Answer the following question: 1. A Venturi tube narrows down from the inlet section to the throat. The inlet is 5 ft^2 while the throat area is half of the inlet. What is the rate of flow of water when the change in pressure is 0.85 atm? (Use English Units

Answer the following question: 1. A Venturi tube narrows down from the inlet section to the throat. The inlet is 5 ft^2 while the throat area is half of the inlet. What is the rate of flow of water when the change in pressure is 0.85 atm? (Use English Units

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 27CQ: Considering the magnitude of typical arterial blood pressures, why are mercury rather than water...

See similar textbooks

Related questions

Q: filling station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: ABernailli equation gives usP1+12ρv12+ρgh1=P2+12ρv22+ρgh2h1≈h2so neglect…

Q: 8. Given the following venturi meter and the two pressures shown, calculate the mass flow rate of…

A: Given data: The pressure at A is PA=200 kPa. The pressure at B is PB=150 kPa. The diameter at A is…

Q: A refinery uses a Venturi tube like the one shown in the figure to monitor the flow of gasoline (? =…

A: density of fluid = ρ= 7 x 102 kg/m3 inlet radius = r1= 2.5 cm outlet radius = r2= 1.4 cm pressure…

Q: A simplified model of how an airplane flies relies on a difference in air pressure between the top…

Q: The venturi meter is a device used to measure the speed of a fluid in a pipe.the cross sectional…

Q: A 6.1 cmcm diameter horizontal pipe gradually narrows to 4.4 cmcm . When water flows through this…

A: The initial diameter of the pipe is, d1=6.1 cm The final diameter of the pipe is, d2=4.4 cm The…

Q: 1000kg/m is flowing through a pipe that has an area of 0.5m2 with a velocity of 1 m/s at position A.…

Q: In a hydraulic brake, a force of 100N is applied to a piston with area of 4 cm^2. a. What is the…

A: a) By the definition of the pressure we have P =F/A = 100/4cm2 = 25N/cm2 P = 25 N/cm2.(100cm/1m)2…

Q: a soft drink bottling plant, a horizontal section of pipe carrying citric acid in liquid form goes…

A: Given: Area (A1) = 8 cm2 Area (A2)= 3 cm2 Speed (V1) = 240 cms liquid Pressure (P) = 1.40×105 Pa…

Q: A 6-cm diameter horizontal pipe gradually narrows to 4 cm. When water flows through this pipe at a…

A: Given a 6-cm diameter horizontal pipe gradually narrows to 4 cm. When water flows through this pipe…

Q: Water flows through the S-shaped pipe shown in the figure below. At one end, the water in the pipe…

Q: The Venturi tube as shown in the figure may be used as a fluid flowmeter. Suppose the device is used…

A: Density of gasoline, ρ=700 kg/m3∆P=P1-P2=51.2 kPaInlet radius,r1=2.4 cmOutlet radius,r2=1.2 cm

Q: A container of cross-sectional area 122 cm2 contains liquid of density 1.75 g/cm3 to a height of…

Q: The venturi tube as shown in the figure may be used as a fluid flowmeter. Suppose the device is used…

A: Solution: given that liquid density p=700 kg/m3 pressure difference P1-P2=51.2 kPa inlet tube radius…

Q: What is the pressure at a depth of 30.0 m from the surface of the lake? However, the atmospheric…

A: Given, depth, h = 30.0 m density of water, ρ =1000.0 kgm3 acceleration due to gravity, g = 9.807 ms2…

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

Q: The radius of the small piston is 5 cm, where the radius of the large piston is 30 cm .if a force of…

Q: A filling station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: We have a tube filled with gasoline of density ρ=7.4*102kg/m3 with inlet and outlet tubes having…

Q: A filling station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: ρ = 7.100 ✕ 102 kg/m3 r1 = 2.840 cm = 2.840 x 10-2 m r2 = 1.420 cm = 1.420 x 10-2 m P1 - P2 = 1.20…

Q: A Filing station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

Q: On a day with atmospheric pressure equal with water (Density= 1000 K9/m3) on one side and with oil…

Q: The Venturi tube as shown in the figure may be used as a fluid flowmeter. Suppose the device is used…

Q: A segment of a larger artery is constricted by an arteriosclerotic plaque to 1/3 of its original…

A: Given : Pressure in the artery, P 110 torr Flow velocity in unobstructed region, v = 0.32 m/s

Q: Water is flowing at a rate of 0.6 m3/min through a horizontal tube with a diameter of 6 cm. If the…

A: To find pressure of water we use Bernoulli's equation which is defined as sum of pressure energy,…

