According to Kolrausch’s law of independent ionic migration, the molar conductivity of an electrolyte is equal to the sum of the molar conductivity of its constituent ions. True Neither true nor false It depends on the experimental parameters. False

According to Kolrausch’s law of independent ionic migration, the molar conductivity of an electrolyte is equal to the sum of the molar conductivity of its constituent ions. True Neither true nor false It depends on the experimental parameters. False

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter32: Gas Chromatography

Section: Chapter Questions

Problem 32.7QAP

See similar textbooks

Related questions

Q: For the reaction below, how many moles of aluminum are produced from 3.6 moles of lithium? 3Li (s) ...

Q: B. Write your answer below. You may add as many spaces as needed. (2) F, (1) Be,* Atomic number: Be=...

A: Given, 1. Be2+ 2. F2

Q: 3. Rank the following in decreasing melting point (1=highest m.p.) :ö: Na

Q: At 500 °C, hydrogen iodide decomposes according to 2HI(g)↽−−⇀H2(g)+I2(g) For HI(g) heated to 500...

Q: Aqueous hydrobromic acid (HBr) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium b...

A: Given, Aqueous hydrobromic acid reacts with solid sodium hydroxide to produce aqueous sodium bromide...

Q: jen is needed to ch Carbon Diox the actual amou

A: The given answer is below:

Q: 3. A 100 mL sample of hard water is titrated with 22.4 mL of the EDTA solution from problem 2. The s...

A: Solution Given that Volume V1 of the sample h...

Q: Consider the reaction. A(aq)↽−−⇀3B(aq)?c=3.14×10−6at 500 K If a 1.50 M sample of A is heated to ...

A: Consider the reaction: A(aq) ⇌ 3B(aq) Kc=3.14×10-6 The initial concentration of A = 1.50 M ...

Q: CO2 (g) + 2NH3 (1) → CO(NH2), (s) + H2O(1) This reaction models how urea fertilizer is produced from...

A: Number of mols = weight / molecular weight At S.T.P. 1 mol of any gas occupy the volume 22.4L

Q: Why will C2H6N not fulfill the octet rule since it exceeds the maximum number of Carbon and Nitrogen...

A: Carbon forms 4 bonds since it needs 4 electrons to complete its octet. Similarly, Hydrogen needs onl...

Q: Mercury can be determined by cold vapor AAS. How would you distinguish between inorganic mercury and...

A: Answer is below

Q: Select the two compounds that could be used to make Compound V through a Diels-Alder reaction. CN CN...

Q: Liquid hexane (CH, (CH,)¸CH;) reacts with gaseous oxygen gas (02) to produce gaseous carbon dioxide ...

A: Recall the equation %yield = (experimental yield/theoretical yield)×100

Q: Place the following in order of increasing acid strength. HlO < H1O 2 < HlO 3 < HlO 4;

A: Place the following in order of increasing acid strength ---

Q: One of the most advanced methods for determining a protein sequence is tandem mass spectrometry (MS/...

A: Tandem mass spectroscopy includes the coupling of two or more mass analyzers to significantly increa...

Q: CASO4 (s) is a and would therefore require a solution to shift the relevant equilibrium to the right...

A: There are some salts which are completely soluble in water , that will form solution. There are som...

Q: A car battery is a lead-acid battery. The reaction that occurs when the battery is recharging is a d...

Q: c) Which species has the strongest conjugate acid? Circle your choice. H.

A: There is a relationship between the strength of an acid (or base) and the strength of its conjugate ...

Q: Classify each of these exchange reactions as an acid-base reaction, a precipitation reaction, or a g...

A: Given incomplete chemical equations are : (a). MnCl2 (aq) + Na2S (aq) ------> (b). Na2CO3 (aq) +...

Q: Provide the correct IUPAC name for skeletal (line-bond) structure shown here.

A: Rule for the nomenclature of cyclic aliphatic hydrocarbon- 1-Take the hydrocarbon ring part as the p...

Q: 1. Complete the table below. Tests Based on the Formation of Furfural and Its Derivatives Test Purpo...

