Answered: At t = 0 an emf of 20 volts is applied…

At t = 0 an emf of 20 volts is applied to a circuit consisting of a 2 henry inductor in series with a resistance of 400 ohms. If the current is zero at t = 0. What is it at any time t ≥ 0?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Related questions

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: To draw the graph current Vs time and find the current at t = 12 sec

Q: Choose the correct value of current i(t) in this circuit shown in figure connected with Resistance…

A: Given : voltage = 200 v t= 5 microseconds R= 23 ohms L=0.8 H

Q: An inductor (1 H) and resistor (0.1 ) are joined in series with an electromotive force (emf) E =…

Q: For the circuit shown in the figure below, assume that initial charge on capacitor as 250 µC. The…

A: Given circuit is - Given values are - QC0=250μC

Q: A typical AA battery has a potential difference of 1.5 V and stores 10,000 J of chemical energy. An…

A: Two AA batteries with each have a potential difference of 1.5 V and store 10,000 Joules of chemical…

Q: A circuit whose resistance is 20 Ω and inductance of 10 H has a steady voltage of 100 V suddenly…

Q: A series resistance of 10 ohms and a capacitance of 0.1 F are connected to a 100-V source. The…

A: The equation of current which can be written as: it=VRe-tRCit=10010e-t10×0.1it=10e-t A

Q: (a) Refer to the circuit as in Figure Q1(a), a switch has been in position A for a long time and…

Q: v(t) + C1 C2 C3 C4 4 Question 6: What is the expression for the current flowing through capacitor…

Q: Part I R, Rz R3 Cz Here, resistors have R1= 19KQ , R2 = 34KQ & R3=34k2 resistances. And capacitances…

Q: 100 V 50 8mH 600 200 A The switch is initially open in the circuit diagrammed above. A) What current…

A: In the Transient analysis of any circuits, the Inductor always opposes the sudden change of…

Q: the figure below, if the potential at point b is 100 V, what is the potential at point a? R, = 3.0 0…

Q: An inductor with inductance L = 0.400 H and negligible resistance is connected to a battery, a…

A: in question H and I we have to find the value of i2 and i1 given i3 has half of its final value

Q: In Kirchoff's experiment, If we measure l = 0.3 mA, I2 = 0.4 mA, and R1 = R2 = R3 3000 Ohm then the…

A: In this question we need to find a voltage across R3 .

Q: how that the two expressions for the self-inductance, namely NΦ/i and ε/(di/dt) have the same unit

A: Given data, Expression of self inductances are L=Nϕi andL=Edidt

Q: In the circuit shown in the figure, the switch opens at t = 0. Accordingly, find the value of the…

Q: 3. Some PV cell P gives power "P" in standard condition. Estimate the change of power when we use…

A: The solar panels are the energy convertors which convert the solar energy into the electrical…

Q: (b) A resistance R in series with inductance L is connected with e.m.f E(t). The current i is given…

Q: Pre-Laboratory Task 1: Write an expression for, Vout (t), the unit step (voltage) response of the RC…

A: In this question, We need to determine the expression of the output voltage waveform? If initial…

Q: 5) 5 mA 3.9 kN 6.8 kN o+4V R R2 R3 c 20µF 0.56 kn Find the mathematical expression of voltage and…

Q: n the circuit shown in the figure, the switch is closed at t = 0. Accordingly, find the value of the…

A: The solution can be achieved as follows.

Q: Refer to the circuit shown in Figure Assume that the inductor has a wire resistance of 0.2 Q and the…

A: The circuit diagram as shown below: The switch is opened after some time, the circuit parameters…

Q: 2. Suppose that you have a circuit that has a resistance of 6 Ohms, capacitance of 1/24 Farads, and…

Q: Two pure elements, R = 30 ohms and C = 400 microfarad, in a parallel connection have an applied…

Q: When the electromotive force is removed from a circuit Containing inductance and resistance but no…

Q: 7. A circuit consisting of a battery (ɛ = 30 V), two resistors (R1 = 10 2 and R2 = 15.0 2), and…

A: To solve the above question, one should understand the behavior of an Inductor and a Capacitor in a…

