An alternator stator winding protected by a percentage differential relay is shown in Fig. 1.12.8 (a). The relay has 0.15 amp minimum pick up and a 12 % slope of characteristics (i, - iz) V. (¹1+¹2). A high resistance ground fault has occured near the grounded neutral end of the generator winding while generator is carrying load. The currents flowing at each end of the generator winding are shown in Fig. 1.12.8(a). Assuming that the CT's have 400/5 amps ratio and no inaccuracies will the relay trip the gene tor CB under this fault condition.

An alternator stator winding protected by a percentage differential relay is shown in Fig. 1.12.8 (a). The relay has 0.15 amp minimum pick up and a 12 % slope of characteristics (i, - iz) V. (¹1+¹2). A high resistance ground fault has occured near the grounded neutral end of the generator winding while generator is carrying load. The currents flowing at each end of the generator winding are shown in Fig. 1.12.8(a). Assuming that the CT's have 400/5 amps ratio and no inaccuracies will the relay trip the gene tor CB under this fault condition.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

two alternators A and B having 5% speed regulation are working in parallel at a station. Alternator A is rated at 15 MW while B is at 20 MW. When the total load to be shared is 12 MW, then how much of the load will be shared by the alternator B?
(8) Q2. Correct the wrong sentence if you find it in only (all) of the following sentences: ual and same direct 1) T1 Porto at e Tated current med on low vo "aly mmf:. the. ideal trout -side. copper loss is not a vy ne vau and 10au. 12) Shunt field winding have a large number of turns compared with a series field winding. 13) The voltage regulation of generator A is 10% and that of generator B is 5%. The A is better than generator B. generator poTOTIS Us. 10 Un 14) The external characteristic of a dc generator is affected by armature reaction. 15) The commutating poles or interpoles is connected in parallel with the armature. 16) The de motor should be started by impressing its rated voltage across the armature terminals. at 17) The cumulative compound motor has the advantage of over a series Motor. 18) The torque in a differential compound motor increase and its speed is decreased with an increase in the armature current. 19) The flux in a machine does not vary with time. 20) After…
A three phase star connected, 1500 kVA, 13 kV alternator has an armature resistance of 0.9 ohm and a synchronous reactance of 8.0 ohms. When carrying rated load voltage, calculate the generated voltage per phase at loads of a. Unity P.F. b. 0.8 lagging P.F. c. 0.8 leading P.F. d. Calculate the voltage regulation for each loads and determine best regulation.
Two identical 20 MW three-phase alternators operate in parallel. The governor of first machine is such that the frequency drops uniformly from 50 Hz on no-load to 48 Hz on full load. The corresponding uniform speed drop of the second machine is from 50 Hz to 47.5 Hz. How will the two machines share a load of 30 MW?
synchronous generator threewThe phases are rated at 1000 kVA and operate at a voltage of 6.6 kV. The product resistance per phase is 0.38 ohms and the leakage reactance is 0.5 ohms per phase. The generator works to provide full load at a power factor of 0.85 delayed and at normal voltages. Find the value of the no-load voltage.
Q2: A three phase alternator is rated at 120 mva,13.2 kv,0.8 pf lagging, and 60 Hz. its direct axis reactance is 0.62 N and its quadrature axis reactance is 0.4 N.all rotational losses may be neglected . 1-What is the voltage of this generator at the rated condition? 2- what is the voltage regulation of this generator at the rated conditions?
Two 60MVA, alternators operate in parallel. The setting of the governor are such that the rise in speed from full load to no load is 2% in one machine and 3% in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 120MW, what will be the load on the first machine (with 2% speed regulation) when the total load is reduced to 80MW?
Two 50-MVA, 3-phase alternators operate in parallel. The settings of the governors are such that the rise in speed from full-load to no-load is 2 percent in one machine and 3 percent in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 100 MW, what would be the load on each machine when the total load is 60 MW? (Req'd) Draw an appropriate diagram.
2.) A 60-MVA, 69.3 kV, 3-phase synchronous generator has a synchronous reactance of 15 ohms per phase and negligible resistance. The generator is delivering rated power at 0.8 pf leading at rated terminal voltage to an infinite bus bar. Determine the magnitude of the power angle. Subject Electrical machine 2
A 1200 kW,60 Hz synchronous alternator A identical governor droop of 0.0005 Hz/kW.Machine A takes two third of 1000kW bus load at 60 Hz.lf an additional 800 kW load is connected to the bus determine (a) bus frequency (b) load on each machine. is in parallel with a 400 kW,60 Hz alternator B.Both machines have (a) 58.6 Hz (b) 566.67 kW, 433.33 kW. (a) 59.6 Hz (b) 866.67 kW, 133.33 kW (a) 59.8 Hz (b) 666.67 kW, 333.33 kW (a) 58.9 Hz (b) 766.67 kW, 233.33 kW
A three phase, 440V, 4-pole, 50Hz, IM, has a star connected winding requires 19.68A- at full load slip of 3% and 0.8 power factor. Find the iron loss, output power and efficiency. If the no-load power is 1200W and no-load current is 6A and Pfw is 300W, R₁ is 0.802/phase. Use EEC. 1
(a) A single phase distributed winding carries alternating current. Show that the time maximum of the peak mmf for a P pole machine is given by 4 N V21 Fipm -K ph ATs per pole P