2. Air is contained in a piston-cylinder assembly and is compressed between an initial andfinal state. For each of the following cases, determine whether it is possible for theprocess to occur adiabatically. If it can, determine the work per unit mass required for theprocess (use units appropriate for those provided in the process). If not, determine thedirection of heat transfer (in/out of system). For the purposes of this problem, air can bemodelled as an ideal gas.a. P1 = 1 bar, T = 27°C → P2 = 5 bar, T2 = 217°Cb. P= 40 psi, T = 80°F → P2 = 150 psi, T2 =240°F

INTRODUCTION: A process in which no heat exchange between system and surrounding, it means no…

Answered: Air is contained in a pistom final…

Air is contained in a pistom final state. For each of the process to occur adiabatica process (use units appropr direction of heat transfer ( modelled as an ideal gas.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the heat added in the system and its final pressure.Nitrogen with a mass of 2.5 kg expands at a constant pressure. Theinitial pressure and temperature in the piston cylinder system is 170kPa and 27 oC, respectively. Because of the heat transfer, the systemreached a final temperature of 200 oC. Note R= 0.2968 kJ/kgK Determine:a. The heat requiredb. The workc. The change of enthalpyd. The change of internal energy
14. Air is contained in a piston - cylinder arrangement. The following data were gathered: P= 700 KPa,V -010 m/kg.m, and u, = 160 KJ/kgm. The air expands slowly with the pressure remaining constant until the specific volume becomes, V2= 0.20 m³/kg. and the internal energy becomes, u2 = 310 KJ/kgm- Calculate the work done by the gas and the heat transferred.
Required information Problem 04.038 - Energy balance for water in a piston-cylinder device NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. An insulated piston-cylinder device contains 3.5 L of saturated liquid water at a constant pressure of 175 kPa. Water is stirred by a paddle wheel while a current of 8 A flows for 45 min through a resistor placed in the water. One-half of the liquid is evaporated during this constant-pressure process and the paddle-wheel work amounts to 400 kJ. 11,0 consta Problem 04.038.a - Find source voltage Determine the voltage of the source. Use data from the steam tables. (Please provide an answer before moving on to the next part) The voltage of the source is V.
Carbon Dioxide is contained in a piston-cylinder assembly and undergoes a cycle made of the fol- lowing processes: • Process 1-2: Constant volume from 1 bar, 300 K to 600 K • Process 2–3: Polytropic expansion with n=k until P3 = P1 • Process 3-1: Isobaric compression (a) Sketch the cycle on p-v and T-v coordinates (b) Determine the work and heat transfer in each process, in kJ/kg (c) Determine the type of cycle that this is. If it is a power cycle, compute the thermal efficiency. Otherwise, compute the coefficient of performance for a heat pump cycle.
1. An ideal gas with R = BTU 0.062- and Cy =0.158 BTU undergoes a three Ibm-°R process cycle in aclosed system. From the initial state of 20 psia and 570 °R, the gas is compressed at constant temperature to 1/5 of its initial volume, process 1-2; it is then heated isochorically to state 3,process 2-3; and finally, it expands polytropically with index n= 1.5 back to its initial state, process 3-1. Determine the pressures, specific volumes and temperatures at eardinal points around the cycle and the cycle thermal efficiency.
Q-1(c): Consider a case in which the air inside the pressurized cabin of a jet transport flying at some altitude of pressure, 0.9 atm and of temperature, 15°C. The total volume of air at any instant inside the cabin is 1800m3. If the air in the cabin is completely recirculated through the air conditioning system every 20 min, calculate the mass flow of air in kg/s through the system. I Answer:
Task 5A sample of gas is compressed by an average pressure of 2 atm which decrease its volume from400 cm 3to 200 cm 3. During the process, 10 J of heat is rejected to the surroundings. Explain and demonstrate the application of the first law of thermodynamics to this system and calculatethe change in energy of the system.
H.W1: Warm air is contained in a piston-cylinder assembly oriented horizontally as shown in Figure below. The air cools slowly from an initial volume of 0.003 m to a final volume of 0.002 m'. During the process, the spring exerts a force that varies linearly from an initial value of 900 N to a final value of zero. The atmospheric pressure is 100 kPa, and the area of the piston face is 0.018 m. Friction between the piston and the cylinder wall can be neglected. For the air, determine the initial and final pressures, in kPa, and the work, in kJ. A = 0.018 m2 Patm = 100 kPa Air Spring force varies linearly from 900 N when V = 0.003 m³ to zero when V, = 0.002 m³
BTU ETU 1. An ideal gas with R = 0.062- and Cy =0.158 undergoes a three 16-2 Ib"R process cycle in aclosed system. From the initial state of 20 psia and 570 °R, the gas is compressed at constant temperature to 1/5 of its initial volume, process 1-2; it is then heated isochorically to state 3,process 2-3; and finally, it expands polytropically with index n= 1.5 back to its initial state, process 3-1. Determine the pressures, specific volumes and temperatures at cardinal points around the cycle and the cycle thermal efficlency.
The pressure of the air in a starting vessel is 40 bar and the temperature is 24°C. If a fire in the vicinity causes the temperature to rise to 65 °C. Neglect anyincrease in the volume of the vessel which is 5 liters. Please answer the following a. The thermodynamic process the problem representsb. the pressure, temperature, and volume after the processc. change in internal energy, change in enthalpy and change in entropyd. work nonflow and heat transferred
fluid-thermal-systems
2. The gas expanding in the combustion space of a reciprocating engine has an initial pressure of 5o bar and an initial temperature of 1623 C. The initial volume is 50000 mm' and the gas expands through a volume ratio of 20 according to the law pV = constant. Calculate w and AU Take R = 270 J/Kg K and C, = 800 J/Kg K. Assume n = 1.38