed (u) through a fluid density (p); revolution per minute (N); and dynamic viscosity (u) Show that: P = (p D² u²) f P Du [; where fis any function.
(Q5] (a) The chamber contains 0.05 m' of ideal gas at a pressure of 20 KPa. The gas is subjected to an isothermal compression. until pressure reaches to 30 KPa. After that the gas is subjected to compression according to PV 2-const until pressure reaches to 40 KPa then an isobaric compression is done till volume reaches 0.005 m3. Assume that no loss in gas during the whole process : I- Sketch the process on P-V diagram and P-T diagram II- Find the work done during the entire process and temperature at end of each process.. gas
تراجع الم محاة aläl Fluid Mechanics I Sheet No. 2 Fluid Statics Air Air Q1) The system in Fig. 1is at 20°C. If the pressure at point A is 1900 ibf/ft, determine the pressures at points B, C,and D in lbf/ft. Consider yw = 62.4 lbf/ft 2ft 3 ft Air 4 t [Ans. Pg=1838 lbf/ft', Pe=2087 lbf/ft',PD=2212 lbf/ft'] 5ft Water D Fig. 1 Q2) In Fig. 2 the 20°C water and gasoline surfaces are open to the atmosphere and at the same elevation. What is the height h of the third liquid in the right leg? [Ans. 1.522 ml Galie Im Luuid, SC-L0 Fig. 2 Q3) The system in Fig. 3 is at 20°C. If atmospheric pressure is 101.33 kPa and the pressure at the bottom of the tank is 242 kPa, what is the specific gravity of fluid X? [Ans. 1.55] Im SAE 30 oil Water 2 m Fluid X 3 m Mercury 0.5 m Fig. 3 Pressure Q4) For the system shown in Fig. 4, Determine the pressure reading in psi and kPa. Given: Soi=0.9, SHg-13.6, h=30.48 cm, h,=15.24 cm, h3=22.86 cm. gage Air Open Oil [Ans. Pair=3.836 psi=26.462 kPa] (1) (2) He Fig. 4…