pls answer all parts An AC voltage of the form Av= 65 sin 330t where Av is in volts and t is in seconds, is applied to a series RLC circuit. If R = 48.0 N, C = 29.0 µF, and L = 0.250 H, find the following.(a) the impedance of the circuitΩ(b) the rms current in the circuitA(c) the average power delivered to the circuitW

Answered: Image /qna-images/answer/b0f8b484-ef15-4c44-8d00-f343c7448e2e.jpg

An AC voltage of the form Av = 65 sin 330t where Av is in volts and t is in seconds, is applied to a series RLC circuit. If R = 48.0 2, C = 29.0 µF, and L = 0.250 H, find the following. (a) the impedance of the circuit (b) the rms current in the circuit (c) the average power delivered to the circuit

An AC voltage of the form Av = 65 sin 330t where Av is in volts and t is in seconds, is applied to a series RLC circuit. If R = 48.0 2, C = 29.0 µF, and L = 0.250 H, find the following. (a) the impedance of the circuit (b) the rms current in the circuit (c) the average power delivered to the circuit

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Similar questions

A series RL circuit connected to an AC voltage sinusoidal source of 100 V peak voltage and 1 kHz frequency. If R = 1 ohm and L = 1 mH, then... a) The rms current through the circuit leads the source voltage b) The rms current through the circuit is 11.114 A 279.043° c) The rms current through the circuit is 15.718 A z-80.96° O d) The rms current through the circuit is 15.718 A 270.56°
R=1 ka A Oscilloscope V-5 V f=500 Hz In the given circuit, a sinusoidal signal is applied at the source, current measured by AVO meter is 0.01A (RMS) and voltage measured by oscilloscope is 25mV(peak). What is the capacitance value of capacitor? Lütfen birini seçin: a.1 uF b.0.18 mF c.0.15 mF d.0.1mF e.0.12 mF
Given the AC signal: v= 200 Sin (377t-30) a) What is the RMS voltage? b) What is the period of this signal? c) What is the phase angle?
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the rms value of the circuit current?
In the figure, R = 22.50, C=4.31 μF, and L = 35.1 mH. The generator provides an emf with rms voltage 92.9 V and frequency 764 Hz. (a) What is the rms current? What is the rms voltage across (b) R, (c) C, (d) L, (e) C and L together, and (f) R, C, and L together? At what average rate is energy dissipated by (g) R, (h) C, and (i) L? www 000 R
For the circuit shown in the figure, A. If A = 8.0 s and B = 15.2 s, the average value of current is A. B. If A = 3.0 s and B = 17.2 s, the RMS value of the current is A. For the circuit shown in the figure, 4 2 A B
A 10.8-2 resistor, a 11.8-µF capacitor, and a 16.4-mH inductor are connected in series with a 130-V generator. (a) At what frequency is the current a maximum? (b) What is the maximum value of the rms current? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number i Units (b) Number i Units
A series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100 sin200t. Determine the following: a). The overall power factor ( indicate big leading or lagging) b). The voltage drop across the resistor and the capacitor
A resistor of 6 Ω, a capacitor of 300 μF and an inductor of 5 mH are connected in series. If an AC power supply of frequency 50 Hz and a maximum voltage of 5V is connected to this circuit, determine: a. impedance of the circuit.b. rms current.c. rms voltage across resistor, capacitor and inductor.d. phase angle between the current and the total voltage in the circuit
Two ac generators supply the same voltage. However, the first generator has a frequency of 1.2 kHz, and the second has a frequency of 5.7 kHz. When an inductor is connected across the terminals of the first generator, the current delivered is 0.15 A. How much current is delivered when this inductor is connected across the terminals of the second generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. Number i Units 1₂ L 0000 V sin 2π f₁t Circuit 1 12 L 0000 Vo sin 2x f₂t Circuit 2
The complex power for an ac circuit is given as S=5ej(pi/4) VA. What will be the value of the real power and what will be the value of the reactive power?
ESSAY: Describe what happens to the power in this RLC series circuit as the capacitance decreases. Explain in general terms why the observed change should occur. Understand the effects of basic electrical components on the average power of the system and the concept of power factor. Differentiate between average power and real power.