Anion Test - Chloride (Cl‾) Procedure : Add 5 drops of Cl‾ (NaCl 0.5 M) and AgNO3 0.05 M into a test tube. Check the solubility of precipitate formed in NH3 2 M solution. Results : NaCl after adding AgNO3 obtained white precipitate. Solubility in NH3: 5 drops - did not dissolved 5 more drops - still did not dissolved Excess NH3 - all precipitate dissolved in NH3 solution. What is the Chemical equation involved and Discuss the Chloride test?

Anion Test - Chloride (Cl‾) Procedure : Add 5 drops of Cl‾ (NaCl 0.5 M) and AgNO3 0.05 M into a test tube. Check the solubility of precipitate formed in NH3 2 M solution. Results : NaCl after adding AgNO3 obtained white precipitate. Solubility in NH3: 5 drops - did not dissolved 5 more drops - still did not dissolved Excess NH3 - all precipitate dissolved in NH3 solution. What is the Chemical equation involved and Discuss the Chloride test?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter17: Complexation And Precipitation Reactions And Titrations

Section: Chapter Questions

Problem 17.35QAP

See similar textbooks

Similar questions

Slowly adding sodium chromate, Na2CrO4, to a solution containing Ba2+, Ca2+, and Pb2+ will cause what order of salts to precipitate? The Ksp of BaCrO4 = 8.5×101; CaCrO4 = 7.1x10-4, and PbCrO4 = 2.0×10-14. %3D QUESTION 7 K sP BaCrO 4 8.5x10-11 CaCrO 4 7.1x10-4 PbCrO 4 2.0x10 -14 O BaCro4 will precipitate out first, followed by CaCrO4. O CaCrO4 will precipitate out first, followed by BaCr04. O PbCrO4 will precipitate out first, followed by BaCr04- O PbCrO4 will precipitate out first, followed by CaCr04.
If 2.00 mL of 0.200 M NaOH are added to 1.00 L of 0.100 M CaCl2, will a precipitate form? Ksp Ca(OH)2= 8.0 x 10-6 **Sample answer format: 1.0x10-14(YES)
The answers to the questions are already given. Please show the solution how to get the answers. A solution containing 0.5 mM CO32- and 2.5 mM F- is to be separated using Mg(NO3)2 as precipitating agent. Ksp of MgCO3=3.5x10-8. Ksp of MgF2=3.7x10-8. Which ion will precipitate first? Answer: CO32- How much of the first ion (in M) will be left when the second ion starts to precipitate? 5.91x10-6 M
5. A 300.0 mg sample containing Na,CO3, NaHCO, and NaOH and inert material either alone or in some combination was dissolved and titrated with 0.1000 M HCI the titration required 24.41 ml to reach the phenolphthalein endpoint. And an additional 8.67 mL to reach the methyl red endpoint. Determine the composition of the sample and calculate the percent of each titrated component.
5. A 300.0 mg sample containing Na,CO3, NaHCO3 and NaOH and inert material either alone or in some combination was dissolved and titrated with 0.1000 M HCI the titration required 24.41 mL to reach the phenolphthalein endpoint. And an additional 8.67 mL to reach the methyl red endpoint. Determine the composition of the sample and calculate the percent of each titrated component.
If 2.00 ml of 0.200M NAOH are added to 1.00 L of 0.100M CaCl2, will a precipitate form? Ksp Ca(OH)2= 8.0 x 10-6 Sample answer format: 1.0x10-14(YES) (Note: Case, Space, and format sensitive)
*SHOW COMPLETE SOLUTION* If 100 mL of a 0.00075 M sodium sulfate is mixed with 50.0 mL of 0.015 M barium chloride, will a precipitate form? Ksp of barium sulfate is 1.1 x 10-10 . ANS: Qsp = 2.5 x 10-6 ; A precipitate forms. Will a precipitate form when 0.10 L of 8.0 x 10-3 M Pb(NO3 )2 is added to 0.40 L of 5.0 x 10-3 M Na2SO4? Ksp PbSO4 is 6.3 x 10-7 . ANS: Qsp = 6.4 x 10-6 ; A precipitate forms.
Salt MgCO3 Mg(OH)2 Theoretical Ksp 3.5 x 10-8 1.8 x 10-11 For the standardization of the HCI titrant, 5.230 mg Na2CO3 (98.9% purity, MW = 105.99 g/mol) required 24.4 mL of the titrant to reach the phenolphthalein endpoint. After isolating and precipitating the magnesium salt A, a portion was dissolved in distilled water in order to make a 250.0-mL saturated solution. The titration of a 50.0-mL aliquot of the saturated solution required 8.20 mL of HCl titrant to reach the phenolphthalein endpoint. Meanwhile, dissolving this magnesium salt in 250.0 mL of 0.0200 M MgCl2 required 1.51 mL of the same HCl titrant to titrate a 100.0-mL solution. a. What is the molarity of the HCI titrant? b. Comparing the data in distilled water with the two possible solids, which is the most likely identity of the magnesium salt? Show your full solutions in getting your conclusion. Note: Don't forget to factor in stoichiometry c. What is the average experimental Ksp for both solvents (distilled water and…
The graphic below shows the general procedure for titrating the saturated solution of magnesium hydroxide with hydrochloric acid. Select all of the true statements from the choices below. 1. Obtain a saturated solution of magnesium hydroxide. 0 2. Transfer 30.0 mL to an Erlenmeyer flask using a volumetric pipet. Add phenolphthalein. 3. Titrate to a colorless endpoint using 0.0020 M hydrochloric acid. It is important that the aliquot drawn in step 2 does not contain undissolved magnesium hydroxide solid. For titrations of the saturated solutions at elevated temperatures, the solution must be held at high temperature for the duration of the titration. Hydrochloric acid is the analyte in this titration. The volume of liquid in the buret should be read before and after the titration. At the endpoint of the titration, the solution will turn from colorless to pink.
What is observed when equal volumes of 0.1M aqueous HCl and 0.01 M Na2SO3 are mixed? Group of answer choices Colorless solution and a white precipitate. Colored solution and a white precipitate. Colorless solution and a colored precipitate. Colorless solution, no precipitate and gas evolution.
Equal volumes of a 5.28 x 10-4 M nickel (II) nitrate solution and a 3.18 x 10-³ M sodium carbonate solution are mixed. The Ksp of nickel (II) carbonate is 1.42 x 10-7. Qsp = 4.20 x 10-7. A precipitate will not form Qsp = 1.68 x 10-6. A precipitate will form Qsp = 4.20 x 10-7. A precipitate will form Qsp = 1.68 x 10-6. A precipitate will not form Qsp cannot be calculated without knowing the specific volumes of the two solutions that were mixed
When 200.0 mL of 5.15 x 10-4 M Ba(NO3)2 is added to 150.0 mL of 8.25 x 10-4 M Na2SO4. Ksp(BaSO4) = 1.08 x 10-10. A precipitate choose your answer.... Ksp because Qsp choose your answer... choose your answer... SIGMA = form