Q: 1. For the network shown in Figure 1: (a) Determine the mathematical expressions for the variation…

A: solution (a) switch closed at position 1 at t=0iL(0-)=0AiL(0+)=iL(0-)=0Abecause inductor does not…

Q: 0.1H | 20 µF 2V

A: To solve the circuit it is first converted to Laplace domain. The initial conditions are zero.…

Q: 9. The initial rate of current rise in an R-L circuit is 800 amps per sec when 453 volts is suddenly…

A: (9) Given Initial rate of rise of current in the circuit is 800 amp/sec. i.e di/dt = 800 amp/sec…

Q: 2. The circuit shown in Figure-2 is at steady state before the switch closes at time t= 0. The input…

Q: Q17. A series RL transient circuit with Resistance, 10kL and inductance, 20mH is connected across…

A: Given values are - R=10kohm=10000ohmL=20mH=0.020HV=8Volt Given circuit is -

Q: R2 R3

A: In d.c. analysis, under steady state condition a capacitor will behave as OPEN CIRCUIT. The detailed…

Q: The potential difference in an open circuit is: * Zero O Unity Infinity Circuit does not exist open…

A: Infinity Positive

Q: In the circuit shown in the figure, the inductor has inductance L = 3.50 H and negligible internal…

Q: The independent current source in the circuit generates zero current for t 0 as shown in Figure 1.…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: D For this problem will will assume direct current, DC. A toaster in your home has a power rating of…

Q: Q2(b) The switch has been closed for a long time as shown in Figure Q2(b). At 1- Os, the switch is…

A: The storage elements such as inductors and capacitors have the property to store energy across them.…

Q: The emf source, E, of the circuit shown in the figure has negligible internal resistance. The…

A: Given circuit: Source emf has negligible internal resistance. Resistors R1=7.1 ΩR2=2.8 Ω…

Q: The switch in Figure Q2(b) circuit has been closed for a long time. At t = 0 s, the switch is…

A: The solutions are

Q: For the circuit in Figure Q2(a), the switch has been closed for a long time, and it is opened at t =…

A: The solution is given below

Q: 12 µF i, (mA) A 2 µF 2 µFL 16 1 2 t(s) Figure Q1(a)(i) Figure Q1(a)(ii)

A: The solution is given below

Q: In the figure below, the switch in the circuit has been in position a for a long time. At t = 0, it…

Q: V1 S1 82 24VDC 30mH V2 A Time = 0 Time = V1 = V1 = %3D V2 = V2 = %3D A = A = 3 Amps

Q: *The switch in the circuit in (Figure 1) has been in the left position for a long time. At t = 0 it…

A: Transient analysis

Q: Problem #1: If the current flowing through a 75mH inductor has the waveform shown below. (a)…

A: (a) Calculate the equation of current from the graph using the straight-line method for the time…

Question

100%

At t = 0 an emf of 20 volts is applied to a circuit consisting of a 2 henry inductor in series with a resistance of 400 ohms. If the current is zero at t = 0. What is it at any time t ≥ 0?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts battery. Find the charge after 0.5 second and the current after 0.4 second
Find the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 25 µH 18 μΗ " a 60 μΗ 20 µH 30 μΗ 75 μΗ 12 μΗ 15 μΗ 38 μΗ Figure Q2 (b)
An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance is 0.0001 Farad. Solve for the current "i" at any time "t". Solve for the charge "q" at any time "t".
Calculate the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 10mH 5mH 15mH ll ell ell 20mH 40 mH 60 mH 80mH bo Figure Q2 (b) ll
What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
In the figure ɛ = inductor is ideal. If the switch is closed for a long time, what is the 10.0 V, R1 = 4.00 N , and R2 = 1.00 N. The current through the inductor. Give vour answer in A. R1 S E R2 L
Using superstition, find the value of i0 if voltage source at the left is 10, angle - 30 degrees V, and current source is 2, angle zero degrees. A total of three sources will be considered, separately. The 24 volt source is DC. When this source is acting alone, the capacitor will be open-circuited.
Find the current through the inductor shown in Figure lb. (i/p is AC, consider results upto one decimal place). 1. 100 V 100 Hz 500 L=60H Figure lb