A: The above tests are based on formation of furfural And based on reducing properties of sugar.

Q: decades

Q: What is the true density of Zr, an HCP crystal, in g/cm3 ? Atomic Number = 40 Atomic Weight = 91.22 ...

A: Recall the equation d = (Z× Atomic number)/(Na×a3) d= density Z= total no of atoms in Na= Avogadro ...

Q: Gaseous ethane (CH,CH,) reacts with gaseous oxygen gas (0,) to produce gaseous carbon dioxide (CO,) ...

A: Number of moles = mass/molar mass Mass = moles × molar mass Molar mass of ethane = 30.0 g/mol Mo...

Q: Consider the following reaction: H3PO4 Choose all final major product(s): HO HO ÕH HO ÕH ОН A В D E ...

A: We have find out major product

Q: Arrange the following substances in order of increasing molar entropy at 25°C: Ne(g), SO2(g), Na(s),...

A: • The given substances is - Ne(g) , SO2(g) , Na(s) and H2O(l) • We need to arrange the...

Q: A4 Each alkali metal reacts with water to give hydrogen gas and an hydroxide (a base). eg: lithium +...

Q: Express the rate constant k for the overall chemical reaction in terms of k1, k2, and (if necessary)...

A: Answer is given as :

Q: Which of the following hydrocarbon will NOT react with potassium permanganate in basic condition? I...

Q: How to wrtie the total ionic and net ionic equation for 2Al+ 6HCl ----> 2AlCl3+3H2

A: • The given balanced chemical equation with the physical states of each substance is, 2Al(s) + 6...

Q: Arrange the following substances in order of increasing molar entropy at 25°C: Ne(g), SO2(g), Na(s),...

A: Entropy is a measurement of randomness or irregularities present in the system. Here we see that th...

Q: questions

A: This is a multiple questions.According to the guidelines, in multiple questions, we can solve only t...

Q: 3. A 100 mL sample of hard water is titrated with 22.4 mL of the EDTA solution from problem 2. The s...

A: Given :- A 100 mL sample of hard water is titrated with 22.4 mL of EDTA solution

Q: Ammonia is produced by the reaction of nitrogen and hydrogen according to the equation N;g) + 3H;(g)...

A: The given chemical reaction is as follows: N2(g) + 3H2(g) → 2NH3(g) The given mass of nitrogen = 36....

Q: 3) AH = ? H2C ĆH H3C-CH Given: B.E.'s C-H C-C C=C C=0 C-O 0-H kcal/mole 99 83 145 173 85 111

Q: What is the difference between natural and synthetic rubber? Are they produced the same way?

A: Rubber is polymer

Q: What is AG (in kJ) for 2 SO2(g) + O2(g) 2 SO3(g) at 700 K, under standard conditions of 1 bar partia...

Q: Consider the table of data collected for the reaction A → Products. Determine the magnitude (value) ...

A: From graph we found the equation of slope line y = -0.1770x + 0.4215 And R2 = 0.9320

Q: Nickel and carbon monoxide react to form nickel carbonyl, like this: Ni(s)+4 CO(g)--Ni(Co),(9) At a ...

A: Consider the given information is as follows; Mass of Ni = 56.7 g Mass of CO = 1.69 g Mass of Ni(CO)...

Q: An aqueous solution of calcium hydroxide is standardized by titration with a 0.133 M solution of nit...

Q: How many moles of AgCl will dissolve in 1.00 L of 0.100 M NaCN? What are the concentrations of the v...

Q: A coffee cup calorimeter, including that water it contains, has a heat capacity of 425 J/K, and is i...

A: Formula: q = C × ∆T where , q = heat C = Heat Capacity ∆T = Change in temperature The Heat lost b...

Q: Find the FALSE statement about the voltaic cell based on the two reduction half- reactions shown bel...

A: For this , we would first write a complete cell reaction . For this we would select cathode and anod...

