An engineer was tasked to determine the pressure of the air in the air receiver of an air compressor. The bourdon gage reads 50psi. The atmospheric pressure at that location is 14psi. Convert this pressure to: a. Krag b. Коза c. Torr (abs) d. Bar (abs)

An engineer was tasked to determine the pressure of the air in the air receiver of an air compressor. The bourdon gage reads 50psi. The atmospheric pressure at that location is 14psi. Convert this pressure to: a. Krag b. Коза c. Torr (abs) d. Bar (abs)

Name: An engineer was tasked to determine the pressure of the air in the ai
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: An engineer was tasked to determine the pressure of the air in the air receiver of an aircompressor. The bourdon gage reads 50psi. The atmospheric pressure at that location is 14psi.Convert this pressure to:а. Крадb. Крааc. Torr (abs)d. Bar (abs)

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 14RQ: Atmospheric pressure at sea level under standard conditions is ______inches of mercury (Hg) or_____...

See similar textbooks

Similar questions

2. Air is enclosed by a rigid cylinder containing a piston. A pressure gage attached to the cylinder indicates an initial reading of 25 psi. Determine the reading on the gage when the piston has compressed the air to one-third its original volume. Assume the compression process to be isothermal and the local atmospheric pressure to be 14.7 psi. Ans. 104 psig
9. A closed vessel contains air at a pressure of 160 kN/m2 gauge and temperature of 30oC. The air is heated at constant volume of 60oC with the atmospheric pressure as 759 mm Hg. What is the final gauge pressure? (3 DECIMALS IN FINAL ANSWER PLS)
Given the barometric pressure of 14.7 psia, make the following conversions. a) 90psig to psia to atmabs; (b) 25 inHgvac to inHgabs to Pascals; (c) 30psia to psivac to Pascalabs; (d) 25inHgg to psia to torrsabs to barsg
Using Boyle's Law Demonstrator, the absolute pressure and the volume of air are respectively 61.15 kPa and 0.5 L. When the oil height is decreased by 2 cm, the new absolute pressure becomes 50.95 kPa. So, the new air volume will be approximately equal to: Select one: a. 0.6 L b. 0.4 L c. It can't be found because there are missed given data. d. 0.2 L
* When a mass of 1.2 kg is Applied on Piston area of 324 mm2. That means the pressure value equal to 0.36296 N/m2 Ture O False O
The absolute pressure in the tank is 140 kPa. The atmospheric pressure is 100 kPa. pHg = 13,550 kg/m³. a. Determine the gage pressure in kPa. b. Determine the pressure head in mm in mercury. c. Determine the pressure head in mm in oil (S = 0.80).
H.W.1/: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown in Fig. below. Determine the gage pressure of air in the tank if hl = 0.4 m, h2 = 0.6 m, and h3 = 0.8 m. Take the densities of water, oil, and mercury to be 1000 kg/m³, 850 kg/m³, and 13600 kg/m3, respectively? Oil Air Water IT h2 h3 Mercury
The barometer can be used to measure ground clearance on aircraft. At a time when Ground Control reports the barometer pressure as 0.753 mHgS, the pilot's Barometer shows a value of 0.690 mhgs. Which of the following is the plane's ground clearance? Average density of air 1.2 kg/ m3, gravity acceleration 9.8 m/s2 and Mercury density 13600 kg/m3 Please select one:a. 646 mb. 750 mс. 714d. 818 m
A U-tube manometer is used to check the pressure of natural gas entering a furnace. One side of the manometer is connected to the gas inlet line, and the water level in the other side open to atmospheric pressure rises 2.0 in. What is the gage pressure of the natural gas in the inlet line in in. H₂O and in lb/ft² gage? Pgas = i Pgas i in. H₂O gage lb/ft² gage
115. A vacuum gauge connected to a steam condenser shows that the pressure inside the condenser is 0.719 bar below the atmospheric pressure. If the atmospheric pressure is 1.162 bar, what is the absolute pressure of the steam inside the condenser in kPa
3. The reading of an automobile gage is proportional to the gage pressure at the bottom of the tank as shown. The tank is 32 cm deep. Unit weight of gasoline is 6670 N/m³ and that of air is 11.8 N/m³. Unit weight of water is 9790 N/m³. Vent Air Gasoline Water a. Determine the gage reading when the tank is full of gasoline. b. How many cm of air remains at the top when the gage indicates full and the tank is contaminated with 3 cm of water? c. Determine the pressure at the interface of the gasoline and water when the gage indicates full.
The reading of the pressure gauge fitted on a vessel is 25 bar. The atmospheric pressure is 1.03 bar and the value of 'g' is 9.81 m/s2. The absolute pressure in the vessel is