An SCR is connected across 150V battery through 0.5H inductance. If the latching current in the circuit is 3mA, what is the minimum pulse width required to turn on the SCR
Q: For the circuit shown below find C, R, and V if the total current 12 A lead th supply voltage by…
A:
Q: Consider the block diagram in Fig.1. The state-space representation of the closed loop system from R…
A: Given:
Q: B: Find the waveform of the voltage V(t) in the circuit shown below given that: e(t)-2.5 sin(500t)…
A: The circuit is as shown below, Given, e(t) = 2.5sin(500t), i(t) = 1.414cos(1000t),
Q: Find the current Ix if the voltage across the diode is 0.5V. The reverse saturation current of diode…
A: Given : The voltage across the diode: 0.5 V Cut in voltage of the diode: 0.6 V Reverse saturation…
Q: Task Four: Hearing Aid Volume Control system The human ear reacts to various frequencies in a…
A:
Q: 2) Find the Req for the circuit shown in below figure. Rea 312 www 302 6.12 492 49 302 w
A:
Q: Inquiring minds want to know: a) What is the function of a DAC? Do not forget to mention the many…
A: a) DAC converts a digital input signal into an analog output signal. The digital signal is…
Q: The parameters of the equivalent circuit of a 150-kVA, 2400/240-V transformer are: R₁ = 0.2 Ω…
A: We have an transformer with equivalent parameters as, R1 = 0.2 Ω X1 = 0.45 Ω Ri = 10 KΩ = 10 * 103 Ω…
Q: Q2. a) b) By sketching energy band diagrams, explain the differences in electrical properties of…
A: Given; Mass density=2700Kg/m3 The atomic weight of Aluminium=27 Here, we have to sketch the energy…
Q: Find the current I if both diodes are identical. Voltage V = 0.8V and let the reverse saturation…
A: Given: V=0.8 Volts and Is=10-9 A
Q: A quadratic system with a single input and a single output is the state equation given below It is…
A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: Q4/ The equivalent circuit impedances of a 20-kVA, 8000/240 V, 60-Hz transformer are to be…
A: I am attaching detailed solution image of this question.
Q: A 440 volt d.c. The armature resistance of the motor is 0.25 ohm. It takes an armature current of 60…
A:
Q: A 6-pole, 50-Hz wound-rotor induction motor when supplied at the rated voltage and frequency with…
A: We have an Wound-rotor induction motor with, Pole = 6 frequency (f) = 50 Hz Open Circuited Voltage…
Q: You are required to design an inverting amplifier, based on an op-amp with an open-loop gain which…
A: We need to find out gain at given frequency .
Q: 1. A capacitor is formed by two concentric spherical shells of radius a and b that are held at…
A: Capacitor:Capacitor is having two opposite charged plates displaced at some distance in a dielectric…
Q: 3. The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators.…
A:
Q: Consider the discrete-time LTI system shown below, find the 3-dB bandwidth of the system. x(n).…
A: The given discrete-time LTI system is shown below:
Q: b) What is the correct bias configuration for a npn BJT?
A: NPN BJT:- Based on the doping types of the three primary terminals, BJTs can be divided into two…
Q: please work out the following using the infomation in the attached photo. This is for a Boost…
A: Given L = 4mH C = 100μF Vin = 20V Load (R) = 500Ω Duty cycle (D) = 33.3% = 13 Asked to find…
Q: 2. A 0.5uF capacitor has voltage waveform v(t) as shown in following figure, plot i(t) as function…
A:
Q: A generator rated 100 MVA, 20 kV has X1=X2=20% and X0 =5% Its neutral is grounded through reactor of…
A:
Q: Find the Laplace of the function and also it's roc
A: In this case, the Laplace transform of the following function needs to be determined: xt=ut-t0
Q: Example: By Using the superposition theorem find I in the circuit shown in figure? 20V 50 30 100 +5A
A: The given circuit diagram is shown below: V-20/5+V/3=5 3V-60+5V=75 8V=135
Q: The reverse saturation current of a diode at 25°C is 1.5 x 10-9A. What will be the reverse current…
A: We need to find out reverse saturation current at given temperature
Q: Calculate the current i. Ssin(1000t+/6) V 5mH SµF th 1002 10V 10μF 2sin(2000t+a/3) A
A:
Q: b) Figure 2.1 shows the circuit diagram of a simple npn BJT common emitter amplifier. Explain the…
A: A common emitter circuit is shown. We have to explain the resistive element RE. How the circuit can…
Q: Find the Laplace transform of the function y(t)=-e^at u(-t)
A: In this case, the Laplace transform of the following function needs to be determined: yt=-eatu-t
Q: Consider a continuous-time signal x(t)=2-cos( +)+sin(xt-) 2πt 3 6 a) Determine and sketch the…
A: GIVEN: xt=2-cos2πt3+π6+sinπt-π3 TO FIND: (a) determine the sketch the Fourier transform of x(t)…
Q: 2) Convert the star network in fig(a) to delta network 2.50 1.670 fig(a) 12 www R₂3 fig(b)
A: Given : Resistance of the star network RA=1.67 Ω,RB=5 Ω,RC=2.5 Ω Find the resistance of the delta…
Q: For an inverting amplifier, R(i)= 100 killo ohm and R(f) = 600 killo ohm. What is the output voltage…
A: We need to find out output for inverting amplifier
Q: Example: 1.16 A moving coil instrument gives a full scale deflection of 10mA, when the potential…
A: Given:- Moving coil instrument, Full-scale deflection of current Im= 10mA Full-scale deflection of…
Q: Reduce the following functions using Boolean algebra : (a) (b) (c) (d) f = A.A+ A.A+B.0+…
A:
Q: Explain, with the help of annotated drawings, the definition and use of noise margins in logic…
A: The noise margins are the amount of noise that an logic circuit can withstand. The value of the…
Q: EXAMPLE 4.8 Determine loss if For DMOSFET, ID = 4.5 mA, VGS = -2 V Vp = -5 V.