Q: Same reaction as in Q1. H3PO4 Identify the nucleophile: H2PO4t- H20 H30* H3PO4 А В D E O A O B O E

A: The nucleophile in the given reaction = ?

Q: In the pseudo-first order hydrolysis of an ester, [ester] = 0.060M at t = 600 s, and 0.018 M at t = ...

A: A Pseudo first-order reaction can be defined as a second-order or bimolecular reaction that is made...

Q: You have a test tube containing a mixture of Ag+, Fe3+, and Ba2+. Make a diagram similar to Expt. 1 ...

A: from a mixture of cation they an be separated by using reagent that causes precipitation of individu...

Q: A sample of copper oxide weighing 2.013 g is dissolved in acid, the pH adjusted, and excess KI added...

A: The solution of the question is given below:

Q: by An isotope of element B has hal. us many protons and half as many neutrons as an atom of 48TI. Wr...

A: 3. Ans :- An isotope of element B has half as many protons and half as many neutrons as an atom of ...

Q: In air, nitric oxide gas reacts with oxygen to produce nitrogen dioxide, which appears brown in colo...

A: Nitric oxide reacts with oxygen to produce nitrogen dioxide. The equation for the balanced chemical ...

Q: 3. What is the final temperature of 100 g of ice at -5 °C added to a styrofoam cup filled with 2500 ...

Question

According to Kolrausch’s law of independent ionic migration, the molar conductivity of an electrolyte is equal to the sum of the molar conductivity of its constituent ions.

		True
		Neither true nor false
		It depends on the experimental parameters.
		False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Molecular Motion in Electrolyte Solutions

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

True or False According to Kolrausch’s law of independent ionic migration, the molar conductivity of an electrolyte is equal to the sum of the molar conductivity of its constituent ions.
What are the units of molar conductivity?
How is boundary molar conductivity determined in strong electrolytes?
The molar conductivity of a 1.5 M solution of an electrolyte is found to be 138.9 S cm2 mol-1. Calculate the conductivity of this solution.
Which of the following is/are TRUE about molar conductivity? The molar conductivity provides information about the current-carrying ability of the ions produced by one mole of the substance. For strong electrolytes, molar conductivity decreases slightly as the concentration is increased. At infinite dilution, each ion derived from the electrolytes makes a definite contribution to the molar conductivity. Debye-Hückel Theory states that the molar conductivity of an electrolyte at infinite dilution is the sum of the molar conductivity of its constituent ions. II, IV I, II, IV I, III, IV I, II, III
What is the partial molar feature? What are the differences between partial molar properties and normal molar properties?
Using Gibb's Phase rule calculate the degrees of freedom of the following: Show complete solutions: 1. Nitrogen (gas) + Nitrogen (liquid) 2. Sucrose + talc + kaolin
(c) The data set below represents the surface tension data for aqueous solutions of 3- methylbutanoic acid [(CH3)2CHCH₂COOH] at 25°C. [C] [mol.dm³] 0 Y[mN.m'] 72.7 0.009 64.6 0.026 59.0 0.065 51.3 0.135 47.0 (i) Calculate the surface excess of 3-methylbutanoic acid (in mol.m2) and (ii) Hence estimate the molecular cross sectional area (in nm²) for this surface active molecule. (iii) Compare your estimate with the molecular cross sectional area one might expect for n-butanoic acid and account for the difference, if any, between the two surface active molecules.
Question 20 According to Kolrausch's law of independent ionic migration, the molar conductivity of an electrolyte is equal to the sum of the molar conductivity of its constituent ions. O True O False
At room temperature, the equilibrium mole fraction of vacancies in a crystal is 10-12. Now the crystal is subjected to irradiation which creates a great number of vacancies leading to a vacancy mole fraction of 0.01. What is the chemical potential of the vacancies in the irradiated crystal?
Calculate the structure factors for a body-centred cubic (cubic I) structure in which the scattering factor of the central ion is twice that of the ions at the corners of the cube.
Find the planer density (Po) in (atom/mm) of (100) in a face centered cubic unit cell with lattice constant of 3.5 A, and determined the atomic radius