AC CIRCUITS Ife = 100 sin(at +30)-50 cos 3ot + 25 sin(5ot +150°) and i= 20 sin(ot +40°)+10 sin (3ot +30°) 5 sin(5ot-50°). Calculate the power in watts. %3D

Q: A resistor (R = 600 n), an inductor (L= 500 mH), and a capacitor (C = 6 µF), and are connected in…

A:

Q: An R = 64.2 SN resistor is connected to a C = 63.0 µF capacitor and to a AVRMS = 106 V, and f = 129…

A: In this question,  In the first case 1 R and C are connected in the series,  In the case 2 R and L…

Q: Rioad load Rioad Vs(t) + Vs +, BLioad source load source load An electric dryer with an equivalent…

A:

Q: coil with a resistance of 35 ohms and an inductance of 92.84 millihenry has the equation e = 340 sin…

A:

Q: 21 - According to the AC current expression given below, what is the period of the current? i(t) = 5…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Q4 Per given cignal, P(0 = jo Cos (wet + 0.5 Sin 2mt), ニ Colculate, i) (! ") freg. duiation, of in)…

A:

Q: Q 4) Obtain the sinusoids corresponding to each of the following phasors (a) V = 60/15° V, w = 1 %3D…

A: a)V1=60∠15° ; ω=1 rad/secV1t=V1sinωt+ϕV1(t)=60sin(t+15°) Volt

Q: A circuit has a resistance of 12 Q and capacitive reactance of 16 Q in series, If the applied…

A:

Q: A current of i(t) = 0.49 cos (18 t-57°) A is applied to an inductor L = 4 mH as shown. What is the…

A: The magnitude of phasor always represent in RMS value.

Q: n()= 100 sin(10) at t< o m(0)- 200 sin(10) at t0 A coil has been connected to an AC source for a…

A: Here two input voltage are given for t  less than 0 and for t greater than  0 To find circuit…

Q: For the circuit shown below, determine Is, V, IR, L and Ic and draw a phasor diagram showing all…

A: In an AC parallel RLC circuit, the reactance offered by inductor and the reactance offered by…

Q: 7. An AC circuit has an RMS voltage of 100 volts, RMS current of 20 amps, and a power factor…

A: Given, An AC circuit has Vrms=100 VIrms=20 Aϕ=45°

Q: QI/A: Define second order-circuit and name its excitation methods. QI/B: The switch in the figure…

A:

Q: The voltage v = 188 sin(100t+50°) V is connected acroos a 8-H inductor. Determine the current at t =…

A:

Q: 6)  A circuit consisting of a resistor in series with an inductance takes 210W at a power factor of…

A: We assume the voltage to be at base angle zero. V=50∠0°, I=7∠-53.13°, R=4.29Ω (d) The impedance is…

Q: 4. Determine the magnitude of the following instantaneous equations (answers must be in 3 decimal…

A: Here instantaneous equations is given ,we have to calculate particular time value(magnitude) by…

Q: The equation of the current in a pure inductor circuit is i = 4.25 sin 157t when the impressed emf…

A:

Q: 3. The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the…

A:

Q: 30 v(t)= 100 sin(10r) at t0 A coil has been connected to an AC source for a long time and at t-0 the…

A: In this question we need to choose a correct option.

Q: In a purely inductive AC circuit as shown in the figure, AV = 100 V. max AVmax sin wt (a) The…

A:

Q: A voltage v(t) = 141.4 cos(100t) V is applied to a series circuit and the resulting current is found…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Consider the sinusoidal voltage v = 160 sin(0.3t+45o). Calculate the value of the voltage at t = 6…

A:

Q: i) The peak value for a 220 V main supply is: Select one a) 198.19 V b) 311.12 V c) 99 V d) 155.56 V…

A: relation between rms value and peak value is, peak value = 2×rms valuepeak value = 2×220= 311.1 volt…

Q: 2). The current through a 20 ohm capacitive reactance is given below. What is the sinusoidal…

A: The solution is given below

Q: The current and voltage in an AC circuit is given by V=120 sin (377t+20°) V and i=5 sin(377t– 60°)…

A: Draw the phasor diagram to find angle between voltage and current .

Q: In the figure below, all impedances are in ohms, all voltages are in volts and currents in Amperes.…

A:

Q: voltage v = 119 sin(100t+50°) V is connected acroos a 8-H inductor. Determine the current in polar…

A: We need to find out the current for given voltage for inductor

Q: 30 v(t)= 100 sin(10r) at t0 A coil has been connected to an AC source for a long time and at t=0 the…

A: Here two input voltage are given for t  less than 0 and for t greater than  0

Q: Figure 3a Figure 3b 220V 100W 220V 100W L 2.5372H L 2.5372H 220V 60HZ 220V 60HZ 5µF 5µF Figure 3c…

A: The inductive reactance of the inductor is calculated as shown below:  XL=jωLXL=j2πfLf=60 HzL=2.5372…

Q: A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected…

A:

Q: If a phasor representation of a current is given by I = 70.7 ∠45° A, it is equivalent to

A:

Q: Problem 7: For the circuit shown below, determine Is, V, IR, IL and Iç and draw a phasor diagram…

A:

Q: Solve for Rc of Figure 42. 12 V - Vc = 6V www Ra www Rc VCE B=80 IB = 40 μA Reference: Boylestad, R.…

A: Given the value of β=80 Consider the value of the collector voltage. Vc=Vce=6 V

Q: 53. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

A:

Q: An AC supply voltage is represented by v = 325 Sin wt. Three loads are connected in parallel across…

A:

Q: A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: Write a Matlab code to sketch using plot function, y(t)=3 sin(t) for 3 periods

A: The required Matlab code can be written with help of a predefined sine function. In order to plot…

Q: H.W 4: For the following pairs of voltages and currents, determine whether the element involved is a…

A:

Q: a. 20 sin (377t – 180°) b. 6 x 10-6 cos wt c. 3.6 x 10¬° cos (754t – 20°)

A:

Q: 32 - According to the AC current expression given below, what is the maximum amplitude of the…

A:

Q: 8. The circuit below is similar to Problem 7 and operates at a frequency of 10 kHz. Circuit element…

A:

Q: QUESTION 1 The voltage v(t) and current i(t) in an AC circuit are given in Figure 1. The closed box…

A: Solve the above questions

Q: Q3: Choose the correct element involved a capacitor, an indictor or resistor * C=0.88 x R=1 R=5 R=10…

A: Choose the elements  Check the elements are involved a capacitor, an inductor or resistors.

Q: 5. The voltage and current waveform are expressed as follows in a power system. Calculate: the…

A: Given,…

Q: In the figure below, all impedances are in ohms, all voltages are in volts and currents in Amperes.…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: In the circuit shown in Figure 1, the source is Vi=10 sin(@t) V where @=2n × 200 rad/s. If the…

A:

Q: Q6. (a) For two sinusoidal voltages v₁ = 30 sin(at) V and v₂ = 30 sin(wt + 0.25m) V, evaluate the…

A: Given  v1 = 30sin(ωt) v2 = 30sin(ωt + 0.25π) v1 + v2 = vsin(ωt +β) RMS values of v1, v2, v1+v2 half…

Q: A resistor of 150 ohms is connected in series with an 0.8 H inductor, across a 230 V, 60 Hz supply.…

A: Given RL series network  With R = 150 ohm   L = 0.8 Henry Supply voltage 230 v, 60 Hz

Q: The voltage across a 100 mH coil is v = 100 sin 50t. Which of these expressions describes the…

A: Given data: vt=100sin50t   The expression for the current is given as, it=1L∫vtdt=1100…