A:
Q: Figure 2.3 shows the circuit diagram of a typical npn BJT common emitter amplifier. The values of…
A:
Q: Calculate the equivalent resistance and the current lo- 24 V + 20 Ω 40 Ω 10 Ω Μ 20 Ω 60 Ω 50 Ω
A:
Q: II. PROBLEM SOLVING. Derive the equations and solve for Z₁, Zo, and Av.Write the complete solution…
A: DC analysis
Q: Determine Norton's equivalent circuit at terminal AB for the circuit shown in Fig 1.162. 100 50 20 V…
A: We have been given an circuit and we have been asked to find Norton's equivalent Circuit at terminal…
Q: Energy saving plant cost Rs. 4,75,000 is. Its useful life is 12 years. Salvage value after useful…
A:
Q: 1 R₁ V₂ D₁ Z
A:
Q: Vx R20 ww R1 Ω Click here for image www Gm Vx R30 R402 Find the current I, shown in the figure. Vs…
A:
Q: SS 2-43 Use current division in Figure P2-43 to find ix, iy. 3A ix 2 ΚΩ iy 1 ΚΩ
A: Given circuit, it=3 ARx=2 kΩRy=1 kΩ
Q: Example C.17 For the electric circuit of Figure C.1, V = 100 v the loop equations are ΤΩ 292…
A:
Q: A synchronous motor improves the power factor of a 200 kW load from 0.8 lagging to 0.9 lagging.…
A:
Q: A series RLC circuit having a resistance of 8 ohm, inductance of 50 mH and capacitance of 90 µF is…
A: We have been give an RLC circuit with, Resistance (R) = 8 Ω Inductor (L) = 50 mH = 50 * 10-3 H…
Q: parallel plate waveguide has plate separation of 1.5cm and filled with a perfect dielectric of…
A: We need to find cut off frequency for waveguide
Q: A three phase power transformer having a line voltage ratio of 400 V to 33 kV is connected in…
A: We have an three-phase power transformer as shown in figure, Voltage ratio = 400 V / 33 KV Current…
Q: 6. Consider the circuit shown in the figure below: 2 ΚΩ 20 mA ( Η Ov \U, 5 ΚΩ www 1 + 5V
A: Given data, Given circuit diagram is,
Q: Find the maximum overshoot in percentage for a unit step response for the closed-loop transfer…
A: Given: CsRs=10s+2s2+2s+2 Required: Maximum percentage overshoot.
Step by step
Solved in 2 steps
- The choke of Figure has a d.c. resistance of 25. What is the d.c. voltage if the full-wave signal into the choke has a peak value of 25.7 V? * 5H 250 pF 750 2 el eShow the output voltage for the Vi input voltage in the figure by drawing it along a period (Note: the diode used is a silicon diode, and it won't be considered an ideal diode) Vi R 15V Vi Vo * 5V -15VQ1/ Sketch the output waveform for the circuit. 15V RL Vo -15V Va 7V Input waveform ww
- C + Vi = 20 V Vo 5V The diode is a non- ideal with Vy = 0.7V Solve and draw the output waveform for the given clamper circuit(a) Apply the S and CLK waveforms of Figure 5-90 to the D and CLKinputs of a D FF that triggers on PGTs. Then determine the waveform at Q.(b) Repeat using the C waveform of Figure 5-90 for the D input.A 10 V peak-to-peak sinusoidal voltage is applied across a silicon diode and series resistor. The maximum voltage across the diode is
- Draw the output waveform and include the voltage value (silicon diode). C +8 V R Vout Vin 0 -8 V +1₁Convert –5 - j30 to exponential form(a) An AC triangular waveform with peak values of ±2V is used as an input to a comparator. The outputs of the comparator are VOH=+5V, VOL=-5V 4 Draw a waveform of the output of the comparator when an inverting circuit in Figure 5 is used. (i) Vi - 20 Vo 20 60 Figure 5
- What is the minimum size the capacitor can be if we want to keep the ripple voltage at the output to 0.5 V or less?Determine the output waveform: 10 5V -10+ TUT -5 25+ -15+ (A) (B) (C)When in forward biased, what have you noticed when you change the source voltage from 0V to +20V? When in reverse biased, what have you noticed when changing the source voltage from 0 V to -15V?