Q: What is the pressure at the bottom of the tank when it is filled with water as shown, in kPa…

A: Given that, ρ=1000 kg/m3g=10 m/s21 atm =1.00×105 kPa The pressure due to a liquid filled in a…

Q: 40.0 cm2 10.0 cm² h k-

A: Venturimeter is used to find the the flow or discharge through any pipe with the help of pressure…

Q: 9. A liquid is flowing through a horizontal pipe whose radius is 2.10 ×10-2 m. The pipe bends…

Q: A dam retaining water is 660m wide. At its deepest, the water reaches a depth of 120m. What is the…

A: Height = 120 m density of water = 1000 kg/m3Using P = h * d * g where h is the depth d is the…

Q: The Venturi tube as shown in the figure may be used as a fluid flowmeter. Suppose the device is used…

Q: An open-tube manometer is used to measure the pressure in an oxygen tank. when the atmospherric…

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

A: Given values: Density of gasoline, ρ=7.00×102 kg/m3 Inlet radius, r1=2.38 cm Outlet radius, r2=1.19…

Q: A pipe has a cross-sectional area of 16.5cm2 at point A, where the speed of the fluid (water) is 1.2…

Q: A gas station uses a Venturi tube to measure the flow rate of gasoline. The density of the gasoline…

Q: An oil refinery uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: a) Apply the continuity equation between sections 1 and 2. Apply Bernoulli’s equation between…

Q: The volume flow rate in a small rubber water pipe is 2.58 x10−6 m3/s. If the radius of the pipe is…

A: Given : Q = 2.58 x10−6 m3/s r = 9.18 mm = 0.00918 m

Q: A huge block of wood is floating on seawater, with 60 percent of its total volume completely…

Q: An aquarium was filled with salt water at a depth of 0.5 m. What is the pressure due to the liquid?…

Q: A cubical block of wood 1010 cmcm on a side, floats at the interface between oil and water with its…

Q: The deepest part of a swimming pool is 4.9 m below the surface of water. If the atmospheric pressure…

Q: You come across an open container that is filled with two liquids. Since the two liquids have…

A: Pressure is the result of a force acting upon a certain area. Pressure at the bottom of the…

Q: Blood flows through a pipe, passing from the wide section with cross-sectional area A1, as shown…

Q: Given that the density of water is 1 × 103 kg m−3, how deep would you have to dive to experience an…

A: The absolute pressure at a depth h from the surface of the water is given by:P=Pa+ρghwhere,ρ is…

Q: A golf course sprinkler system discharges water from a horizontal pipe at the rate of 7,197 cm³/s.…

A: Given : Q = 7197 cm3/s = 7.197 × 10-3 m3/s r1 = 4.1 cm = 0.041 m r2 = 2.9 cm = 0.029 m P1 = 2.26 ×…

Q: A liquid of density 1.19 × 103 kg/m3 flows steadily through a pipe of varying diameter and height.…

A: Write the expression for equation of continuity.

Q: A large storage tank, open to the atmosphere at the top and filled with water, develops a small…

Q: container of cross-sectional area 122 cm2 contains liquid of density 1.75 g/cm3 to a height of 6.40…

Q: Calculate the gauge pressure (in Pa first, then convert) due to whole blood in an IV system such as…

A: Givenh=2.03 mDensity of whole blood, ρ = 1060 kg/m3

Q: A nozzle with a radius rn = 0.250 cm is attached to a garden hose with a radius of rh = 0.900 cm.…

A: Given data The radius of the nozzle is rn = 0.250 cm. The radius of the hose is rh = 0.900 cm. The…

Q: A pumping station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
Small spheres of diameter 1.00 mm fall through 20C water with a terminal speed of 1.10 cm/s. Calculate the density of the spheres.
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?
The human circulation system has approximately 1109 capillary vessels. Each vessel has a diameter of about 8 m. Assuming cardiac output is 5 L/min, determine the average velocity of blood flow through each capillary vessel.
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
An airplane is cruising at altitude 10 km. The pressure outside the craft is 0.287 atm; within the passenger compartment, the pressure is 1.00 atm and the temperature is 20C. A small leak occurs in one of the window seals in the passenger compartment. Model the air as an ideal fluid to estimate the speed of the airstream flowing through the leak.
What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the iceberg is 917 kg/m3.
What is the difference between flow rate and fluid velocity? How are they related?
Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
How tall must a water-filled manometer be to measure blood pressures as high as 300 mm Hg?
Blood is pumped from the heart at a rate of 5.0 L/min into the aorta (of radius 1.0 cm). Determine the speed of blood through the aorta.