AY-connected balanced three-phase generator with an impedance of 0.4 +0.3 Q per phase is connected to a Y-connected balanced load with an impedance of 24+j19 Q per phase. The line joining the generator and the load has an impedance of 0.6 + 0.7 Q per phase. Assuming a positive. sequence for the source voltages and that Van=120 @ 30° V. Find the complex power at the source and at the load. O a. 1012 +j801.6 VA O b. 785.5+ j25.89 VA O c. 2542+ j452.69 VA Qd. 845+j258.14 VA O e. 2547 + j48.25 VA 06/07/2023 10:07

AY-connected balanced three-phase generator with an impedance of 0.4 +0.3 Q per phase is connected to a Y-connected balanced load with an impedance of 24+j19 Q per phase. The line joining the generator and the load has an impedance of 0.6 + 0.7 Q per phase. Assuming a positive. sequence for the source voltages and that Van=120 @ 30° V. Find the complex power at the source and at the load. O a. 1012 +j801.6 VA O b. 785.5+ j25.89 VA O c. 2542+ j452.69 VA Qd. 845+j258.14 VA O e. 2547 + j48.25 VA 06/07/2023 10:07

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.43P: Three single-phase transformers, each rated 10MVA,66.4/12.5kV,60Hz, with an equivalent series...

See similar textbooks

Similar questions

Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 j3n Za j20 ZA j30 j3n -j20 j 30 -j20 Zo -j20 ZE j30 -j2n j 3n. ZF Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral.
If the line-to-line primary voltage and line current is 1.0 at 0 degrees, what is the secondary line- to-line voltage for the following three-phase transformers? Assume a turns ratio of N = 10. Express answer in polar form. a. Delta-to-Delta: b. Delta-to-Wye: c. Wye-to-Delta: d. Wye-to-Wye:
Can you explain the given questions in an original way? Single Phase and Three Phase Principles • Single Phase Generators • Two Phase Generators
The one-line diagram of a three-phase power system is shown in the above figure. The line impedances are in per- unit on a 100-MVA base, and the line admittances are neglected. Use Gauss-Seidel method in Matlab to analyze the system the tolerance of error is 10-3. Then anwser the questions as follows. V, = 1.05200 0.01+ j0.025 300 + j200 MVA 0.015 + j0.035 150 MW 200 +j150 MVA 0.01+ j0.03 |V = 1.03 The admittance matrix (Y_bus)? 0.02 + jo.04 0.0125 + jo.03 2.
)Two complex loads Z1 and Z2 are connected in parallel and powered by a value voltage effective 7.2 kV and frequency 60 Hz. The first load has a power of 50 kVA and a factor of rear power of 0.9. The second charge has a power of 45 kW and a rear power factorof 0.91. Determine in steady state the kVAR power and the capacity required to correct the Total power factor to a value of 0.97 rear.
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020°, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.332Z –120° A (C) 0.9962-120° A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. 10 ZA j 20 j30 Za j20 j30 j3Ω -j20 j3a -j2n Ze Zo •j20 j 30 j30. ZE -j20 Assume the generator is connected in delta, calculate the total power of the system and the total power factor.
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
A 30-0 resistor, a 15-02 inductive reactance, and a 12-02 capacitive reactance are connected in parallel across a 120-V 60-Hz line. Find (a) the phasor branch currents, (b) total current and phase angle, (c) impedance, and (d) power drawn by the circuit.
A balanced Y-connected generator with terminal voltage Vbc 5 200/08 volts is connected to a balanced-D load whose impedance is 10/408 ohms per phase. The line impedance between the source and load is 0.5/808 ohm for each phase. The generator neutral is grounded through an impedance of j5 ohms. The generator sequence impedances are given by Zg0 5 j7, Zg1 5 j15, and Zg2 5 j10 ohms. Draw the sequence networks for this system and determine the sequence components of the line currents.
The plant capacity of a 3-phase generating station consists of two 8 MVA generators of reactance 14·5%each and one 4 MVA generator of reactance 9·5%. These are connected to a common bus-bar fromwhich loads are taken through a number of 3 MVA step-up transformers each having 4% reactance.Determine the MVA rating of the circuit breakers on (i) L.V. side and (ii) H.V. side. Reactances givenare based on the MVA of each equipment. [(i) 15·24 MVA (ii) 50·25 MVA]
A single phase AC generator winding has an effective resistance of 0.2 ohm and synchronous reactance of 2.2 ohms. Find the generated emf when the load is 50A at a terminal voltage of 500 V at pf 0.8 leading.