An urban freeway presently has three 12-ft lanes on a 3 percent upgrade 1.75 mi long. The traffic includes 8 percent trucks and buses (recreational vehicles are negligible). There are no lateral obstructions. Design speed is 70 MPH. (a) What is the present capacity of the upgrade? (b) How much could the capacity be increased by widening and remarking the existing traveled way to provide four 10-ft lanes up the grade?

An urban freeway presently has three 12-ft lanes on a 3 percent upgrade 1.75 mi long. The traffic includes 8 percent trucks and buses (recreational vehicles are negligible). There are no lateral obstructions. Design speed is 70 MPH. (a) What is the present capacity of the upgrade? (b) How much could the capacity be increased by widening and remarking the existing traveled way to provide four 10-ft lanes up the grade?

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 8P

See similar textbooks

Similar questions

A four-lane freeway (two lanes on each direction) is located on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, and a 3-ft left-side shoulder, and a 60- mph design speed. The freeway currently operates at capacity during the peak hour. If an additional 11-ft lane is added, and all other factors stay the same, what will the new level of service be?
A Class II two-lane highway needs to be redesigned for an area with rolling terrain. During the peak hour, 380 vehicles are traveling in the analysis direction and 300 vehicles are traveling in the opposing direction. The PHF is 0.92. The traffic stream includes 8% large trucks, 2% buses, and no recreational vehicles. What is the maximum percentage of no-passing zones that can be built into the design with LOS C maintained?
A Class II two-lane highway needs to be redesigned for an area with rolling terrain. During the peak hour, 380 vehicles are traveling in the analysis direction and 300 vehicles are traveling in the opposing direction. The PHF is 0.92. The traffic stream includes 8% large trucks, 2% buses, and no recreational vehicles. What is the maximum percentage of no-passing zones that can be built into the design with LOS maintained?
Find the upgrade and downgrade service flow rates and service volumes for an eight lane freeway with the following characteristics: (11 ft lanes, 2 ft right-side clearance, 4.2 ramps/mile, 3% trucks, good weather, regular drivers, PHF of 0.92) The segment in question is on a sustained grade of 3.5%, 1.5 miles in length.
A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak- hour factor is 0.90, and all drivers are regular users. The lanes are 12 ft wide, there are no lateral obstructions within 10 ft of the roadway, and the total ramp density is 1.0 ramps per mile. A bus strike will eliminate all bus traffic, but it is estimated that for each bus removed from the roadway, seven additional passenger cars will be added as travelers seek other means of travel. a.) What is density, before the bus strike? b.) What is the volume-to-capacity ratio, before the bus strike? c.) What is the level of service of the upgrade segment before the bus strike? d.) What is density, after the bus strike? e.) What is the volume-to-capacity ratio, after the bus strike? f.) What is the level of service of the upgrade segment after the bus strike?
A long segment of suburban freeway is to be designed on level terrain. The level segment, however, is followed by a 4.5% grade, 2.0 miles in length. If the DDHV is 2,500 vehicles per hour with 15% trucks (standard mix), how many lanes will be needed on the (A.) Upgrade, (B.) Downgrade, (C.) Level terrain segment to provide for level of service C? Lane widths and lateral clearances may be assumed to be 12 feet and 6 feet, respectively. Ramp density is expected to be 1.0 ramps per mile. The PHF is 0.92. Good weather, no incidents, no work zones, and regular users of the facility may be assumed.
A basic segment of a rural freeway has the following characteristics: • Four-lanes (two lanes in each direction)%3B There is one ramp within 3 miles upstream, and 2 ramps within 3 miles downstream; 10-ft lanes; Right shoulder width of 4 ft; • Level terrain;. 10% trucks and 5% buses in the vehicle stream. Calculate the FFS at this freeway section and then determine the level of service (LOS) when the flow rate is 1740 pc/h/In. (Write the answer for the LOS in the box below).
Problem 2. New freeway is being designed on a level terrain, free-flow speed 70 mph 12-ft lanes, 6-ft lateral clearance Peak hour volume 2700 veh, 12% heavy vehicles PHF = 0.92 FIND: Number of lanes for LOS C
A new basic freeway segment will have 3 lanes in each direction. The left and center lane each has a width of 12 ft while the width of the right lane is 13 ft. The left shoulder is 4 ft while the right shoulder is also 4 ft. There are 2 interchanges within 6 miles (3 miles upstream and 3 miles down stream).The site has level terrain, the design speed is 80 mph the hourly design volume is 5250 veh/h, which includes 9.0% trucks and buses. The peak hour factor is 0.870. Calculate FHV, VP, FFS, LOS Show all work
A four-lane rural freeway segment has a 510 m grade length of 2% upgrade followed by a 630 m grade length of 3%. The freeway has 3.4-m lane, 1.5m left-shoulder lateral clearances and interchanges spaced at every 25 km. During the peak hour, there are 6% trucks, 2% buses, 2% recreational vehicles and the rest are passenger cars. Driver population adjustment is determined to be 0.90, peak hour factor is 0.90 and the BFFS is 110 km/h. At present, the freeway operates at capacity during the peak hour in the direction in question. If an additional 3.4 m lane is introduced, and all other factors stay the same, what will be the new level of service?
Spreadsheet is required) 6. 7. An eigt-lane urban freeway (four lanes in each direction) has -ft lanes, with obstructions 2 ft from the right edge of the pavement and aramps over 6-mi analysis segment. Determine Free Flow Speed (FFS).
Civil Engineering A four-lane rural freeway segment has a 510 m grade length of 2% upgrade followed by a 630 m grade length of 3%. The freeway has 3.4-m lane, 1.5m left-shoulder lateral clearances and interchanges spaced at every 25 km. During the peak hour, there are 6% trucks, 2% buses, 2% recreational vehicles and the rest are passenger cars. Driver population adjustment is determined to be 0.90, peak hour factor is 0.90 and the BFFS is 110 km/h. At present, the freeway operates at capacity during the peak hour in the direction in question. If an additional 3.4 m lane is introduced, and all other factors stay the same, what will be the new level of service?