After being closed for a long time, the switch S in the circuit shown in the figure below is thrown open at t = 0. In the circuit, & = 24.0 V, RA= 3.50 kn, R₂ = 7.10 k0, and L = 532 mH.RASElRB(a) What is the emf across the inductor immediately after the switch is opened?(b) When does the current in the resistor R₂ have a magnitude of 1.00 mA?

Answered: Image /qna-images/answer/7890d07a-a9b6-4596-890b-10589b6349d4.jpg

After being closed for a long time, the switch S in the circuit shown in the figure below is thrown open at t = 0. In the circuit, & = 24.0 V, RA= 3.50 kn, Rg = 7.10 kn, and L = 532 mH. RA m L S + b 6 RB (a) What is the emf across the inductor immediately after the switch is opened? V (b) When does the current in the resistor Rg have a magnitude of 1.00 mA?

After being closed for a long time, the switch S in the circuit shown in the figure below is thrown open at t = 0. In the circuit, & = 24.0 V, RA= 3.50 kn, Rg = 7.10 kn, and L = 532 mH. RA m L S + b 6 RB (a) What is the emf across the inductor immediately after the switch is opened? V (b) When does the current in the resistor Rg have a magnitude of 1.00 mA?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section25.1: Electric Current From Changing Magnetic Fields

Problem 3PP

See similar textbooks

Similar questions

Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
A 75-turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 radius in a 1.25 T field, starting with the plane of the coil parallel to the field. (a) What is the peak emf? (b) At what time is the peak emf first reached? (c) At what time is the emf first at its meet negative? (d) What is the period of the AC voltage output?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
Two coils close to each other have a mutual inductance of 32 mH. If the current in one coil decays according to I=I0eat , where I0= 5.0 A and =2.0103s1 , what is the emf induced in the second coil immediately after the current starts to decay? At t=10.0103s? ?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A small series-wound dc motor is operated from a 12-V car battery. Under a normal load, the motor draws 4.0 A, and when the armature is clamped so that it cannot turn, the motor draws 24 A. What is the back emf when tire motor is operating normally?
A 120-V, series-wound dc motor draws 0.50 A from its power source when operating at full speed, and it draws 2.0 A when it starts. The resistance of the armature coils is 10 , (a) What is the resistance of the field coils? (b) What is tire back emf of the motor when it is running at full speed? (c) The motor operates at a different speed and draws 1.0 A from the source. What is the back emf in this case?
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
A rectangular wire loop with length a and width b lies in the xy-plane, as shownbelow. Within the loop there is a time-dependent magnetic field given by B(t)=C((xcost)i+(ysint)k) ,with B(t) intesla. Determine the emf induced in the loop as a function of time.
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?